Question about 2005 Nissan Xterra

Open Question

Location of oil sending unit on 2007 nissan exterra

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 40 Answers

SOURCE: What size socket do I need to remove the Nissan oil sending unit?

I think 46
but not sure measur with ruler then buy a socket
other wise use a big adjesterble plyer hold sender unit nut tightly put a big screw drive through the plyer mouth and turn
good luck

Posted on May 08, 2010

johnjohn2
  • 5763 Answers

SOURCE: Oil capacity for 2001 Nissan exterra

There are two engine that can come with this truck. i will list both the 3.3 engine holds 3.5 qts and then the 2.4 engine hold 3.75 Qts. good day.

Posted on Jun 25, 2011

clifford224
  • 1975 Answers

SOURCE: 2000 Nissan exterra fuel relay location diagram?

See picture below. I hope this helps.


clifford224_504.jpg

Posted on Sep 15, 2011

alicantecoli
  • 22133 Answers

SOURCE: location of oil sending unit for 1986 nissan maxima

one of two places either on the head where the oil feed comes up for the cams or in the main oil gallery on the block but some vehicles do have them on the oil filter head ,its so long since i done one i just cannot remember and what i have worked on were all diesels

Posted on Feb 08, 2012

cansmo
  • 2431 Answers

SOURCE: picture/location of crankshaft position sensor 2003 nissan exterra

The location is in back of the engine on the top of the transmission3_17_2012_9_03_53_pm.jpg

Posted on Mar 17, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

A/t ecu fuse keep blowing out nissan exterra 2007 when start the car and car still running but kid of loose power when driving


Possible shorted transmission harness or transmission shift solenoids. Disconnect the big connector at the transmission under the car and see if the short stops and fuses don't go.

Oct 07, 2016 | 2003 Nissan Xterra

2 Answers

Where is the oil sending unit located on a 1999 nissan altima?


Not exactly sure about 1999 model but It's usually located next to the oil filter with a wire coming out of it or with in the oil drain area. It's about $12 to replace.
For vehicles with an indicator light, the sending unit is like a simple switch. When the engine is off, or the pressure is too low, the switch closes, and illuminates the lamp. Under pressure, the switch is open and the lamp goes out. The only difference in the above test, is with the wire disconnected, the light is out, and with the wire grounded, the light is on. How an Oil Sender works

Dec 07, 2014 | 1999 Nissan Altima

1 Answer

Oil sending unit


you mean oil level sensor? If yes it should in the sump

Apr 14, 2014 | 2007 Nissan Xterra SE

1 Answer

Where is the oil sending unit located on a 2007 Chevy Impala LT?


On the passenger side. Look at the wheel well and find the oil filter. The sending unit is just above it.

Apr 11, 2014 | 2007 Chevrolet Impala LS Sedan New Cars

1 Answer

Location of oil sending unit for 1986 nissan maxima


one of two places either on the head where the oil feed comes up for the cams or in the main oil gallery on the block but some vehicles do have them on the oil filter head ,its so long since i done one i just cannot remember and what i have worked on were all diesels

Feb 08, 2012 | 1986 Nissan Maxima

3 Answers

My 04 XTerra's oil light keeps coming on but there is oil in the car....not overheating, driving okay??? I am perplexed.


1st you need to do an oil pressure test. If it reads between 20psi-60psi, then it's Ok and you have a bad oil pressure switch. If it's below the above specs then you have an internal engine problem - IE: bad oil pump, bad bearing, etc...

Mar 12, 2011 | 2004 Nissan XTerra

1 Answer

Fuel sensor is not working properly. fuel gauge only works half the time.


NHTSA 10V075000
Feb 26,2010

Units Effected 80689

Fuel System, Gasoline Storage Aux,Tank

Nissan Is Recalling 2006 thru 2008 Frontier,Exterra and Pathfinder Vehicles
for deformed molded fuel tank,causing fuel gauge to show one quarter tank


Dealer will replace fuel sending unit with modified float arm

Recall to begin March 22,2010



www.nhtsa.gov

Nov 09, 2010 | 2007 Nissan Frontier SE Crew Cab

1 Answer

I took the exterra for oil change and after that it started to make a noise like little stones jumping in front in the hood inside.


If the noise is there all the time,I would suspect the timing chain

All Frontiers,Exterra and Pathfinders,2004 thru Nov 2009 have that problem

There is a new Borg Warner chain out, to fix that,of coarse any chain guide issues and oil activated tensioners,should be checked out or replaced

Nov 06, 2010 | 2004 Nissan XTerra

Not finding what you are looking for?
2005 Nissan Xterra Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...