Question about 2004 Cadillac Escalade Ext

1 Answer

I put in a conversion kit for air ride in my 2004 escalde. Now my abs light and traction control light willnot go off. My console reads service ride control and service stability. I don't even know

With the conversion kit for the air ride was suppose get rid of the service ride control message. Instead my brakes do not seem to be fuctioning properly and my abs and traction control light are on. Plus the console says "service ride control and Service stability"

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cadillac Master
  • 3,679 Answers

Take out the part you have fitted and have the OBD codes cleared ,then refit the part and see if the same happens

Posted on Apr 15, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: How do you reset service stability control & ABS

please send $100 to me and ill send you solution.. I was interested in your service until i heard some of your answers like requires expert must take to pro??? gee thanks for $15 advice

Posted on Sep 26, 2008

  • 1 Answer

SOURCE: abs light/traction control light

You can check out what the trouble code is by pushing and holding the information button and the up arrow (right side of instrument cluster above the radio) until all the instrument clusters light. Press the information button (last) to enter test mode. I've had an error C1234, meaning Left rear wheel sensor fault. I found the problem to be a corroded connector under the chasis just under the rear left door about 2 feet in. I had to by-pass (replace 1 wire due to corrosion at the connector.

Posted on Sep 15, 2009

  • 4340 Answers

SOURCE: how do i reset the service ride control message

You have to pull the error codes and repair what is indicated. The computer thinks something is wrong.

Posted on Oct 03, 2010

  • 1 Answer

SOURCE: service stability system light flashes

i hav the same problem wit my 98 deville wat did u do to fix it and wat was the cheapest way. Also did u have anyother problems wit ur car during the time u were driving it wit these lights on

Posted on Dec 29, 2010

  • 7353 Answers

SOURCE: my service ride control message

The most common problem is the rear auto level shocks leaking and/or the pump is bad. What happens ids one or both of the shock leak air, and the pump runs overtime to keep the truck level, and burns up the pump. everything is expensive.

Posted on Sep 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Changed rear air ride shocks on 2007 tahoe have abs,service stable track ,service traction control light on how can I reset them


Hi Ron,
Check to see if the speed sensor came off at either of the back wheels,That would turn on the ABS light,Which would then disable the traction control. The ABS will reset itself when it sees no problem.

Feb 06, 2014 | Chevrolet Cars & Trucks

1 Answer

Saturn vue 2004 intermittent abs and traction control comes on and after restarting shuts off?


Has this happened after you replaced the sensors for the abs. if so they have to be set at a gap close to the rotor sensor to read correctly. The other thing maybe if the new sensors area slightly different to the original ones the abs might be having trouble identifying them.
The last one maybe, could the new brake pads be causing flexing or pushing against something resulting in this intermittent problem.

Jun 13, 2012 | 2004 Saturn VUE

1 Answer

Dsc warning light on , bmw e46


Dynamic Stability Control....a derivitave of ABS / Traction control. The control unit that monitors the dynamics will most likely be sensing a difference in the measured wheel speeds. Possibly defective ABS sensor, wiring, ABS exciter ring, ABS module or steering angle sensor. Can also be triggered by wheel spin.
Have a diagnostic scan done ( cost £30 - £50 approx at good local garage) to read the fault codes first. If you get a fault code relating to "ABS module pressure sensor" the module requires replacement (common issue). Used to be a £1400 job, but repair kit now available from dealer for £180 ish and 2 hours to fit.

Apr 27, 2011 | 2004 BMW 3 Series

1 Answer

WHILE DRIVING DOWN THE ROAD THE ABS LIGHT CAME ON ALONG WITH THE TRACTION CONTROL LIGHT.WE BEGAN GETTING A SERVICE TRACTION CONTROL SYSTEM,FOLLOWED BY SERVICE STABILIZATION SYSTEM,FOLLOWED BY SERVICE ABS...


All are tied into the ABS system, traction as well as stabilization, This needs to be looked at by someone who can hook up a diagnostic tester to read the fault codes stored in the ABS system then perform the correct diagnostic procedures to isolate the problem

Jan 03, 2011 | Buick LaCrosse Cars & Trucks

1 Answer

Traction control not working


the most common problem i find with abs are faulty abs readings a bad bearing or external ring gear is chipped or cracked. it uses magnets to read a steel ring gear no thicker than a quarter inch so a slight disturbance can throw it off a visual inspection of the gears could shed light on your problem also traction control is part of your abs so thats why they came on together but you should know these are only typical it is possible you have a bad abs module hopefully not but still possible(though unlikely) hope this helps good luck

Feb 27, 2010 | 2004 Hyundai Santa Fe

5 Answers

I need new front struts, back air shocks, and a engine mount


If you are looking to replace the shocks on this Deville, you could be looking at a price that you may not like. With all the different components to the air ride system it is a good idea to go with a conversion kit that allows you to get away from the air all together by using a coil spring conversion. Strutmasters offers great kits at a great price with a lifetime warranty. I would rather pay half the price to fix my car and have the parts be warranted than buy expensive parts for the car not knowing its going to fix the problem and have no warranty with it. Check them out!

Nov 23, 2009 | 1995 Cadillac DeVille

1 Answer

Service traction system and ABS light


verify all tire pressures are correct this can affect abs traction control on your vehicle

May 31, 2009 | 2003 Chevrolet Impala

1 Answer

2004 lincoln ls 3.0 abs light and traction control light on? Started intermeitly but now stay on all the time.


have the car scanned with a scanner capable of reading ABS codes,get back to me with the code and we'll go from there. sounds like like one of the wheel sensors is bad. this controls both ABS and TRACTION CONTROL

May 15, 2009 | 2004 Lincoln LS

1 Answer

ABS TURN LIGHTS COME ON


need to get abs codes read. it will tell you what wheel to look at.
1.bad wheel bearing, sensor is part of bearing.
2.broken wires to sensor.
3.traction control part of abs

May 06, 2009 | 2004 Cadillac CTS

2 Answers

1997 Lincoln Continental Suspension Conversion Problem


It could be a wheel speed sensor that went out or something... When working with the wiring, something could have just gotten crossed or tapped to get these codes as well. The compressor shouldnt be running anymore if everything was tied off properly. Take it in somewhere and have the codes cleared and that should fix the problem hopefully. I know AutoZone has a reader, but I do not know if they have they ability to clear the codes.
I hope this helps.

Feb 22, 2009 | 1997 Lincoln Continental

Not finding what you are looking for?
Cars & Trucks Logo

371 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...