Question about 1994 Buick LeSabre

1 Answer

How is the way to change the dead a/c blower motor from my 2002 buick lesabre and to put a new one in???

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Buick Master
  • 426 Answers

You have to remove the cover thats underneath the glove box.Disconnect the plug from blower relay to motor.The blower motor has 9/32 or 7 mm screws holding it in remove thos and you will have to allow it to drop down and probably tilt it to remove it from under the dash. The cover under the dash has several small screws they should be 1/4 or 9/32 also and it will have a light coming through it be careful not to rip the light out. then reverse the process

Posted on Jun 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Air and heat won't work in my 2002 Buick lasabrea


You mean it won't blow air out the vents . Blower motor could be bad . To find the problem need to check for B+ voltage at blower motor . Buick LeSabre HVAC Blower Motor Troubleshooting

Jul 05, 2016 | Buick Cars & Trucks

1 Answer

How to remove and reinstall heater fan motor on a 2002 Buick LeSabre ?


remove the plastic panel underneath the passenger side dashboard area. This panel contains built-in retaining clips and simply pops off by hand.
remove three 8mm holding the blower motors assembly into the dashboard HVAC unit, use a 1/4-inch ratchet and an 8 mm socket. Remove the blower motor's electrical connector and discard the old blower motor. Install the new blower motor in the HVAC cavity and replace the 8 mm mounting nuts. Reconnect the blower motor's electrical connector and replace the plastic panel. Turn on the ignition and test the blower motor on all of the fan speed settings

Oct 25, 2014 | 2002 Buick LeSabre

1 Answer

In-operative Heater blower


These cars don't have a resistor per say. They are equipped with a blower module which is on the right end of the blower case behind the glove box. Much more expensive than the typical resistor.

Jan 17, 2013 | 2002 Buick LeSabre

1 Answer

I put a new battery in my car ('94 BUICK LESABRE) my heater display flashes and the heater doesnt heat up, worked fine before battery change.


I know in a lot of vehicles, the blower motor is attached to the firewall. If yours is beside the battery, they may be a chance something was unhooked or tore. It had to be something that was done when you changed the battery. I am not familiar with Buick Park Avenue's. Find the blower motor and check for loose wires. Check the fuse as well. I would say, from experience, it is a simple solution as a loose wire or blown fuse. It might have been perfect timing for the blower to go out. It does happen. Check the current on the blower with a voltage meter. If you need anything else, let me know. Thank you very much for choosing FixYa.

Feb 19, 2011 | 1994 Buick Park Avenue

1 Answer

94 Buick lesabre, new blower motor and new control module. Blower stays on even with key out of ignition. What could be the issue? Relay or control module?


The only way for the blower to still get power with the key off...means the resistor to the blower motor is bad...The resistor is located on the firewall...under the plastic shroud...this should fix your problem...nice Buick...:)

Jan 18, 2011 | 1994 Buick LeSabre

1 Answer

I have a 1994 Buick LeSabre Limited with a blower motor that will not run. When I hook the motor up directly to the battery it works, and when I put a voltmeter on the plug that goes into the blower motor...


The blower motor fuse,or relay is not working,check these,and the blower motor switch.The relay is activated by connecting ground to the relay.Best bet,is the blown fuse.

Dec 20, 2009 | 1994 Buick LeSabre

1 Answer

Matney 68told me how to replace my blower motor.


under the right side of the dash there is a plastic panel. remove that & you will see the blower motor

Jul 30, 2009 | 2002 Buick LeSabre

1 Answer

2000 BUICK LESABRE BLOWER MOTOR


The blower motor should be two wires. Backprobe and find out which is power and which is ground and bench test it. You could have a bad blower but it sounds more like a defective speed resister.

May 30, 2009 | 2000 Buick LeSabre

Not finding what you are looking for?
1994 Buick LeSabre Logo

198 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...