Question about Tata Indica

Open Question

Throttle position sensor

Indica v2 diesel after a engine wash check engine light glows on and off only whe car is running

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 217 Answers

SOURCE: check engine light on 2001 Ram 3500 5.9l diesel

need To know the codes and a reason why they did not replace the fuel pump and only the lift pump

Posted on Jan 17, 2009

Ad
localwonder
  • 6784 Answers

SOURCE: throttle Pedal Position Sensor Switch A

its just a sensor. you do not have to replace the entire throttle body.

Posted on Mar 16, 2009

  • 1 Answer

SOURCE: Car stumbles,hesitates,loses power on Hwy, randomly

Did you check earth connection of electric system?

Posted on May 10, 2009

warlock61
  • 659 Answers

SOURCE: 2000 Taurus. Will not idle. No check engine light.

check on the rear of the engine below the throttlebody area there is a vacuum line that collapses or splits and cause this

Posted on Jun 05, 2009

  • 1071 Answers

SOURCE: car won,t start sometimes & check engine light

before changing any more parts there are grounds on the engine that need cleaned one on the back of intake manifold then you have to remove battery tray clean up the ground there then clean where the tray bolts up as this aids in chassis grounding remove ground cable from bellhousing before you reassemble install star washers btween cable ends and where they bolt up this will dig into ground surface and cables making a better ground then remove turn signals in front there are two on right side and one on left side cleanup and star washer then there is the ground spots for the ecm inside removr kick panel on right side clean up and star washer if the starter doesnt work after this starter is probably bad but the other codes will probably clear out

Posted on Jul 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have tata indica v2 Ls 2012 Start the engine black smoke coming.what problem?


Do you have a check engine light on? What is the fuel pressure reading? Is this a diesel?

Jun 02, 2016 | Tata Cars & Trucks

1 Answer

I need blink diagnostic code 22 for my tata indica dls v2 bs2 diesel car model2007


How long after the Injection pump repair did this start happening? If not long ago, I'd go back to the repair man or ?Dealer?. Was the overhaul Manufacture recall? It's highly unusual for injection pump failure on a fairly recent Auto.

Mar 03, 2015 | Tata Indica Cars & Trucks

1 Answer

Throttle position sensor


see no check engine light. need to have throttle control module check or tps sensor but need diagnostic equipment to check it.dealership has to check it out.

Dec 26, 2013 | Hyundai Cars & Trucks

1 Answer

Ford F250 2002 7.3 Diesel won't start


check engine immobiliser and crank position sensor . Run fault codes and replace faulty units.

Apr 04, 2013 | Ford Cars & Trucks

1 Answer

Check engine light glowing always in tata indica car


The check engine light is because all check engine light codes are caused by components that affect emissions. It's not actually an engine problem, it's a problem with either your O2 sensor, MAF sensor, fuel/air ratio, pyrometer, or exhaust.

you can start with an OBDII code reader, which you can get for free at your local parts store. This will tell you what component is malfunctioning, and then you can decide if it's worth fixing or not. But rest assured, the oil leak has nothing to do with your check engine light.

Jan 11, 2013 | Tata Indica Cars & Trucks

2 Answers

P0222 and p0121 troubleshooting


FIRST AND FORMOST do not listen to any advice the totally unqualified parts guys hand out at Autozone or any other free code reader parts store, they want to sell you parts and that is all.

P0222 VOLKSWAGEN - Throttle Pedal Position Sensor/Switch 'B' Circuit Low
Possible causes- Throttle position sensor harness is open or shorted
- Throttle position sensor poor electrical connection
- Faulty Throttle position sensor
When is the code detected?An excessively low voltage from the Throttle Position Sensor (TPS) is sent to Engine Control Module (ECM).

P0121 VOLKSWAGEN - Throttle/Pedal Position Sensor/Switch 'A' Circuit Range/Performance
Possible causes- Faulty throttle position sensor
- Throttle position sensor harness is open or shorted
- Throttle position sensor circuit poor electrical connection
- Faulty Engine Control Module (ECM) When is the code detected?Malfunction is detected when an excessively low or high voltage from the sensor is sent to ECM.

Have the VW dealer complete the diagnosis on this.

Nov 05, 2012 | Cars & Trucks

1 Answer

Where is throttle position sensor in my tata indica dicor?


It is mounted on the throttle body and is actuated off the throttle shaft.

Sep 20, 2012 | 2007 Tata Indica Dicor

1 Answer

Can anyone tell me where to find the glowplug relay, it's a 7 prong relay, on a 2002 vw beetle 1.9 diesel no turbo ? allready been under the dash and checked all the relays, none of which are 7 prong,...


Above the Relay Panel is the Auxiliary Relay Panel. Has thirteen positions in it.
6 across the top, 7 across the bottom.

Across the bottom the Glow Plug Relay is the fourth one over from the left. It is Number 10.
(180)

Sep 17, 2009 | 2002 Volkswagen Beetle Turbo S

3 Answers

Why the preheating light sometimes is on on cold engine and sometimes off on warm


I'm going to assume you has the diesel version of the Sprinter.


Diesel is just like a good old COX airplane engine.


The engine need to heat up by glow plugs.

You need to turn the key to on position and let the glow plug relay to energize the glow plugs for 5-X numbers of seconds first.......it all depend on the temperature.

The temp. sensor on the engine block will take all the guess work out for you.

When the dash indicator goes out then your are ready to start.

This is the correct procedure to start an diesel engine.

===
Please disregard this post if you has a gasoline version of the Spiniter.

Jul 15, 2009 | 2006 Dodge Sprinter

1 Answer

95 f250 7.3 is throttle position sensor on the pedal


i have a f350 ps and it starts and idles but i have no throttle nothing happens when i push the pedal and the check engine light comes on

Feb 27, 2009 | 1995 Ford F250

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Tata Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

old marine
old marine

Level 3 Expert

1983 Answers

David Harrelson
David Harrelson

Level 3 Expert

5316 Answers

Are you a Tata Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...