Question about 2002 Chevrolet Tracker

Open Question

2002 chevy tracker low brake pedal

How to adjust rear brakes for a better brake pedal. this model has two adjusters

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Spongy brakes 1996 Chevy C1500

You can adjust the shoes outward on the rear by removing the wheels and drums, then above the axle but below the wheel cylinder you will see an arm that is horizontal, pushing both of the shoes outwards. There should be an adjustment nut that you can turn to extend the arm to push the shoes out.

Posted on Jun 01, 2009

Ad
  • 13 Answers

SOURCE: Need 2002 Chevy Tracker rear brake diagram on how

install star wheel toward the self adjuster arm

Posted on Jan 22, 2010

  • 2 Answers

SOURCE: How do you adjust the parking brake on a 2002 Chevy Blazer

This is not a hard answer but I couldn't find it anywhere either so I figured it out.
On the drivers side of the vehicle between the door and the rear wheel, just under the vehicle (outside of the frame) you will see the cable. Locate the nut (it's on a lolong screw-the front of the screw is facing the front of the vehicle) About 6 inches toward the read of that screw attach a vise grip. Then rotate the nut with a 12mm box wrench and shorten the cable. It takes a lot of turns so after every 10 or so check the parking brake pedal. If you are going in the right direction it should stop further fromn the floor each time. The manual says adjust to the point the pedal travels 1/2 way to the floor.Tip- Lube the nut and screw before starting. The nut can be rusted on and may snap if you try too hard. Mine was nice and easy to turn and now the pedal stops 1/2 way to the floor.

Posted on Sep 28, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Brake adjuster spring keeps slipping off!


Hi Joe,it could be your e-brake cable that is connected to the back brake shoe.

May 07, 2013 | 2002 Chevrolet Tracker

1 Answer

My brake pedal went to the floor, brought it in...They told me it was the Master Cylinder. They changed it and put in a brand new master cylinder but it still seems like the brake pedal goes further t


The extra brake travel can be;
1. air still in the brake lines and need bleeding
2. if there are brake drums on the rear they may be out of adjustment
3. if there are warped brake disc or caliper problems that will add to the brake travel

Dec 08, 2012 | 2002 Chevrolet Tracker

2 Answers

How do you adjust the brake peddle for more peddle


Is the problem your brake pedal is to low There is an adjustment for the brake light switch at the top of the pedal that could affect pedal hight slightly But if down a 1/2 inch or so i would suspect some kind of a problem with the brake system it self how well do the brakes stop the vehicleand have you noticed more of a drop in the pedal over time?

Nov 21, 2010 | 2000 Chevrolet Lumina

2 Answers

Brake pedal goes to the floor , replaced master cyclinder , replaced front pads , adjusted rear brakes , bleeded all the lines , still the same .


you need to check and see if these have a brake pedal adjustment on them i think they do where you control pedal can up/down for comfort of the driver go to autozone they can tell you for sure

Sep 24, 2010 | 2002 Chevrolet Tracker

2 Answers

Low brake pedal on honda accord lx 96


You need to check the brake fluid if it is low it will take air in the system,you need to take that air lock in order to get a better brake.

Feb 02, 2010 | 1996 Honda Accord

1 Answer

How do i adjust the hand brake on my 2002 honda civic after replacing the rear drum brakes?


Do not adjust the handbrake, it is not necessary. You can adjust the new brake shoes for a better brake pedal and this will also take care of the hand brake. This will have to be done with wheels off and lugs reinstalled to keep the brake drums in place. Sometimes the adjuster is difficult to reach and do not over tighten. When the rear brakes are properly adjusted you should have 3 to 4 clicks on the handbrake.

May 03, 2009 | Honda Civic Cars & Trucks

2 Answers

Disc Brake Emergency brake adjustment on 04' Chev Express Van


Continually push the brake pedal to set the brakes. (With park brake off). Brakes are self adjusting and will adjust to correct position.

Mar 29, 2009 | 2004 Chevrolet Express

1 Answer

Cabrio 1997 brake shoes (rear) adjustment


There should be a rubber insert in the back of the wheel assembely,take it out and you can adjust the brake tighter or looser by turning the adjusting wheel

Jan 15, 2009 | 2002 Volkswagen Cabrio

Not finding what you are looking for?
2002 Chevrolet Tracker Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...