Question about 1999 Dodge Intrepid

Open Question

Where is the low side ac port on a '99 intrepid?

Ac recharge

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 115 Answers

SOURCE: low side service port

Hi, All air-con systems have stardard size air-con pipe connections.1 small 1large so you can`t connect to the wrong side,the connector usually has a ring you have to pull back to then push onto the pipe connection that when connected keeps the connection tight ,to disconnect it is the reverse of fitting BE carefully and do not connect or disconnect with engine running wear goggles and gloves and do not breath any escaped gas,if your not confident give it to an expert !!.

Posted on Jul 10, 2009

  • 45 Answers

SOURCE: locating the High side and Low side AC gas ports

Easy. find the compressor. The larger hose attaching to the compressor is the "suction" side. This is where you install the refrigerant.

The smaller hose, whether rubber or metal as it travels to the passenger compartment, is the high pressure side.

After installing refrigerant and as the compressor is running, the larger hose will feel cool and the pressure side will feel hot.

Posted on Jul 29, 2009

  • 14036 Answers

SOURCE: To remove an alternator on a 1998-99 Intrepid, on drivers side

FIRST OF ALL.TURN OFF RADIO SO YOU WONT LOSE RADIO CODE.FOR THE 2.7L ENGINE.DISCONNECT NEGATIVE BATTERY CABLE.REMOVE THE LOWER PLASTIC SPLASH SHIELD.REMOVE TRANSMISSION COOLER AND POSITION IT ASIDE.REMOVE THE LOWER RADIATOR CROSSMEMBER SUPPORT.LOOSEN BUT DO NOT REMOVE.ADJUSTING T BOLT AND THE PIVOT BOLT.LOOSEN DRIVE BELT ADJUSTING BOLT.REMOVE OR DISCONNECT THE FOLLOWING.DRIVE BELT.REMOVE ALTERNATOR ELECTRICAL WIRES.REMOVE PIVOT BOLT CAREFUL NOT TO LOSE THE SPACER.REMOVE THE ALTERNATOR. NOW THE 3.2L AND 3.5L ENGINES REMOVE THE NEGATIVE BATTERY CABLE.THEN REMOVE THE LOWER MOUNTING BOLT AND PIVIT BOLT.REMOVE DRIVE BELTTENSION BOLT THEN DRIVE BELT.REMOVE BRACKET LOWER MOUNTING BOLT AND PIVOT BOLT.THEN REMOVE THE ALTERNATOR + ALTERNATOR FIELD CIRCUIT PLUG + ALTERNATOR B+ TERMINAL NUT AND WIRE.THEN PUT EVERYTHING BACK VISA VERSA.

Posted on Sep 18, 2009

Testimonial: "Thank you , as i am a senior i will try the recommendation, and let you know , but it appears very excellent help and i thank you for this Cheers Ste"

  • 1374 Answers

SOURCE: Where is the low side a/c recharging port on my 2000 dodge

Follow the line that comes from the firewall to the compressor. if nthe system is functional its the coldest of the two.

Posted on Mar 24, 2010

  • 39 Answers

SOURCE: 2007 Ram Truck: where is low side of ac to recharge in 2007 dodge ...

The Low Pressure Side connector will be smaller than the High Pressure Side connector so the refill hose will fit properly only on the Low Pressure Side.
Read more: How to Recharge Air Conditioning with Freon in a Dodge Ram | eHow.com http://www.ehow.com/how_4484569_recharge-air-conditioning-freon-dodge.html#ixzz0uLXJnwvE

Posted on Jul 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the low end ac port located?


ON THE LOW SIDE LINE. THE LARGER OF THE TWO LINES FROM THE COMPRESSOR IS THE LOW SIDE . IT IS THE LINE THAT ENTERS THE CABIN THROUGH THE FIREWALL

Apr 03, 2015 | AC Cars & Trucks

1 Answer

Picture of low side ac port on 2001 buick regal


You low pressure port is against the firewall just below the center of the cowl and is best accessed from the drivers side

Jun 30, 2012 | 2001 Buick Regal

2 Answers

Where,exactly, IS the low line port for recharging the AC on my 2003 Chevy Malibu? OR is the coupler that came with the recharge kit the wrong size? I've assumed that most AC units have a standard...


You found the high side port. The other line should have the low side and if it is not on there it might be at the AC evaporator which is a cylinder shape made of aluminum. The cap will have a L on it not a H. Do not force it on the high side.

Jun 12, 2011 | 2003 Chevrolet Malibu

1 Answer

How do I recharge my ac on my 99 Regal?


mcdevito75 here, The low side of you A/C is the side you charge, follow the silver lines commimg out the firewall, they hook up to the evaporator under the dash, look for the charge port on this line from the firewall. The recharge kit you buy will only fit this port, also the port may be covered with a brass ;looking cap un screw this cap and the valve looks like the tire valve. Also follow the chargeing instructions carefully.

Jun 19, 2010 | 1999 Buick Regal

1 Answer

Where is the low side a/c recharging port on my 2000 dodge intrepid?


Follow the line that comes from the firewall to the compressor. if nthe system is functional its the coldest of the two.

Mar 24, 2010 | 2000 Dodge Intrepid

1 Answer

A/c dont work and wires are good the compressor is as far as i know the clutch is good kind of tight tho. has been recharged. if some one can help that would be great thanks


ck ac relay and low side switch,,,,fuses ok? make sure there is nothing causing the ac not toif it where recharged it might have leaked back down come on,,,enough freon?

Jun 30, 2009 | 1996 Dodge Intrepid

1 Answer

2004 f250 super duty diesel where is low side recharge port ac


on fords ussualy at reciever drier,if not follow large ac line till you find the schrader port.

Jun 18, 2009 | Ford Contour Cars & Trucks

4 Answers

Where do I recharge ac at


there are 2 ports one for low pressure and one for high pressure. the low pressure is bigger in diameter and is usually close to the dryer and or fender and firewall. the high pressure is near the condensor on the fron of the vehicle. if there are caps for the ports low will be blue and high will be red. low side pressure should be 35-50 psi and high pressure should be 135-150 psi

May 11, 2009 | 1998 Dodge Dakota

1 Answer

Looking To Recharge The AC in a 2002 Pontiac Montana


the low port is between the engine and the radiator support and the high pressure port is by the cruise controll module

Jul 28, 2008 | 2002 Pontiac Montana

2 Answers

97 grand am low pressure port to recharge


The low pressure port is on the compressor on the bottom side. It should have a black cap on it.

Jul 24, 2008 | 1996 Pontiac Grand Am

Not finding what you are looking for?
1999 Dodge Intrepid Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...