Question about Cars & Trucks

Open Question

How to turn service light out on nissan nv400

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why is airbag light flashing?


According to the Nissan service manual the procedure to Reset the Air Bag System Warning Light is as follows:
1. Turn ignition switch from OFF to ON.
2. Air Bag warning light is on for 7 seconds and turns off, turn the ignition switch OFF within 1 second after the light goes out.
3. After ignition switch is turned OFF, wait for more than 3 seconds.
4. Repeat steps 1 to 3 twice. (Perform 3 times in total.)
5. Turn Ignition switch ON.
6. The SRS light should be reset.
If the warning light can not be reset I'd suggest you contact your Nissan dealer for more information and a proper diagnostics check as there be a fault with the airbag system.
Alan

Jul 10, 2014 | Nissan XTrail Cars & Trucks

1 Answer

Nissan terstar dci 120 not starting flashing red stop light


no year, now that makes for a long story, huh?
what is a terstar?
you ment , INTERSTAR (so says google.)??????
a VAN.
ouch wiki is only in German....
2003-10 (transated)
Analogous to the revision of the Renault Master II / Opel Movano I also received the Interstar 2003 a revision of the body, engines and interior. Since then, an automated manual transmission (Interstar X70) was for the revised model now available and optional ESP (vehicle dynamics control) available. Also belonged from now a Brake Assist besides the previously installed anti-lock braking system standard on all models. Since then, the Interstar has been delivered as a minibus with up to 16 seats. 2010, the Interstar was replaced by the Nissan NV400.

NO START.
but to start any DIESEL engine,
IT MUST Crank first. does it?
if NOT, the the battery is dead, or bad. (or discharged)
DOes jumper cables used, (donor car) crank engine now?
if it DOES, crank, and robustly, then Id bet the glow plugs are bad.
if not glow plugs, lack of FUEL , ever change the filters per schedule>?

open glove box, extract the operators guide, I PROMISE
it tells you what the RED lamp means..
if lost , get one. from NISSAN , they are free.

Jul 04, 2014 | Cars & Trucks

2 Answers

How do i reset Engine Service Soon light


To reset the light you need a scan tool to clear the codes and this will reset the light.
If you goto any major parts store chain, they can do this for you for free.

Feb 09, 2010 | 2000 Nissan Maxima

1 Answer

Service engine soon light on my 2002 nissan xterra came on at about 100,000 miles. What could be the cause


If it's the indicator that literally says "service engine soon", and not the check-engine light, then you have no worries. That's programmed to come on at set intervals to remind you that routine service may be due soon (oil change, inspection, tire rotation, etc). It's not an indication of failure. Failures will be shown by the check-engine light. That one is nothing to worry about. Your owner's manual should have a procedure to turn it off.

Dec 16, 2009 | 2002 Nissan Xterra

1 Answer

2000 Nissan Xterra Service Engine soon indicator is always on


The knock sensor is not a huge deal to replace and will not turn on the light. It should be dont though.

The crankshaft sensor is located directly between the engine and transmission. It is dead center at the bottom.

May 17, 2009 | 2000 Nissan Xterra

1 Answer

The light "service engine soon" turn on in a nissan quest 2000 I read the manual but i'm not sure about if it is a big problem or not or if Is it a expensive problem ?


go here for quest help

http://autos.groups.yahoo.com/group/villagerquest/

The service engine light on is not a big deal. you just aren't meeting emissions right now.

Go to Autozone and have them run a free scan to get fault codes.

Just remember this - do not ever change the knock sensor even if it gives a fault code. It is in the middle of the engine and a waste of $600 for no improvement. It will never affect your engine performance, good or bad.

report back with code here or on Villager- Quest website I gave you.

Apr 23, 2009 | 2005 Nissan Quest

1 Answer

How do i reset service light on my 55 reg nissan primera


turn ignition to position 2 turn off radio push and hold info button whilst turning volume button on radio a new menu will appear on screen go into confirmation adjustments then go into service and reset

Feb 24, 2009 | 2003 Nissan Murano

2 Answers

Service light 2003 nissan primera


i know because i was told by a nissan engineer

turn the radio and ac off and with the ignition on but no engine running press the info button and spin the volume knob quite quickly this will get you into the diagnostics you can easily reset the service bar but dont be tempted to touch anything else or you could buggar up the settings in the computer.
regards paul

Sep 20, 2008 | 2003 Nissan Murano

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

533 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...