Question about 2004 GMC Envoy

Open Question

2003 gmc envoy - 2004 GMC Envoy

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: Air Vents 2003 Envoy

I have the same ploblem, I just wonder why this is not a recall yet? the other problem i got is the fuel gauge not working.

Posted on Aug 25, 2008

Ad
  • 4 Answers

SOURCE: How to replace the headlights on my 2003 GMC envoy.

The headlights on the envoy are the easiest parts of the car to repair. You just pull the two tabs at the top of the headlights, screw out the bulb containers and you are good to go

Posted on Nov 15, 2008

  • 1 Answer

SOURCE: 2003 GMC Envoy lower 3 heater fan settings quit working.

had same problem on my XUV. changed the blower motor resistor, located under passenger side dash. easy to change, works no problem.

Posted on Feb 17, 2009

  • 179 Answers

SOURCE: 2003 GMC Envoy stalling w/ AC on when stopping

try turning up the idle ajustment screw also have alternator checked, another solution would be to have your car tuned up weak spark from your coil worn plugs wires etc. not enough power is being produced

Posted on May 31, 2009

  • 691 Answers

SOURCE: how do you change brakes on a 2003 gmc envoy

don't need any special tools, standard sockets sets, "C" clams is a must unless your a He-Man and wrench set, plyer or needle nose will do. I assumed being 2003 your rotor never have been turn and i recommend every time you change your bakes is good idea to have your rotor turn. reason is it will make your pad last lot longer, removed any vibration and better even wear on the pad and eliminate any squealing although is not necessary to do so. make sure you get extra break fluid to bleed the brakes. get your self 5 feet long smallest vacum rubber hoses and a glass jar to bleed your brake fluid in. the rubber vacum hose you going to use to fit on to the bleeding nipple and run the other end of line to your the glass jar to save the brake fluid when you bleed the brakes. when removing caliper, check inspect make sure the rubber seals around your piston look good and not crack or deteriorated. before applying new pad make sure you open the bleed valve to reduce the pressure by turning the bleed nipple counter clockwise and leave it open attach that rubber hoses to the nipple because you going to press on the piston back into it housing with the "C" clamp in order for new pad to fit. becareful not to damage the rubber seals around the piston. its going to take lots of effort to push that piston back in so be a bare with it if needs to. once the pad is back in make sure you keep the reservoir full with brake fluid and then bleed the brake. two people is a good idea to do brake. one will do the pumping the brake and holding it down and other will bleed the nipple. I bleed it 2-3 time will do the job. good luck!

Posted on Jul 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Were is the fuse for the right blinker in a 2003 gmc envoy


Hey Derrick,
I do not think the blinkers have a "right" and "left" fuse...Its usually a flasher/blinker relay.
Try replacing the bulbs.. make sure their sockets are clean and able to hold the bulbs tight. If you are not getting both right side blinkers to work and you know both bulbs are good, the switch in the column may be the culprit.

2003 GMC ENVOY 4 2L L6 Turn Signal Switch RockAuto

Turn signal/Flasher
2003 GMC ENVOY 4 2L L6 Flasher RockAuto

Bulbs/Sockets
http://www.rockauto.com/en/catalog/gmc,2003,envoy,4.2l+l6,1415269,electrical-bulb+&+socket,turn+signal+lamp+bulb,13675

Sep 24, 2017 | GMC Cars & Trucks

1 Answer

Where is the tail light fuse?


The tail light fuse is under the rear seat on the drivers side.

Jan 17, 2016 | 2003 GMC Envoy

1 Answer

My 2003 gmc envoy wont shift out of first gear


There is a linkage hooked to the indicator that may be broken

Oct 15, 2014 | 2003 GMC Envoy

1 Answer

HOW DO I LOCATE CYLINDER 6 ON A 2003 GMC ENVOY THAT HAS A 4.2 V-6


the last cylinder is the number 6 front to rear

Sep 11, 2014 | 2003 GMC Envoy

1 Answer

Im having a p1133 po171 po300 po175 on gmc envoy 5.3L what could be the problem


Intake manifold gasket leaking.Replace the intake manifold gaskets.

Jan 21, 2012 | 2003 GMC Envoy

1 Answer

The back gate won't stay up on 2003 GMC envoy


You need to replace the two gas struts on either side of the rear hatch.

Apr 14, 2010 | 2003 GMC Envoy

1 Answer

Need to find blower resistor for 2003 GMC envoy


ITS UNDER THE RIGHT INSTRUMENT PANEL.YOU HAVE TO MOVE THE GLOVE BOX DOOR.TO GET TO BLOWER MOTOR AND RELAY AND THE RESISTOR.

Jun 06, 2009 | 2004 GMC Envoy

2 Answers

How to replace the headlights on my 2003 GMC envoy.


The headlights on the envoy are the easiest parts of the car to repair. You just pull the two tabs at the top of the headlights, screw out the bulb containers and you are good to go

Nov 01, 2008 | 2003 GMC Envoy

Not finding what you are looking for?
2004 GMC Envoy Logo

Related Topics:

10 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...