Question about 2010 Chrysler Sebring

1 Answer

Electronic throttle control

Would not start, noticed the etc light came on. I jump started it and it started drove home let it warm up about 30 minutes turned off restarted it back up. about hour later would not start and only the radio comes on now.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,746 Answers

Hi, Sounds like a bad connection on starter and/or battery.
Could also be a bad soleniod on starter. Good luck.

Posted on Apr 14, 2014


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 34 Answers

SOURCE: Started car fine and drove home. Going back to

sounds like a starter

Posted on Jul 10, 2009

  • 11 Answers

SOURCE: 2009 town and country van. MIL is on and the van

U need to get somone with diagnostics to read DTC"S

Posted on Feb 15, 2010

  • 341 Answers

SOURCE: wont start without jump

have your charging system check...I bet it's the alternator again. A loose connection can damage the built-in IC of the alternator and will often time lead to alternator parts failure. Check for corroded wires leading to the battery or alternator. You can actually run a heavy guage wire from the positive terminal of the battery to the main terminal of the alternator for a temporary solution.

Posted on Aug 10, 2009

  • 145 Answers

SOURCE: first the etc light came on and then the mil light

Have you checked to see if the gas cap is on tight. New cars have a pressurized gas tank. It will set a light if it doesn't seal good.

Posted on May 17, 2010

  • 20 Answers

SOURCE: 2007 chrysler 300 car won't start OBD light on.

Sounds like an electrical issue. You'll want to take it in.

Posted on Nov 04, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What is causing the battery to drain?

Most likely a bad alternator..batt isnt gittn chargd. The diode is bad causing the alt to suck juice from batt. Also the main wire from battery to back of alternator I wud test first for wear. A bad one impedes chargn

Dec 04, 2015 | 1989 Eagle Summit

2 Answers

While starting vehicle ETC warning display vehicle not throttle

This is a warning that something needs to be checked. This happens a lot when a vehicle is jumped with a dead battery. You may have to take to dealer and have ETC reprogramed.
Throttle Control Warning Light More and more vehicles are doing away with the mechanical throttle cable between the driver's foot and the engine throttle body, replacing it with a "drive-by-wire" system. In this system, a throttle pedal sensor sends data to an electronic throttle control computer, which evaluates and relays the throttle request to a specialized electronic throttle motor on the engine throttle body.
The throttle motor opens or closes the actual throttle blade, which increases or decreases the power output of the engine. The throttle control warning light illuminates when a problem is detected in the electronic throttle system.

Jan 04, 2015 | Cars & Trucks

1 Answer

Throttle position sensor problems

reduced engine power has to do with the electronic throttle control or drive by wire . All electronic wires under the dash on the gas pedal , electric motor on the throttle body . DTC'S - diagnostic trouble codes stored in the computer . Take it to the dealer .

Mar 04, 2017 | 2002 Chevrolet TrailBlazer

1 Answer

What does it mean when code p1516 shows up on a06 chevy impala

It means your Throttle Actuator Control Module senses a problem with your Throttle Actuator Position performance. Here is a link to help you out...
P1516 Chevrolet Throttle Actuator Control Module Throttle Actuator...

May 24, 2017 | 2006 Chevrolet Impala

1 Answer

2007 chrysler 300 car won't start OBD light on.

Sounds like an electrical issue. You'll want to take it in.

Nov 04, 2012 | 2006 Chrysler 300

1 Answer

Jeep Compass turns over, won't start

check for power at the fuel pump if no power check relay's fuses ect If you have power at the pump then most likely bad fuel pump.And yes they do quit just like that

Jun 07, 2012 | Jeep Compass Cars & Trucks

1 Answer

Bad battery symptoms

These are not a battery related issue, if it were the car would not have restarted. You should have the systems electronic control module scanned for fault code, this may explain the stall, remember this engine is likely to be fully electronically controlled, fuel ignition system all of it. It would aid if you gave the model and make and year of the car or truck.

Jan 25, 2012 | Cars & Trucks

Not finding what you are looking for?
2010 Chrysler Sebring Logo

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides