Question about 2007 Nissan Xterra SE

1 Answer

Oil sending unit

Need the location of oil sending unit on 2007 v-6 engine

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 52 Answers

You mean oil level sensor? If yes it should in the sump

Posted on Apr 16, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

4 Answers

My 07 tahoe has no oil pressure ive drove it 10 mile to get homeit still runs good but still not showing any oil pressure


Hello, if your engine did not have oil pressure , I doubt you could drive it ten miles. I think you should check your oil pressure with an auxiliary pressure gauge. More than likely you might only need a new oil sending unit.

Mar 15, 2015 | 2007 Chevrolet Tahoe

2 Answers

How do I change the oil pressure sensor on 2007 Avalance


On both the V6 and V8 engines the Oil Sensor is located on top of the engine at the rear. You will need to remove the top of the intake manifold to get to it.

Feb 25, 2015 | 2007 Chevrolet Avalanche

1 Answer

Where is the oil sending unit located on a 2007 Chevy Impala LT?


On the passenger side. Look at the wheel well and find the oil filter. The sending unit is just above it.

Apr 11, 2014 | 2007 Chevrolet Impala LS Sedan New Cars

1 Answer

Location of oil sending unit


usually in the middle in the very back of the engine on top..some are near the oil filter .. check both locations

Apr 11, 2014 | 2007 Chevrolet Impala LS Sedan New Cars

1 Answer

I need to replace the oil sender switch on my 2002 Buick La Sabre


first need to buy oil pressure sending unit 3/8 deep socket remove oil pressure sending unit you need teflon tap sealer for oil sending unit threads.okay to replace oil pressure sending unit.you need safe raise support vechicle locate oil pressure sending unit next to the oil filter.disconnect oil pressure sending unit wire connector then use oil pressure sending unit 3/8 socket remove the sending unit.then take new oil pressure sending unit use teflon tape white plumbers tape or use thread sealer apply to the oil pressure sending unit threads then install new oil pressure sending unit and reconnect electrical connector to sending unit.then crank engine check for oil leak if all is good lower vechicle back to ground wait several minutes check engine oil level.you good to roll.

Feb 09, 2013 | 2002 Buick LeSabre

1 Answer

Where is the oil pressure sending unit located on a 1999 oldsmobile alero


2.2L ENGINE OIL SENDING UNIT LOCATED FRONT CAMSHAFT HOUSING ON LEFT DRIVER SIDE OF ENGINE.FOR 3.1L ENGINE OIL PRESSURE SENDING UNIT LOCATED NEXT TO OIL FILTER.

Sep 16, 2011 | 1999 Oldsmobile Alero

1 Answer

Where is the oil sending unit located on a 2002 chevrolet malibu


V6 ENGINE OIL PRESSURE SENDING UNIT LOCATION NEXT TO OIL FILTER. THE 4 CYLINDER ENGINE OIL PRESSURE SENDING UNIT LOCATION IS FRONT CAMSHAFT HOUSING ON THE LEFT DRIVER SIDE OF THE ENGINE COMPARTMENT.

Mar 20, 2011 | 2002 Chevrolet Malibu

1 Answer

What should the oil pressure be for a 2007 chevy avalanche


Start up with the engine cold, should be 60-65 psi Start up with engine hot and also running in gear idling 42-48psi
Any other readings could be a bad oil pressure sending unit or a oil pressure relieve valve which is located on the block where the remote oil line is bolted to. Good luck and keep me posted.

Feb 22, 2010 | 2007 Chevrolet Avalanche LTZ

Not finding what you are looking for?
2007 Nissan Xterra SE Logo

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...