Question about Ford CMax

Open Question

Vibration blower motor increase flow

Loud and felt vibration when fan is turned above level 3

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: fan blower works but no air flow

THE DOORS IN THE HVAC UNIT BREAK ALL THE TIME.

Posted on Aug 14, 2008

  • 16 Answers

SOURCE: blower motor noise

the blower motor is like round cage and the only way to get to it is to take appart the dash. not the insterment cluster but the top and through the glove box is probably the only access. i doubt you will find a schematic just take lots of pictures while taking appart of what each screw looks like as it comes out. most the heater vents are in your way taking them out is not only screws but plastic barbs. just take every thing appart that is plastic and keep track of where it goes the cage you want is dead center of the dash. you dont need to take it out just get access to it. also what ever got there probably fell from one of the vents that blows onto the windshield so the top of dash removal may be easier if all you need is access to pull out some trash.

Posted on Jan 05, 2009

chuck943
  • 783 Answers

SOURCE: 2006 Ford Explorer XLT the Blower Fan only works on 4 and 3 Sp

Look under the dash on passenger side and just to the left of the blower motor housing you will see the 4WD control module.Remove the 2 screws holding the module and let it hang down and your resistors are behind this.Remove the 2 screws holding the resistors and remove.
Now I am assuming you have manual climate control and not electonic.

Posted on Feb 26, 2009

e-Guru
  • 3917 Answers

SOURCE: Blower motor or resistor?

Yes its the blower motor resistor.

More then likley theres some trash or something in it, or possibly the motor itself is on it's way out. There not that bad to pull out of that body car, just pull it out and see what you can see.

The blower motor is under the glove compartment

You can replace the resistor on your own. Please find a detailed diagram which would guide you to do it.

http://autorepair.about.com/library/images/bl629a-lib.htm

Thanks

Posted on Apr 09, 2009

  • 81 Answers

SOURCE: Blower motor or resistor?

I had a truck about the same year with the same problem, it was the wiring harness, but id check the resistor and the fan first before replacing anythings,

Posted on May 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My heater only works on high. Very annoying as it's loud.


Most likely a bad resisitor, follow the wires from the fan going to the blower motor resister and change it

Jan 31, 2016 | Cars & Trucks

1 Answer

I have a 2002 Grand Am SE, my heat works fine, temperature wise, but doesn't flow out of my vents very well. Whenever I turn the heat on I hear a loud humming/vibrating sound coming from my blower...


I had a very similar problem on a Buick recently. Like mine, your blower's fan blade assembly may have come loose from the motor shaft. There is a very small washer type clip that holds the fan blade part to the motor's shaft. Usually the whole blower assembly is pretty easy to get to and take off...usually. A lot of GM cars had the assembly accessed from the firewall behind the engine. You would need to pull the blower motor out and check the fan assembly.

Jan 21, 2014 | Cars & Trucks

1 Answer

Vibration in engine area felt in gas pedal


Almost sounds like maybe a motor mount issue.

Nov 30, 2013 | 2003 Ford Taurus

2 Answers

I will be please if you could suggest a solution in this case. My 1998 Corolla 160i GLE suddenly developed a noisy vibration in the fan unit. The airflow from the unit appears normal as the fan speed is...


This is a common problem. It is much more common in vehicles that do not move for several days at a time. It is usually caused by rodents getting into the blower housing and building nests.

The blower motor assembly must be removed to clean out the debris. Here are the instructions for your vehicle:

BLOWER MOTOR

Removal and Installation

Disconnect the negative battery cable. Remove right front door scuff plate. Remove kick panel. Remove lower dash trim panel. Unplug blower motor connector. Remove blower motor. To install, reverse removal procedure.

Mar 01, 2011 | 1998 Toyota Corolla

1 Answer

Loud blower fan 2006 jeep commander


Either the motor is defective or its rubbing against a loose motor panel or there may be somthing stuck in it. Regardless have it checked out.

May 24, 2010 | 2006 Jeep Commander

1 Answer

2006 dodge quad cab blower motor squeak


take out the glove box then on your right side you will see the blower motor housing. it has 3 chrome bolts unscrew those sometimes things get in there-the other day my blower motor was vibrating there was a napkin in there-any questions email me and i will give you my cell so we can talk if any questions thanks brad

Feb 17, 2010 | 2001 Dodge Ram 2500 Truck

1 Answer

A/C and heater raddle/vibration when fan control turned on


That vibration is caused by something lying in the fan. This causes an imbalance in the fan that gives off the vibration. You will have to remove the blower motor in order to get to the fan and clear the fan of whatever is stuck in the fan.

Oct 06, 2009 | 2004 Chevrolet TrailBlazer

2 Answers

Blower motor makes loud noise when on high


I have a 2004 dodge ram 1500 with the same problem, vibrating blow fan when on high, pulled the blower fan out and found a piece of the hinge from the recirculation door and felt the recirculation door sitting up on the vent of its hinge. Crappy engineering once again.

Feb 14, 2009 | 2004 Dodge Ram 2500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...