Question about 2006 Chrysler Pacifica

1 Answer

Starting clicking noise, starter does'nt engage.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 5,309 Answers

Sounds like bad battery; battery cable connection; or possibly bad starter solenoid.

Posted on Dec 01, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Lincoln making a clicking noise and won't start.


Your starter has what is known as a bendix drive. Upon start the drive actuates and pushes and holds the starter drive gear engaged with the flywheel. The drive must be bad and is not locking in engagement, but bouncing in and out causing the noise.
murf427

Aug 02, 2012 | 2002 Lincoln LS

1 Answer

Wont start


the clicking noise is usually 2 things, step on try jump starting car and if starts have battery tested as it is probably bad (free testing at most chain auto stores), the other usual problem is that the starter has gone bad, when whoever tried turning off car while driving might have put into start mode and burnt out the starter when it engaged at high speed.

Jun 09, 2012 | 1998 Ford Taurus

1 Answer

Van won't start. Only have clicking noise. Have a new battery and had the starter checked.


I know you had the starter tested but i still thing you have one of two things going on here, first acid damage to the Positive battery cable at the battery, if this is present you will notice the outside of the cable seems swelled yo under the red insulator, this causes low voltage, enough to click the starter solenoid but not enough to turn the starter motor. The other problem is burnt contact inside the starter solenoid itself, this problem will cause a clicking noise from the solenoid with no starter engagement, it very common. The starter solenoid is near the battery just follow the Positive cable from the battery to it, carefully jumper across it, does the starter engage? Here is a picture of the starter solenoid.

_1875.jpg

Aug 30, 2011 | 1993 Ford Econoline

1 Answer

I pulled the starter,alternator & battery they all checked good and ity still wont turn over what could it be?


If you can hear the starter click or engage when you try to start . Either the battery has low voltage or the engine has seized. You can check the engine by putting a wrench on the crank pulley bolt and try to turn by hand.Make sure to disconnect the battery first. If the engine turns it's good. If the starter is making a loud grinding noise but does'nt turn the engine. It's your flywheel/flexplate. Also make sure your battery connections are clean and tight for proper voltage delivery. I'm not sure if your car would have a fuse or power relay for the starter,but it might be worth checking out. If you do not hear a click from the starter when you turn the key it could be a short in the ignition switch.Not the key tumbler,the electrical switch is behind the ignition key tumbler. Hope this helps. Other than this you may need a repair manual to trace the wiring of the starting system and fusable links.

Jul 25, 2011 | 1994 Oldsmobile Cutlass Ciera

4 Answers

Cranks over for a couple seconds then starts clicking


Your battery is to weak, either charge battery or replace it.

May 04, 2011 | 2004 Ford F150

1 Answer

Will not start, have replaced battery, Starter, sounds like starter is not engaging.


Does the vehicle crank over? or does it make a grinding sound like the gear isn't contacting. If your hearing a grinding noise chances are the flex plate are missing teeth that the starter engages. Only way to replace that is to remove transmission. If your hearing a clicking noise check to make sure the battery connections are tight and the terminals are clean.

Mar 18, 2011 | Dodge Dakota Cars & Trucks

1 Answer

Van won't start


Either the starter is bad, or the starter solenoid.

May 31, 2009 | 1993 Ford Econoline

2 Answers

1994 lincoln wont start and does clicking noises


do you know ware the clicking noise is comming from? maybe relay? maybe bad sellinoid? the sellinoid is my guess.

Jan 02, 2009 | 1994 Lincoln Continental

1 Answer

My daughtrs 2001 Chevy s10 has an itermitant starting problem.


quick way to tell... next time it won't crank and just clicks... hit it gently with a hammer as you have someone attempt to start it... if all of a sudden it cranks.... it's the starter... replace it before it quites completely.

Robert

Dec 18, 2008 | 2001 Chevrolet S-10

Not finding what you are looking for?
2006 Chrysler Pacifica Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...