Question about 1998 Mercury Villager

1 Answer

Window relay my windows wouldn't roll up I replaced the gray relay and it worked long enough to get the windows up then it started clicking just like the old one did and now it wont work. could there be a problem with my fuse box?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,511 Answers

Sounds more like a short circuit and/or wiring condition. Check for insulation cracks, bare wires, loose wires, or poor connections. Look for water damage or rusting. Fuses are not the problem.

Posted on Apr 15, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: drivers power window went down

Had the same problem with mine, Removed the door panel and removed the window motor( two bolts holding it in), reconnected the window switch and ran /tested the motor. If it runs reinstall the motor and it should go up and down now. I had 2 windows jam down and this fixed both of them

Posted on Jul 23, 2008

richrobi
  • 15 Answers

SOURCE: power windows wont work

All things Capri are at //www.techcapri.com/
The manuals are there - check them out ...
Wiring diagrams are there. Probably fixed by now anyway.

Regards
Richrobi

Posted on Jan 07, 2009

KETOLACA
  • 4 Answers

SOURCE: power windows stopped working on '03 mountianeer

There may be a relay or perhaps a switch to replace in the panel that houses the window switches on the driver's door. That panel comes off by prying it up from around the switches. You will see all the wires and perhaps the relay to replace when you pull it away from the door itself. The switches should simply unplug and you can replace whatever looks burned out.

Posted on Jan 27, 2009

  • 14036 Answers

SOURCE: On a 2002 mercury sable the drivesrs rear window

check fuse and relay.if all is good .either switch bad or window electric motor is bad.

Posted on May 17, 2009

ZJLimited
  • 17970 Answers

SOURCE: I looked at the owners manual for the fuse box

Check in the Power Distribution box, this is located in the engine compartment, and contains high-current fuses that protect your vehicle.

For POWER WINDOWS, check the position 4, 30AMP (Maxi Fuse) (also Power Moonroof, Power Seat).

1b9e6fb.gif

This and other details can find in your 2000 Mcercury Mountaineer Owners Manual.

Hope this help (remember comment and rated this).

Posted on Apr 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Unable to start/ 2000 F250 V10


Try first unplugging battery cable for five minutes, this sometimes fix the problem. If it does not replace electric windows relay and electric windows fuse.

Jul 26, 2008 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

My passanger side rear window wont go back up. It will go down fine, I was able to get it back up by banging on the door a coupe times, but this time it wont go up at all. When I try to roll it up from the...


It sounds like the Power Window Motor is bad, if it was a wiring issue it would either work or not work, it wouldn't matter what position (up or down) the window was moving in. Replace the motor and it should work fine.

May 14, 2011 | 2004 Jeep Grand Cherokee

1 Answer

Windows wont roll up and down and hazard continues to click even when not on.


These are two separate issues.The most common cause of the clicking is the hazard switch located above the radio.Replacing this generally takes care of that issue occassionally it is a malfunction in the turn signal switch but most likely the hazard switch. If all windows are affected would check fuses first.If the windows roll down from the corresponding switches example rf allows rf to roll down. If not suspect an electrical issue such as fuse or relay.If they do roll down from the switches on the doors but not the drivers door possible a master switch issue.Drivers door contains a master switch that controls all windows.Do the windows work at all?

Jun 06, 2010 | 2000 Pontiac Grand Am GT

2 Answers

2000 Ford expedition window problem


Sounds like you need a window motor. Try hitting in center of door trim panel to see if you can get it to work if so replace motor.

Jul 05, 2009 | Ford Expedition Cars & Trucks

1 Answer

Honda Passport 2000 - none of the windows rolling


Sounds to me like you have a bad power window relay. Start by checking the power supply to the relay. Should the relay be bad replace and the window movement should be restored. If this doesn't take care of the problem you may need to replace the master switch in the driver door. The master switch allows all the other switches to do their job. If it malfunctions none of the windows will work. Hope this info helps, good luck!!!

May 11, 2009 | 2000 Honda Passport

1 Answer

Power window switch on 2008 Civic


Roll the window down. Now hold the button to roll it up and keep holding the button even after the window stops - you may hear a faint relay click noise. It is then reprogrammed. Sometimes I have to do it two or more times because I did not hold it long enough.

Mar 27, 2009 | 2008 Honda Civic

1 Answer

Windows wont go down or up


Check the switches for a clicking sound if you hear a clicking sound then the switches are fine. Does the driver side switch work for the windows? Check it for the click sound. Make sure it isnt a blown fuse. If you have replaced the fuse and you dont hear clicking sound it might be the switches and you can find them at a junk yard. If you have tried all these things and it still doesnt work you might need new window regulators and/or window motors or it might be a wiring problem.

Mar 08, 2009 | 1995 Pontiac Bonneville

2 Answers

2002 Nissan Xterra drivers power window wont roll down


Quite possibly yes...I would first check any relays and/or fuses just in case.  A few dollars for a fuse or relay is much cheeper than say $100.00 and a few hours of labor.  
You can purchase just the window motors from any major auto parts stores.  You can also purchase the window motor with the regulator.  The regulator is kind of like a rope and pulley system to lift the window up and down and the motor is attached to this assembly.  It is a little more expensive but I would change both.  I always change both just in case the regulator is bad and it isn't the motor.  You will have to remove the plastic interior of the door in order to change either the motor or the motor/regulator assembly.

Any questions, feel free to ask!

Feb 04, 2009 | 2002 Nissan Xterra

1 Answer

Hear clicking sound from Passenger window, but won't roll up or down


The clicking is the relay, that means the relay is ok, if it didn't click it would be defective, you most likely have a faulty power window motor.

Oct 21, 2008 | 1994 Nissan Pathfinder

Not finding what you are looking for?
1998 Mercury Villager Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

fordexpert

Level 3 Expert

5495 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...