Question about 1992 Toyota Camry V6

Open Question

John Deere 3235A fairway mower backs up fine but has no power going forward ,rebuilt right hydraulic motor.

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 8030 zts, where is the battery?


Normally with any of the mini excavators there under the seat or stored on the right side under the hydraulic tank cover, but as our company refuses to buy any of the JBC garbage thats only a guess at to where that podunk company puts there batterys all our mini's are Kubota up to the 080, anything bigger will be John Deere, Case or Komatsu.

Jul 24, 2017 | Cars & Trucks

1 Answer

Haudraulick problems on John Deere 3350


Try disconnecting a hose from the steer cylinder. Place the hose end in a 5 gal. bucket and see if you have flow from steer motor. turn steering wheel to the opposite direction of open hose fitting to check for steer cylinder piston leakage. Piston leakage will pressurize both directions of steer cylinder at the same time resulting in no steer. Be careful not to overflow your bucket. Reuse your oil if bucket is clean

May 21, 2017 | Cars & Trucks

1 Answer

Where is pto over temp relay or sensor located on x495 john deere diesel engine


I worked for Kubota for 10 years and I am not familiar with a PTO temp sensor, John Deere or otherwise. The PTO function has nothing to do with engine other than slight increase in coolant temp when the PTO is under a load. Check for correct Hydraulic oil level(dipstick or sight glass in transaxel) and make sure grass or trash is not packed around the hydraulic oil cooler in front of the radiator. Remove the screen and use compressed air to clean it often. Change hydraulic oil filters every 100 hours

May 21, 2017 | Cars & Trucks

1 Answer

John deere 1025 snow blade does not turn right or left


Could be the hydraulic block. Solenoid is bad. Could be the controller itself(PC board). could be bad wiring or motors. Depends on years. These are search and fix problems. It really has to be in my hands to fix. Most fixes are from corrosion. Meaning ,loosen a nut or bolt, retighten. Unplug and plug back in. If you see white to greenish color on wires, most likely the need replaced.

Jan 02, 2017 | Cars & Trucks

1 Answer

1972 jcb backhoe not moving backwards or forwards


Sorry no info on any model this old.

May 09, 2016 | Cars & Trucks

1 Answer

Hi. My bobcat skidsteer 641 has got hydraulic issues. We have just changed the oil cooler as the old one was wrecked, filled the hydro tank full of oil and ran machine for 20mins lifting the rams up and...


Did it run out of oil? if you ran the drive motors very long with no oil they are destroyed. Make sure the hyd. oil is still full. Usually the cylinders will act up first when oil is low. Try loosening the lines on drive motors to make sure there is no air in system, like an air locked injector.

Feb 20, 2015 | Cars & Trucks

1 Answer

The right side hydraulic drive motor on my husqvana cz 4817 zero turn mower is hesitating and making a groaning sound like a power steering pump sounds when it's low on fluid. Can I add hydraulic fluid to...


there should be a single reservoir for the main drive motor that supplies fluid under pressure to the drive motors at the wheels . Check that level and if ok then the problem will be in that drive motor and it may need repairs.

Aug 06, 2014 | Cars & Trucks

1 Answer

Where can i get a hydraulic tank


Hi I'm Peter, You can purchase a hydraulic tank many places the problem is what is it for . Is it a replacement tank due to your original being damaged or is it a project you are doing? Is there a leak in the tank? Tanks can be welded a LOT cheaper than buying a new one. With a little more detailed information I can direct you to where you need to go. Are you putting Hydraulics on your vehicle to make it jump or are you replacing the hydraulic tank on a John Deere 310D back hoe? See what I mean . I 'll wait to hear so we can get the correct size or part for your needs.

Apr 23, 2014 | Cars & Trucks

1 Answer

How do you time the injector pump


air pressure in the tank , i kind of had the same problem, come to find out it was pressure . i put a air hose and put pressure in my self ,and it done the job,a friend of mine from the army taught me that.

Oct 22, 2009 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
1992 Toyota Camry V6 Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...