Question about 2009 Volkswagen Passat 1.8

Open Question

Bulb replace signal turn wing mirror

How to replace wing mirror indicator bulb

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
shaggyrat
  • 1224 Answers

SOURCE: Mirror indicator

under the mirror there should be a 1 1/2 slot door under mirror that looks like a flat lid this will be flush with mirror moulding where it looks like a quarter can turn it
this is the light access panel the detachment screw is threw this panel to take off mirror then you can access the bulb

Posted on May 21, 2008

Ad
  • 5 Answers

SOURCE: Indicator on wing mirror

Have you tried taking off the cover to see if the indicator cover is part of the entire wing mirror cover. I think it might all be part of the same cover. The Haynes manual may be able to help more.
Sian

Posted on Oct 19, 2008

  • 84 Answers

SOURCE: VW indicator unit on wing mirror

Ok very carefully pull off the mirrior blade. The mirrior blade is clipped but EXTEMELY fragile and will break if forced. From there remove the 2 heated blade wires. The cover is also clipped as you will notice after that is removed. You have to pry with a plastic tip between the cover and hosing near the body of the car while pulling the clips in the housing you see to lift the cover straight up. Once this is done you'll need a t-10 torx screwdriver to remove the lower portion. These screws are when you're looking straight down. With this assembly off you can access the 2 other little screws holding the flasher to the bottom cover. Remove the wires and the little clip and there you go. Installation is reverse.

Posted on Nov 01, 2008

  • 1 Answer

SOURCE: wing mirror indicator not working

I changed mine a few years ago (2005 Sharan). Price of the LED part was ~£20 from the main dealer. Biggest problem was taking the mirror unit apart. I spent ages removing the mirror then seperating the parts. Later some ne'r-do-well knocked into the mirror on a bike, folding it towards the front of the car, and it all just came apart in such a way as to make changing the indicator easy!

Posted on May 27, 2009

  • 1986 Answers

SOURCE: how to remove and repalce vw golf wing mirror

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you can remove the bolts securing the mirror to the door.

Posted on Sep 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My ml 270 year 2001 wing mirror indicator got smashed but now I dont have front or rear indicators on the jeep, need to fix unfilled I can replace the complete wing morror with the indicator in it.


When mirror got smashed it may have shorted the wiring. Insure wiring is not shorted and tape loose ends. Then check fuse and you may restore other signals.

Dec 19, 2014 | Cars & Trucks

1 Answer

2004 gmc 2500 i have heated folding turn indicator side mirrors.turn indicator is not working on driver side.is it possible to repair ot do i need to replace?


I'd call a GMC dealer and ask for the parts department. I'd ask about the availability and price of the driver's mirror turn signal bulb. That might tell you if that bulb is replaceable. You could also ask that same delaership's service department about the labor cost to replace the bulb.
If the plastic cover below the mirror will not snap off, you would probably have to remove the mirror from the door and take it apart to replace the bulb. Depending on the friendliness of the GMC service or parts department , they might tell you what to do here.

Jan 18, 2013 | Cars & Trucks

1 Answer

Honda civic wing mirror indicator replacement


Do you mean the turn indicator located in the mirror assembly? There is no way to replace that other than to replace the entire mirror assembly. I would be checking the wiring harness to the door before replacing the mirror. There could be a broken wire in the umbilical that goes between the body and the door.

May 18, 2012 | 2005 Honda Civic

1 Answer

I am trying to replace aleft rear turn signal bulb on a 2005 lacrosse. I removed two wing nuts but cannot remove assmbly. Is there another wing nut holding it in. I cannot find it?


3 wing nuts. here is the info needed.

gmlogoflat.gif Service Information
bhome.gifbpublication.gifbnumsrchbutton.gifbnews.gifymkbutton.giffeedback.gifbhelp.gif
2005 Buick LaCrosse ' Allure, LaCrosse VIN W Service Manual ' Body ' Lighting Systems ' Repair Instructions ' Document ID: 1537542 Tail Lamp, Turn Signal Lamp, High Mount Stop Lamp, License Lamp, Backup Lamp Replacement - Rear
1537540.gif
tif.gif
Callout
Component Name
Notice: Refer to Fastener Notice in the Preface section.
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
Turn Signal/Stop Lamp Assembly Replacement - Rear 1
Nut, Turn Signal/Tail Lamp (Qty: 3)
Tip
Pull back rear compartment carpet to gain access to lamp.
Tighten
2 N·m (18 lb in)
2
Lamp, Turn Signal/Tail Lamp
Tip
Twist the bulb socket and pull inward to replace the bulb.
License Lamp Replacement 3
Screws, License Lamp (Qty: 2)
Tighten
2 N·m (18 lb in)
4
Lamp, License Lamp
Tip
Twist the bulb socket and pull inward to replace the bulb.

Jul 29, 2011 | Buick LaCrosse Cars & Trucks

1 Answer

How do i remove indicator bulb on wing mirror Sprinter 2008


It's been a while, you go through the glass.. the big glass.. grab it lightly
slide it up adn then over left.. the bottom glass.. slide it left and the up and right at the same time.. its a little touchy so be patient.. now i cant remember but i think you have to removed the motor.. then you can access the bulb behind it.. best of luck!!

Jan 11, 2010 | 2008 Mercedes-Benz Mercedes Benz Ml Class

1 Answer

MIRROR INDICATOR BULB


You cannot change the bulb - the indicator is a sealed unit - mine failed because water got into a crack.  VW will sell you the unit - you need to dismantle the wing mirror to fit it - took me about 20 mins.  Cost of the unit was about £17

Jan 04, 2009 | 2004 Volkswagen Passat

3 Answers

Indicator flashing 2 fast at off side all bulds illuminating


double check all bulbs are illuminationg (including the side repeaters / wing mirror repeaters) and check the fuses

Oct 13, 2008 | Land Rover Discovery Cars & Trucks

1 Answer

Mirror indicator


under the mirror there should be a 1 1/2 slot door under mirror that looks like a flat lid this will be flush with mirror moulding where it looks like a quarter can turn it
this is the light access panel the detachment screw is threw this panel to take off mirror then you can access the bulb

May 21, 2008 | 2004 Volkswagen Golf

Not finding what you are looking for?
2009 Volkswagen Passat 1.8 Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8548 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...