Question about Ford Laser

Open Question

Where does electric choke wire connect - Laser Ford Cars & Trucks

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

tripletauto
  • 1450 Answers

SOURCE: carb choke

yes ground and hot
youur hot wire needs to hook into ignition circuit so it is hot with key on

Posted on Sep 16, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

95 Chevrolet Silverado 5.7 v8, turns over but wont fire up.


Check the connection on the temperature sending unit/sensor on the engine. If it's disconnected the computer won't put it in cold start mode. If it's carbureted instead of EFI then the choke is not coming on. It's an electric actuated choke and the wire could have come off the blade/pin while driving the day before.

Nov 23, 2014 | 1995 Chevrolet K1500

1 Answer

My choke light stays on while i drive my 84 firebird trans am. Why does it do that and how can i make it go away?


the choke light will come on when the choke is on i assume its electric choke if the choke is on vehicle would run poorly flood out and stall if vehicle runs fine then its in the electrics of the choke switch or a bad wire to the choke that says its on even when its not i would start there first.

Nov 11, 2014 | 1984 Pontiac Firebird

1 Answer

Electric choke is staying closed does it work off a fuse


No, replace the choke and /or wiring. You have 12 volts to it, replace the choke.

Jan 02, 2014 | Jeep CJ7 Cars & Trucks

1 Answer

Have an 85 impala with the factory 305 V8. Need a new carb. Trying to see if this year model uses a computer ctrl carb? Or maybe even advice on how to tell if a carb is computer ctrl. Thanks


The carb for this year model is not computer controlled. At most it might have an electric choke. How will you know? It will have a wire or wires goting to the passenger side of the carb connected to the choke. Other than that, no, the carb is not electronic. Hope this helps.

Sep 16, 2011 | 1985 Chevrolet Impala

2 Answers

Got a new carborater with electric choke. how do i wire it?


The electric choke needs to be wired to a keyed power source.

Jul 11, 2011 | Chevrolet 1500 Cars & Trucks

1 Answer

84 ford f150 carburetor was rebuilt runs great when cold kicks and bucks when warm have to stomp on throttle to get to go


Sounds as if your choke is hanging up, or not opening at all. With the engine warm remove the air cleaner, there is a butterfly valve right inside the top of the carburetor If this is closed or mostly closed your choke needs to be adjusted. There are manual and electric chokes, yours should be an electric choke. First with engine cold and the key turned to on check for voltage at the choke wires. If you have voltage, then you might just need to adjust your choke. Electric chokes heat up an element inside the choke to tighten a spring and open the choke butterfly valve at the top of the carburetor. There should be between 4 and 5 screws that hold a ring around the choke housing on the side of the carburetor with the wires going to it. While holding the round choke housing in place loosen all of the screws on the retaining ring. If you can feel the choke housing wanting to spin turn it the opposite way that it wants to turn. Do this in stages until your choke butterfly valve is open with the key turned on, or the engine warm. Hope this helps if you have more questions just ask.

Jun 18, 2011 | Ford F-150 Cars & Trucks

1 Answer

1981 chevy pickup with a carburated 305 is hard starting, runs rough and when warmed up runs fine.......have replaced two carbs and the problem still exists......the carb im using now is a factory rebuilt...


Is the choke operating properly? You say the current carb has an electric choke, so I am assuming the original carb did not have an electric choke. If that's the case, have you wired the electric choke to a power supply?

Dec 19, 2010 | 1991 Chevrolet C1500

1 Answer

Engine runs rough and istrument Gages not working


It sounds like you need to inspect the wiring harness and look for broken wires and any wires that are hanging they may not be connected, the black exhaust is caused by a choke plate that is not opening on the carb the electric choke is not getting any voltage through the wire or the choke plate is out of adjustment it should be wide open after 5 minutes of running, check the fuses to be sure there is no blown fuses and check the wire that goes to the carb. to ensure it has 12 volts.

Dec 02, 2009 | 1985 Ford F150

1 Answer

I have a new alternator from the local auto parts. I have a wire coming off the carb that i don't know where to connect on the alt??????


I know of no wire from carb to alt only wire would be on a carb would be a electric choke ??? Is that what wire you have

Nov 12, 2009 | 1981 Ford F 100

1 Answer

Carb choke


yes ground and hot
youur hot wire needs to hook into ignition circuit so it is hot with key on

Sep 05, 2008 | 1966 Ford Mustang

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5467 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...