Question about 2007 Toyota Avalon

1 Answer

2007 toyota avalon lkicense plate light do not work. Bulbs and fus are good. Any ideas

Every thing else on fuse works. I replaced both bulbs but still no luck

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Toyota Master
  • 632 Answers

Check for power and ground. The socket itself may be bad.

Posted on Apr 15, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1042 Answers

SOURCE: 94 toyota previa brake lights not illuminating

CHECK THE BRAKE LIGHT SWITCH UNDER THE BRAKE PEDAL

Posted on Jan 08, 2009

  • 840 Answers

SOURCE: 2002 license plate bulbs

its real simple look at the license plates then look up you will see 2 screw per lamp / unscrew them and slide remove its a 194 bulb so get some ready then replace and put back / Please rate my response thank you very much

Posted on Feb 02, 2009

localwonder
  • 6784 Answers

SOURCE: 2000 toyota camry turn signals not working. Fuses

Hi, i recommend testing the switch and flasher module. i will post the testing procedures for both devices. replace the device that is faulty.

To test turn signal switches, use a 12-volt test light to probe for voltage into and out of the switch. The ignition switch must be in the RUN position for the circuit to operate. If voltage is present on the input side of the switch but not on the output side, the switch is faulty.

FLASHER TEST PROCEDURE---

  • A test light can be used to determine which flasher is used for the turn signals and which is used for the hazard warning light.
  • An easier way is to turn on both the directionals and the hazards. This activates both flasher units.
  • By removing one of the flashers, the affected circuit no longer flashes.
  • Therefore, that flash unit controls that particular circuit.
  • If the turn signals fail to operate and the fuse is good, the flasher has probably failed.
  • Occasionally, the flasher does not flash as fast as it once did, or it flashes faster. This is also cause for replacement.
  • If it flashes too slowly or not at all, check for a burned-out bulb first.
the flasher is located in the Front seating area, driver side, driver side of steering column, mounted in corner behind instrument panel

If the turn signals operate properly in one direction but do not flash in the other, the problem is not in the flasher unit. A burned-out lamp filament will not cause enough current to flow to heat the bimetallic strip sufficiently to cause it to open. Thus the lights do not flash. Locate the faulty bulb and replace it.

Posted on May 19, 2009

  • 484 Answers

SOURCE: 1989 Toyota Camry. No brake lights.

It could be the relay, which is a yellow box located under the carpeting in the trunk on the left side. It is a problem common to your model. Also, check the brake switch's (behind the brake pedal) functionality (12V present with key at ACC or ON and continuity between wires when button engaged).

i hope this helps
-matthew

Posted on Oct 26, 2009

Testimonial: "Wow! I would have never found the problem without you guys. It was the relay located in the trunk. Thanks!"

Sean80000
  • 1867 Answers

SOURCE: brake lights not working,

Assuming the wiring to the brake lights is serviceable, you will find that the brake light switch, which is activated by the brake pedal for the brake lights, will have failed and will need to be replaced.


Just ensure you first replace the fuse and both brake light bulbs as an initial step and then re-check to ensure you still have no lights.

Sean

Posted on Jan 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 chevy equinox license plate light won't work after bulb and fuse replacement


Do the park lamps work ? license plate lights get power from same fuse ! Check ground wire ! use a volt meter an do voltage drop test ! Voltage Drop Testing The fuse for the license plate lights is in the under hood fuse box -engine compartment ! fuse #12 RT PRK LAMP 10Amp .

May 23, 2015 | 2007 Chevrolet Chevrolet Equinox LT

1 Answer

Only my brights work


The 2003 Toyota Avalon has a high beam bulb and a low beam bulb, so it is possible the low beam bulbs have burned out. Your low beams are bulb# 9006 Type A. You can see a diagram on how to change them here: http://www.toyota.com/t3Portal/document/om/OM41401U/pdf/7-3.pdf Another possibility is the fuses are blown. Each bulb has it's own fuse and you can see the fuse locations here: http://www.toyota.com/t3Portal/document/om/OM41401U/pdf/8.pdf

These are your 2 most likely and easy-to-fix solutions, so hopefully your problem will be resolved by one of these. Good luck!

Apr 22, 2014 | 2003 Toyota Avalon

1 Answer

Replaced license plate bulb on toyota avalon and dash indicator light remains on


Hi J, Make sure that the wattage of the replacement bulb is the correct rating and that no other bulbs are blown. Regards John

Feb 15, 2013 | 1997 Toyota Avalon

2 Answers

Tail lights on my1994 camry will not work, my sessor says its a bulb gone bad and I have done the following: 1. checked all fuses=all good 2. replaced bulbs 3. Turn signals work, licence plate lights...


under the hood on right side there should be a black box take cover off there should be breakers under there will be in breaker that says flasher check that breaker

Jul 08, 2011 | Toyota Camry Cars & Trucks

1 Answer

2000 Toyota Avalon - when you press the brake the light on the dash comes on and indicates a problem with the tail light. Checked all the bulbs, working fine. Replace two with new ones, light still on. ...


Make sure you are using the correct bulb numbers per manufactures recommendation. Diff types of bulbs even though they fit and light up will give light monitor false readings. You may have a malfunctioning light monitor which I have seen on a few of these models.

May 17, 2011 | 2000 Toyota Avalon

1 Answer

Which is the fuse for a toyota avalon reversing lights?


Might not have a fuse. If reverse lights are not working , and you have checked for burnt out bulbs , the most likely cause is the reverse gear sensor switch which is usually threaded into the transmission

May 29, 2010 | 2000 Toyota Avalon

1 Answer

2001 Toyota Avalon - Rear signals


Check the front lights. Usually if i flashes fast it indicate a bulb is out on that side.

Aug 02, 2009 | 2001 Toyota Avalon

1 Answer

2002 license plate bulbs


its real simple look at the license plates then look up you will see 2 screw per lamp / unscrew them and slide remove its a 194 bulb so get some ready then replace and put back / Please rate my response thank you very much

Feb 01, 2009 | 2002 Toyota Avalon

1 Answer

Rear light failure warning light


the warning light desapeared and everthing works as before with no problem. Guess there must be a loose conection? Will see how long it will last......

Sep 18, 2008 | 1997 Toyota Camry

Not finding what you are looking for?
2007 Toyota Avalon Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...