Question about 1998 Plymouth Voyager

2 Answers

Blinking panel lights

How do you fix the blinking panel lights after you replace your battery?

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 72 Answers

To Calibrate , start and warm engine to normal operating temp. with engine idling turn blower switch to high, turn mode switch to panel, open all outlets, move temp lever to full cold.
press and hold rear wash and rear wiper buttons simultaneously for 5 seconds (untill all leds illuminate.) all leds should light up for 5 seconds, rear wiper and intermittent rear wiper button leds will flash alternatly during calibration... after 60 seconds if only rear wiper button led is flashing, cal. is complete

Posted on Jun 18, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

  • Contributor
  • 4 Answers

Led Panel Light- LED Panel Light designed by LED Lighting has features like dimmable, light weight, energy efficient, maintenance free, etc.
For More Info: http://www.ledlighting.com.au/led-panel-light

Posted on Jan 05, 2016

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Anti theft light blinking


sounds like that battery has been polarized and what i mean by that it may have been hooked up in reverse screwing up the comp electrical system , take it back to the ones who installed the battery , or the battery is defective ive seen this problem before .

Mar 21, 2014 | 2006 Chrysler Town & Country

1 Answer

The light on the control panel for air and heater blinck on and off all the time .


there is a sequence to turning of the blinking lights on the control panel. you must have replaced the battery or jump started your vehicle for the lights to be blinking.i used to know how to correct this but i can`t remember at this time,if you know a tech then he can look up the procedure on the shop info computer or he can talk to someone from the dealer to tell him how to do it.

Mar 08, 2011 | 1997 Chrysler Town & Country

1 Answer

I have a 1997 plymouth grand voyager. Everything was working fine until my battery died. Replaced battery & now my rear window wiper lights on the dash blink constantly. The wipers work fine when I cut...


What has most likely happened is that the Heater-a/c unit needs to be recalibrated and here are the steps to do so.
With the engine running and fully warmed up, A/C has to be turned off for at least 5 minutes [don't turn it on at all] and transmission in Park do the following
1. Set the temp control all the way to cold
2. Set the mode selector to Vent so air blows out of the dash panel outlets.
3. Hold down the rear washer button and the rear wiper buttons simultaineously for about 5 seconds until most all of the heater and ac panel lights blink and then release both buttons
6. At this point the system should go into a self calibration test which can take up to 60 seconds. While it is calibrating various control panel switch lights will blink as it goes through it's tests.
7. When the system is done calibrating then just the rear wiper light should be flashing and you can exit the test by turning off the vehicle. Wait about 10 seconds and restart the engine and it should be fine. If both the rear wiper and intermittent light are both still flashing after the calibration then there is most likely a problem with the system that will need more diagnosing. I see this fairly often with battery replacements so I think you'll be ok. It sometimes takes a couple of tries to calibrate so don't give up if it doesn't work the first time. Good luck, hope this helps!

Jul 14, 2010 | 1997 Plymouth Grand Voyager

1 Answer

Car overheated because of leak in the thermostat fixed problem now check engine light blinks 5 times then pauses and blinks 5 more times?


Remove the battery wires and leave diisconnected for an hour then replace.useulally solves the problem.

Jul 16, 2009 | 1995 Dodge Neon

3 Answers

Hold light blinking, check engine light on, engine slows down


check tps sensor (throttle position sensor in backside of the throttle cable) and map sensor (manifold absolute pressure on front little 1 inch sensor with vacuum line) make sure there plugged in. the ecm (engine control module driver side inner fender) and tcm (transmission control module under dash) both need the data to know when to upshift and increase fuel/air. Otherwise the computer runs default values and guesses off of other sensors giving poor performance. also disconnect battery for 15 min. usually resets aveo service lights if you dont have a scanner.

Jul 13, 2009 | 2004 Chevrolet Aveo

2 Answers

Security light on info panel blinks all the time and runs down the battery and the back door power locks do not unlock or lock when depressing the buttons is there a fuse for this and where can it be found


the light should blink all the time without running down your battery, that tells you it's working. pull one fuse at a time and see if any are blown for your locks. you may need a new battery.

Jul 01, 2009 | 1991 Cadillac DeVille

2 Answers

Doors will not lock.


chances are the light flashing is the alarm system not the door relay. locate the relay for the doors and replace it. usually located in the fuse panel under the dash.

Robert

Dec 15, 2008 | 2005 Dodge Grand Caravan

1 Answer

Blinking lights after battery replacement


Solution: The remote key entry system is waiting for you to push the "Unlock" button on your keyfob to sync up the car's receiver and the keyfob's transmitter. Just push the keyfob button and the lights will stop blinking.

Oct 03, 2008 | 2000 Subaru Forester

1 Answer

Panel lights


when you replaced the battery, you loosened the ground cable on the battery box. whitch grounds the the dashboard, tighten it up and see what happens

Aug 03, 2008 | 1998 Dodge Caravan

Not finding what you are looking for?
1998 Plymouth Voyager Logo

474 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...