Question about 2005 Toyota Tazz 130

Open Question

Attempted theft car starts occasionally?

They attempted to steal my tazz, they disconnected my hooter. i reconnected it. but now when i try to turn the key my car only starts occasionally. sometimes it turns over. i can push start it, and i did check the alternator.could it be the immobiliser? or a loose connection? thanks puzzled

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
Mr BrokRench
  • 1623 Answers

SOURCE: intermittent non-starting caused by high pitched whirring when key turned in ignition

hello gwolfson...from your explanation it sounds like the starter motor is turning but the bendix is not engaged. This happens over time and is caused by normal wear. A click or clicking noise would point to the starter solenoid. Don't wait until you hear a grinding noise to replace it, thats hard on the ring gear and flywheel. A NEW starter is recommended if you plan on keeping the car. If not, you can go with a rebuilt starter for around 65 dollars. Of course make sure the battery terminals are clean and secure as well as the solenoid terminals.
Good luck...i hope this helps and will fixya up.

Posted on May 29, 2009

Ad
  • 1 Answer

SOURCE: 93 corolla 1.8 No start Blown ignition fuse

I had a prolem like this one time a while back. what i did was got the wiring diagram and checked everything that was running through that 30 amp fuse. on the one i was working on it ended up being an injector wire pinched under the valve cover and it didnt short out till the car was driven til it warmed up and expanded after the valve cover gasket was changed. hope this helps!

Posted on Jun 27, 2009

  • 538 Answers

SOURCE: car won't start after disconnecting battery to replace alternator

Are you sure you have the battery connected right, Red to + Black to -? The connections are tight? Are sure the new batery is good? I've seen that happen before where the battery is new but dead. Try jumping it from another car or put that battery in another car and see if it starts that car. If you have a voltmeter check the battery, it should be about 12.8 volts, then check while trying to start the car the voltage shoudn't drop below 10 volts.

Posted on Dec 31, 2009

flbergeron68
  • 541 Answers

SOURCE: Starter occasionally makes grinding noise and does

broken teeth on flywheel or starter pinion. take starter out and bench test it. if starter seems good and no teeth are missing/worn, inspect flywheel through starter whole

Posted on Jan 03, 2011

egadgetguy
  • 258 Answers

SOURCE: Hi, have a toyota avalon, tried starting the car , it won't start, but then the starter engaged and won't turn off evenwithout the key, disconnected the battery and it stopped , when the batte

It sounds like you have a bad actuator. This is attached to the starter and has a solonoid that pushes the starter motor gears into the engine gear. If the solonoid is faulty this may happen. Also check alignment of the same.

Posted on Mar 18, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2001 Bmw 740i and I just replaced the battery and now the car will turn over but won't start and the alarm randomly goes off


It thinks you are stealing it!

You have fallen foul of the anti-theft system!

Number one tip, maintain power when changing batteries with a couple of lengths of wire or jump leads.

Disconnect the battery for 2 hours. Put your key in the ignition, but not on. Reconnect the battery. The ECU will pair the chip in the key and the chip in the ignition lock. The ECU will then release power to the ignition system.

At present the ECU thinks you are trying to steal the car with a key that just happens to fit the lock. Clever stuff eh? Let me know how you get on by clicking COMMENT under my post.

It must be 2 hours to dissipate all power in the car held by electronics.
Posted on Jan 10, 2017

Jan 10, 2017 | BMW 740i Cars & Trucks

1 Answer

2001 740i battery replacement now the car will turn over but won't start just keeps turning over


You have fallen foul of the anti-theft system!

Number one tip, maintain power when changing batteries with a couple of lengths of wire or jump leads.

Disconnect the battery for 2 hours. Put your key in the ignition, but not on. Reconnect the battery. The ECU will pair the chip in the key and the chip in the ignition lock. The ECU will then release power to the ignition system.

At present the ECU thinks you are trying to steal the car with a key that just happens to fit the lock. Clever stuff eh? Let me know how you get on by clicking COMMENT under my post.

It must be 2 hours to dissipate all power in the car held by electronics.

Jan 10, 2017 | BMW 740i Cars & Trucks

1 Answer

Toyota Tazz 2003 model


My left steering arm of my 2003 Toyota tazz 1300 is loose inside the steering rack how do i fix it. Please can u help

Jan 07, 2014 | Toyota Tazz Cars & Trucks

1 Answer

Saab 95 2001


first check fuses..then try this..disconnect the battery negative with the key in the run position..all circuits will be dead....then shut the key off..reconnect the battery negative and then turn the key to the run position..DO NO ATTEMPT TO START..wait for 3-5 seconds or until dash indicators go out..this tells you that the factory presets are reprogrammed in the computer..then start the car..see if it works..

Dec 15, 2013 | Saab Cars & Trucks

1 Answer

1997 jeep grand cherokee won't start after alarm went off


I just had the same prblem. Reconnect your alarm first of all. You need to use your key bob "remote" to deactivate the alarm before starting. It is a feature "good one" i might add that should someone try to steal it the jeep will not start until u deactivate it w theke bob.

Jan 20, 2013 | 1997 Jeep Grand Cherokee

1 Answer

1994 toyata camry the alarm goes off and will not let me start the car.


factory security does not have toggle switches as far as I know so it is probably an aftermarket system. Try one of two things, turn the toggle switch the oposite direction with battery disconnected. Reconnect the battery and try again, the horn will beep a few times when you reconnect. try starting. If that doesn't work, disconnect the battery and turn the key to the on position and reconnect the battery and the horn will sound but will go off get in the car and try to start. It should start and run normally. shut car off, then you should be able to return the toggle switch to the previous position If this happens again turn the toggle switch to the opposite position with the batterry disconnected and turn the key switch to the on position and reconnect the battery and start when started go see a service that installs aftermarket systems and they should be able to reset it security system Hope this helps

Sep 19, 2012 | 1994 Toyota Camry

1 Answer

2005 saturn ion won't start, no clicking sound, all lights and accessories are working. what's wrong?


Mine (an '04 Ion sedan) has an issue with it's anti-theft computer programming, in where it will occasionally (maybe once every three weeks) not want to start. What is happening is that the computer is thinking that someone is attempting to steal the car (even though the factory key is being used), and disables the ignition for ten minutes. What I typically do is just turn the key all the way off, and sit until the radio clicks off (exactly 10 minutes), at which point I try again and it starts right up.
It's pretty annoying, but, to my knowledge, the only fix is to get a new computer, and while it's a pain in the ***, it's not worth $600+ to remedy.

This is also a relatively common issue in '98-'02 era Chevrolet Malibus, as well as some other GM cars of that time.

Jan 23, 2011 | 2005 Saturn ION

1 Answer

Alarm problem


The alarm system 'thinks' someone was trying to steal the car. You will have to reset it.
Try this;
remove key from ignition.
lock and open the car door with the key as normal.
or disconnect/wait a while/reconnect the battery
or you may have to contact the alarm manufacturer.

Apr 10, 2009 | 1990 Nissan Maxima

1 Answer

Changed ingition cylinder auxillery works but will not turn over


U will need to have the car taken in to the dealer so the security electronic module can be programmed to accept the code from the new key, there is no other way. Why is this the issue? think about this, if just installing a new lock cylinder was all it took to steal the car wouldn't that defeat the purpose of the system?

Feb 03, 2009 | 1999 Oldsmobile Intrigue

Not finding what you are looking for?
2005 Toyota Tazz 130 Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...