Question about 2004 Ford Explorer

1 Answer


Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 34 Answers

I reset the computer on my '91 Lexus LS 400, the garage wanted 580.00 to do it, and all I did was disconnect both battery posts and hooked them up together with electrical tape..

Posted on May 01, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How can i deactivate my anitheft system on my 02 nissan maxima with only a key

A lock smith can make you a key that will work you do not need to deactivate it unless you are a car theif usually....

Jan 11, 2016 | Nissan Cars & Trucks

1 Answer

1979 coup deville won't shift through drive gears

Check the control module on the back of the transmission make sure you have vacum on the line and that it is not leaking fluid.
Question have you tried changing the gears manualy?

Apr 14, 2014 | 1998 Ford F250 SuperCab

1 Answer

What is the function of the transmission control solenoid

There are a few solenoids in the Transmission
TCC = Controls Lock-Up of the Torque Converter
1-2 Solenoid Gears
3-4 Solenoid Gears

Basically what they ALL DO IS ... control certain aspects of the operation of the Transmission

Apr 04, 2013 | Dodge Ram 1500 Cars & Trucks

1 Answer

Nissan Liberty 2004 Automaticac not changing all the gears

You must have the systms control module scanned for fault codes, this is an electronic problem.

Jun 14, 2012 | Cars & Trucks

1 Answer

Shifting into drive car turn off

hum...thats another new one????? I would disconnect battery ....wait 5 minutes...reconnect...wait 5... then if it does as it should....replace transmission control mod....if not ....there are 6 sensors and 2 silinoids....they only cost about 150.00 EACH.....oh...this will also cause your radio to lock in anti-theif mode so you will need model number and ser.number to get the code from 1-800 honda...sorry...thats all i can advise except to make sure your fluid is filled and does not look like a bad cup of coffee,,,,,good luck!

Nov 29, 2011 | Honda Accord Cars & Trucks

1 Answer

1993 ford escort wagon with automatic transmission, it will not shift into the two higher gears it only has first gear.


There are several things to check.

1) Check transmission fluid level.
2) Make sure that transmission is not in limp mode. That will restrict use of transmission to low gears. Go to the nearest car dealer and do a code scanning.If there are codes stored troubleshoot the codes.
3) Check if brake lights are working. Check brakes switch. The transmission shift lock may be on.
4) Check the TPS. The throttle position sensor is located on the throttle body The sensor detects the opening of the throttle, its output is used by the transmission control module to determine when to shift gears. The TPS is basically a variable resistor mounted on the throttle body. The TPS is tested by reading volts while operating the pedal. Making sure that voltage is in range and that there are no gaps or spikes in voltage changing while the pedal gets pressed slowly and smoothly.
5) Test the transmission switch solenoids. The higher gears solenoids may be defective. The solenoids are part of a pack located on the valve body in the transmission. The solenoids are tested reading Ohms at their terminal.
6) If you do not find anything else check wiring to transmission control module located under the dash. Make sure you did a code scanning.
7) Look for mechanical problems (clutch, valve, gears) inside the transmission.

On automatic transmission problems see also: My car does not shift..




Sep 07, 2011 | Ford Escort Cars & Trucks

1 Answer

Location of code number on ignition switch theif lock?

There is no code exactly , they have different resistance values being sent to the pcm . What is the problem ?

Jul 28, 2010 | 2002 Pontiac Sunfire

2 Answers

Anti theif light is blinking fast & it wouldn t

OOPS dealer only ,Try opening and closing door lock three times drivers side 10 sec interval between clicks then try starting if no go then dealer only

Mar 14, 2009 | 2000 Ford Windstar

1 Answer

Transmission fluid is coming back up thru dipstick on my 2002 tb

i have a micromax x211 mobile & iwant to change the mobile lock code but i cant *** it

Feb 19, 2009 | 2002 Chevrolet TrailBlazer

1 Answer

My '01 Mustang V6 revs high when in neutral/when changing gears.

sounds more like the IAC, Idle air control valve.. they can be cleaned with carb and choke cleaner gently...

Nov 17, 2008 | 2001 Ford Mustang

Not finding what you are looking for?
2004 Ford Explorer Logo

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers


Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides