Question about 2010 Chevrolet Traverse
AC will not come on when the button is pushed. The ac light blinks three times.
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
If your vehicle is equipped with automatic climate control, this should help.
The HVAC control module controls the air intake through the recirculation actuator. The recirculation switch closes the recirculation door in order to circulate the air within the vehicle. The outside air switch opens the recirculation door in order to route outside air into the vehicle. Regardless of the blower motor switch position, recirculation is available only in the panel and bi-level mode switch positions. Including the OFF position. The mode switch must be placed in either the panel or bi-level position before the blower motor switch is placed in the OFF position. In order to reduce windshield fogging, outside air is circulated when the mode switch is in the defrost or defog positions. If the recirculation switch is pressed into the ON position when the mode switch is in an unavailable mode position, then the recirculation switch LED will flash 3 times. If the HVAC control module detects a fault with the recirc door the HVAC control module will try to drive the actuator for a predetermined amount of time, to outside air, which is the defaulted position for the recirculation actuator
Posted on Oct 17, 2009
When the light is blinking that means there is a code in the system you will have to take it to a shop and have the codes read. Sometimes "Jiffy Lube" or "Rapid Oil Change" can read the code for but they won't fix it. If the blower motor only runs on high, the blower motor resistor is bad. When you put the fan switch on high it puts full voltage to the fan motor (blower motor) when the fan switch is in any other position, the voltage is reduced by the resistor causing the motor to run at slower speeds. The two problems are probably a result of the resistor.
Posted on Dec 14, 2009
Testimonial: "Just the kind of response I needed. Clear and to the point. Thanks"
this light is on because the system is cycling the ac compressor to often, this means the system is low on charge, this means u have a leak, the leak is either the compressor front seal or the ac condensor core, both of which many times pass leak tests.
Posted on May 25, 2010
Testimonial: "Your suggestions are helpful but how do I check for leak on the compressor if no pressure leak is found with testing?"
Tips for a great answer:
May 17, 2017 | Buick Cars & Trucks
Sep 23, 2014 | 2001 Mitsubishi Montero Limited
May 18, 2013 | 2001 Oldsmobile Aurora
Apr 03, 2012 | Cars & Trucks
Jun 24, 2010 | 1997 Dodge Grand Caravan
May 25, 2010 | 1998 Chevrolet Corvette
Aug 08, 2009 | Plymouth Voyager Cars & Trucks
May 09, 2009 | 1998 Dodge Caravan
35 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: