Question about Cars & Trucks

1 Answer

Sticky gas when changed fuel filter - Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 191 Answers
Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Boggs at 2200 rpm or 1/2 throttle


Have you ever had maintenance performed on the carburetor? Just sitting still full of gas will cause gummy, sticky accumulations on all of the carburetor parts. A sticky float seems the most likely glitch causing your problem. Have the carb removed, cleaned & inspected top to bottom. If the truck doesn't use a carb, let me know.

Dec 19, 2013 | 1997 Chevrolet Tahoe

2 Answers

I have a 1995 Jimmy and I have gas in the oil


I take it you're doing an oil change and made this discovery? Some gas is normal, especially after winter months (high idle/choke) Could be sticky injectors - run a good fuel system cleaner through it, clean MAF and oil change/filter and check after about 2-300 miles. If there's alot of fuel, then you might consider changing injectors

Mar 21, 2011 | 1995 GMC Jimmy

2 Answers

My 2006 Colorado has intermittent starting problems. It will just crank and crank as if it were out of gas or electrical problems. Let it sit for 10 minutes it starts right up as if nothings wrong, and...


You can check Edmunds.com for possible recalls. I suspect bad or sticky oil pressure switch. Reason; Oil pressure switch is also a safety that controls your fuel pump. When oil pressure drops like in an accident or rollover, it cuts electric fuel pump off. Have you had it into a dealer for diagnosis??? Another note: when was last "healthy" tune up? Plugs, wires, All fluids & filters including fuel filter? You didn't mention mileage.

Mar 03, 2011 | 2006 Chevrolet Colorado

1 Answer

Where is the fuel filter located


THE FUEL FILTER IS LOCATED UNDER THE REAR SEAT CUSION. PRY THE FUEL PUMP COVER UP. IT IS FASTENED WITH STICKY SEALENT. THE FILTER IS IN PLAIN SITE TO THE RIGHT OF THE PUMP. NO TOOLS ARE NEEDED TO CHANGE THE FILTER. UNPLUG ONE WIRE CLIP AND THE INLET AND OUTLET FUEL LINES.

Jan 23, 2011 | 2002 Hyundai Accent

1 Answer

I'm trying to change my fuel filter on a 1995 toyota tacoma SR5. It's a V6 3.4L. I have located the fuel filter and have a the part. I am having extreme difficulties removing the old fuel filter. One of...


Try soaking it down with WD-40 and letting it sit for a bit. Usually you can heat up a sticky screw/bolt and get it to break, but since youre next to the gas tank, its not recommended.

Jan 05, 2011 | 1995 Toyota Tacoma

4 Answers

I have a 2000 chevy s 10 with 152,000 miles on it what does a tune up consist of


I would change the spark plugs, spark plug wires, distributor cap and rotor, fuel filter, check and change air filter if dirty, check timing, check and top off all fluids, check or change transmission fluid, check brake pads/.shoes and drums/rotors for wear and check tire pressure, check the condition of all belts and hoses and replace as needed, check condition of radiator antifreeze and top off or replace as needed.

Jun 10, 2010 | 2000 Chevrolet S-10

1 Answer

Wont run


sticky choke maybe, try carb cleaner, check the air-cleaner filter,depending on were you live, maybe some dry gas.from the symtom's sounds like it's chocking out,those are the easy cheap thing's first, now check the fuel filter, then the fue pump, prividing your getting good spark to fire up the fuel,good luck

Dec 21, 2009 | 1989 Jeep Comanche

1 Answer

DUAL GAS TANKS: FORD ECON 150 1988 FAMILY VAN


The actual switching of tanks is performed by a solenoid operated valve that is controlled by the toggle switch. The valve or it's solenoid could be getting sticky and not switching over quickly. The switch should also change wire connections to the new tank fuel-level sensor. It's possible that the fuel pump is getting tired and has a problem picking up fuel from the new tank. I assume that the vehicle is using the stock engine-mounted fuel pump.

Sep 07, 2009 | 1998 Dodge Dakota

1 Answer

1999 Chevy Silverado 1500 hard to start


i had the the same problem. did a fuel pressure check every thing was fine, except for a few sticky injectors. so i suggest get that checked befor doing anything else.

Jan 02, 2009 | 1999 Chevrolet Silverado 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...