Question about 2004 Subaru Baja
Need back tail to come off to replace the light bulb?
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: replace tail light legacy
In side the trunk behind the light you need to fix is a small access panel. Just open and replace bulb. Very simple and straight forward. Good luck and have a great day.
Posted on Feb 08, 2010
Tips for a great answer:
Aug 27, 2012 | 1998 Buick LeSabre
May 01, 2012 | 2003 Acura MDX
Dec 29, 2010 | 2000 Lexus RX 300
Dec 18, 2010 | 2000 Oldsmobile Silhouette
process for replacing tail light bulbs is the same in all models. If
you have a burnt-out tail light bulb, you may need to replace the
brake light, the reverse light or the turn signal. The procedure to
replace each of the bulbs is the same.
1. Open the Hummer's rear swing gate. This will expose the edge of the vehicle's tail light assembly. You'll see two small Phillips head screws that hold the tail light assembly in place. Put on your gloves.
Remove the two screws from the tail light assembly. Pull the tail
light out and inspect the back for two bulbs. The top bulb is the
brake light and turn signal. The bottom bulb is the reverse bulb.
Determine which bulb you need to replace.
the tail light into its cradle. Hold it with one hand and replace
the Phillips head screws with the other.
Dec 03, 2010 | 2008 Hummer H3
Check with your local auto parts store or look in your owner's manual to find the proper model number of the replacement tail light globe.
Turn the two latches counterclockwise to open them so the cover may be removed. In most cases you can turn the latches with your fingers; in some cases you may need a coin or a slot screwdriver to turn them. Remove the cover.
Press the tabs that allow you to remove the tray that holds the tail light globes. There are four tabs on most VW models. Each tab must be depressed to release the tray. Pull the tray out a few inches, as far as the wiring allows.
Press down slightly on the burned-out globe and turn it counterclockwise with your thumb and fingers. It should release easily and then pull straight out. Push the replacement bulb in and turn it clockwise until it locks in place.
Snap the tail light tray back in place. The tray should simply push back into place and the four tabs should "snap" into their locked position. Replace the door cover and turn the door locks clockwise. Test your bulb to see that it is working.
Nov 20, 2010 | 2004 Volkswagen Beetle
Nov 01, 2009 | 2001 Toyota Sequoia
Oct 27, 2009 | 1999 Buick Park Avenue
Dec 23, 2008 | 2004 Mitsubishi Outlander
11 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: