Question about Toyota Celica
Have all the wires connected but only low beams turn on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2001 Toyota Celica GTS Clutch
i paid a friend to do it because it's a lot of work! if you haven't already treid to or got it done just know that when my friend did it; it took him like 8 hours (he'd never done one on a celica, but had done them on american cars) so if your not familiar with it... not a good idea to do alone. I watched him do most, but i'm not the best to talk to about it.(plus i have a 2000GT) Some of the parts that i can remember that he took out to get to the clutch were the front driver's side tire, the axel on the same side, ....some other parts in there....and ALSO parts on top...the intake also had to be taken out just to have enough room to do the job. parts are cheap...just ask for a clutch kit at auto zone or whatever. around $150. another random tid bit that might help is make sure to tighten the engine mounts really good afterwards or else it will jump around in there when you turn it on and cut it off. buy gear oil before you start as well because you will need to put some in after the new clutch is in. i will need to put the car on a real lift... you need a lot of space underneath and on top to work. and most likely two people. well hope some of this helped.
Posted on Sep 06, 2008
You should be able to access the buld holder from the rear of the headlight. It's a nylon bulb holder with a lock thing on it. You squeeze the lock part and turn it counterclock wise, and it should come out. Remove the old bulb and install the new one being careful not to touch the glass of the new bulb with bare fingers. The finger print you will leave can cause the bulb to prematurely die on you.
Posted on Jun 15, 2009
nothing try back flushing heater core, they clog up due to litle water preasure,you might want to flush cooling system if you already havent, hope this hleps.
Posted on Oct 06, 2009
Removal & Installation
NOTE When retracting the tensioner, turn it clockwise slowly in 3 sec. or more. Be sure not to apply force rapidly. After the tensioner is retracted all the way, do not apply force any more than necessary.
Posted on Feb 27, 2010
SOURCE: no low beams toyota tercel
This could be caused from bad dimer switch/ lost ground for high beams / or is it possible both of your high beams are bad? have you used a test light at the light to verify no power and good ground?
Posted on Apr 05, 2010
Testimonial: "good advice "
Tips for a great answer:
Mar 08, 2017 | 2000 Toyota Celica
Oct 23, 2015 | Toyota Cars & Trucks
Aug 04, 2013 | Cars & Trucks
Jan 21, 2013 | 1991 Toyota Celica
Apr 03, 2012 | 1993 Toyota Celica
Apr 10, 2011 | 1991 Lexus LS 400
Dec 11, 2010 | 2003 Toyota Celica
Sep 07, 2010 | 2001 Toyota Celica
13 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: