Just stopped running
Could be your electric fuel pump in gas tank. you can check it by turning the key on and take gas cap off and have someone to check to see if their is a noise saying the fuel pump is working. someone has to stand by where you put gas in your car and put their ear to the hole an listen when you turn key on, do not start the car just turn the key on and if they hear a noise like a pump running then your electric fuel pump is okay, but if don't hear a noise then your electric fuel pump is not working. it is hard to explain about the noise you will hear, but as long as they hear something when you turn key on and their ear is at the opening they will know what I am talking about. I've done 4 electric fuel pumps in gas tanks on different vehicles. good luck ! would like to know if you could hear the pump running when you turned the key on with the gas cap off.
SOURCE: removal of rear brake drum 2002 ford escape
make sure handbrake is off take wheel off hit the drum with a mallet not steel,as it will brake,hit on outter diametter face of drum, try and rotate as you twist off
SOURCE: Steps to remove radiator in 2002 Ford Escape?
http://www.autozone.com/autozone/repairinfo/common/repairInfoMain.jsp?leftNavPage=productsHowTo&partCode=0900c15280213faa&title=Radiator&targetPage=productInformation
Try this web site. It takes you to Auto Zone "How To" site. This one covers the 4 cylinder as you did not indicate the engine size.
Good luck and hope this helps.
SOURCE: ford escape 2002 firing order
V6 1-4-2-5-3-6 back bank pasenger side right to left cylinders 1 2 3
front bank passenger side right to left 4-5-6
4 cly 1-3-4-2
SOURCE: How do you replace the EGR on a 2002 ford escape?
To replace the the spark plugs on the V6, you'll need to remove the intake manifold. There is a coil on top of each plug (COP). Check this website for info:
http://www.escape-central.com/1forum/showthread.php?threadid=32550&referrerid=11756
The same link will also show the R&R of the EGR valve.
SOURCE: cruise control ford escape 2002. ford escape
If the cruise lamp comes on and the cruise does not set i would advise inspecting the cruise cable and make certain it is not broken, if ok the the servo has likely failed.
164 views
Usually answered in minutes!
×