Question about Mercedes-Benz C-Class

1 Answer

Vito 1.9 manual second gear will not select

55 reg diesel man van .fisrt gear selection is fine second gear will not select unless you get upto a fast speed from standstil

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Mercedes-Benz Expert
  • 102 Answers

Sounds like 2nd gear synchro prob but check gear change cable adjustment first

Posted on May 06, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: my 1999 v6 camry is idling way to fast 1000rpm when hot

i would start with checking the spark plug cables in some cases if there is a bad wire it can cause a irratic or high idle being a 96 it is probably fuel injected so i would check the throttle cable and throttle body it may need some cleaning or a sensor may be off such as the idle control valve.

Posted on Dec 11, 2008

chain saw
  • 94 Answers

SOURCE: Gear Selection Audi A4

GEAR LINKAGE ADJUSTMENT IS UNDER GAITER PLUS REMOVE ASHTRAY .......BUT I WOULD CHECK FOR WORN OR DAMAGED GEAR LINKAGES ....CLUTCH FAULT WOULD BE THE NEXT THING

Posted on Feb 18, 2009

emjem74
  • 162 Answers

SOURCE: reversing lights not work

sounds like it could just be the reverse sensor located on the acctual gearbox under bonnet, you can tell which one it is as it is one of possible two.

Posted on Feb 25, 2009

solasknows
  • 199 Answers

SOURCE: Cant select reverse gear.

it should be the oil check level first most likely is that

Posted on Jun 19, 2009

  • 4088 Answers

SOURCE: vw lt35 sdi T.reg clutch

Suspect the clutch disc (which fits between the pressure plate and the flywheel) may have had it's center torn out which could prevent power from transferring into the transmission. You could also have a bad differential or a broken axle/CV-joint/universal joint. Another possibility is the drive from the clutch output down to the transmission could be damaged. In any case, it looks as if you are in for a major tear-down of the drive from the clutch onward. You can check for anything broken in either axle by setting the brake, blocking the wheels, and try to move the car with the engine while watching the stub axles coming from the differential case. If one of the axles turns, check outward for what doesn't. If neither turns, then the problem is inside the cases. Good luck!

Posted on Dec 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

X5 2001 4.4i - rough on low down acceleration at medium pedal press. idle at accelerate is fine, only under acceleration. At higher speeds is fine and no spluttering. When I put in drive, put foot on...


Sounds like lack of preventative maintenance

Spark Plugs every 3 years or 30 to 40,000 miles

You may have ignition coils failing

Clean MAF Sensor

Replace any O2 Sensors over 100,000 miles

Gas filter every 3 years

Sep 30, 2012 | 2001 BMW 5 Series

1 Answer

Hi ive got a citroen dispatch van 1.6 hdi 07 plateive had upto date first and second syncros done the a new gear box with linkages the all the syncros with gears and a new clutch but it has done it again...


you surprise me,these vehicles are bullet proof under normal circumstances and yes the syncros can wear out like any make of vehicle ,but this old grandad who passed his test in a viva with no syncro on first gear ,and passed his hgv on a vehicle with no syncros at all was taught to drive in a different era and rule one was neutral and handbrake on when stopped ,not holding it on a hill by slipping the clutch ,secondly to not put a vehicle in first gear whilst moving ,well it wouldnt go anyway ,double the clutch between gears so as to reduce the wear on the syncros and gears .not to ride the clutch between changing gears and also change down using double the clutch to save the brakes and stop vehicle slipping or skidding on a wet road ,not fly up to a roundabout ,slam on brakes force it into first gear at 30 mph then try to imitate evil kenival by going around on two wheels .This sort of driving will only damage the gearbox like syncros and clutches not lasting very long .

Jul 03, 2010 | Cars & Trucks

1 Answer

Have a t reg foed escort 55 diesel van fuse for stereo,lighter and clock keeps blowing as soon as replaced???? can anyone help???


common cause is, baby has stuffed a sweety wrapper in *** lighter causing short,try disconnecting each in turn until fuse dont blow...thimples.....

May 12, 2010 | 1998 Ford Escort

1 Answer

Volkswagen transporter 1.9 diesel van r reg starts no problem but has no acceleration. When out of gear and press accelerater no response for about omne min then very slowly builds up revs can drive but...


It seems like fuel pump gear is in wrong position. You need to remove drive belt and turn pump gear 360 degrees. Before you do that, you should know that there is 3 marks: first on flywheel, when 1 and 4 pistons is on top, second at the end of the camshaft and third in fuel pump gear (16 mm bolt). If you never do that before, I suggest you to go to mechanic, otherwise, you can do seriuos damage, like folded valves. 

Feb 02, 2010 | Volkswagen Camper Cars & Trucks

1 Answer

Hi, I have a 55 plate HDI 2LITRE expert van , today it just cut out when I put it into second gear , it starts fine put it into first move off and as soon as I go into second it cuts out, if I go from ist...


check around the selector area at the gearbox and where the shift lever sits to see if a harnes section or wire is getting trapped, chafed, or crushed, or if a plug is being pulled when 2nd is selected. The actual gears and box have NO way to cut the engine out so the moving external parts on the gearbox or shift must be causing an electrical cut out by interfering with nearby components.

Nov 05, 2009 | 2005 Peugeot 405

2 Answers

Our new Forester Diesel is ok But has no power at low revs when pulling away from standstil or moving slowly in 2nd and 3rd gears. Also main issue with this vehicle is the very slow and tractor like gear...


The forester diesel 6spd gear box is designed to replace the high low gear box so although starting off in second or third gear is possible .... puts a lot of strain on compents ie clutch/ gear box . very slow manuovering is much better carried out in 1st gear , as is moving from stationary . The engine torque is low dow the rev range high max idle is reached very quickly . The diesel engine characteristics are different to the petrol version ( I own 2.5 forester 2009 - 7.8l per km's @55000 km's). So you need to change your driving style to suit . I have test driven the 2.0l Diesel and sufficiently impressed to replace the 2009 version with the diesel .

Oct 13, 2009 | 2009 Subaru Forester

2 Answers

1992 Ford E350 7.3 Diesel Automatic Cube Van


I would look under the hood for a relay box and see if the relay needs to be replaced for the tail lights. As far as the acceleration i would try ramping up to passing speed the vehicle could have a governor limiting the top speed.

Apr 10, 2017 | Ford E-350 Cars & Trucks

1 Answer

1979 v8 auto ford ecconoline van wont change gear.


it sounds like it could be a governor problem the tailshaft housing will have to be removed to access it. the trans does not have to removed for this. there is a snap ring that holds the governor on the shaft check to see if the valve in the governor is sticking

Nov 18, 2008 | 1983 Ford Econoline

2 Answers

Van drops into 1st gear after 15 miles


What does the speedometer do when this happens? If it goes dead at the same time you need a Vehicle Speed Sensor which is mounted to the transmission. It tells the ECM what your speed is and without the input from the sensor, the computer assumes the van isn't going very fast and locks in 1st gear.

Jun 09, 2008 | 1998 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76132 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...