Question about 2010 Nissan Note 1.4

Open Question

How do i change the rear window wiper blade on my 2014 nissan note hatchback

I can take off the 10 mm nut but the wiper will not pull off easily. H ow mucy fore do i need without brearking it or is there some trick to getting this done right?

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1901 Answers

SOURCE: How to change wiper blades on 2007 Nissan Altima

Most wiper blades are replaced the same way as on this video. I have a 2006 Altima and it is.

Make sure you have the correct size wipers. You have 2 different sizes (lengths) so use the manual where you buy them and get the right ones.

Thanks for using Fixya.

Posted on Sep 07, 2009

  • 430 Answers

SOURCE: How do you replace the rear window wiper on a 2006

Sure, you have to remove the outer blade by moving the plastic cover off of the mount location & then remove the nut. You'll need to remove the door trim panel once the back door is open, once removed you'll see the harness leading to the motor & the mounting bolts. once removed, it's a straight pull out & you are done. To remove the back door trim, you'll need to gently pry out the 2 lights with a padded flat screwdriver & disconnect the plug-in connector, push in on the little buttons at the bottom of the door and then pry the 1/2 " push in plugs out, (these are all reusable) remove the handle/grip by gently prying & the panel will more or less "pop" out of the holders. It's a push fit once the bottom retainers are removed. Good Luck

Posted on Jan 27, 2010

Testimonial: "Thank you I will try tomorrow."

  • 100 Answers

SOURCE: wiper blade motor runs but blades do not work

you have broken the gears in wiper transmission

Posted on Feb 15, 2010

  • 430 Answers

SOURCE: Remone rear wiper blade 2006 nissan murano

You need to first remove the plastic cover (it just snaps on at the base & lifts upward) that hides the 10mm nut. Remove the nut & wiggle the arm a bit to remove. then you'll need to flip the wiper blade assy until the opening in it allows removal.

good luck

Posted on Feb 16, 2010

  • 6826 Answers

SOURCE: How do I change wiper blades on 2001 nissan

I couldn't find instructions specific to your make and model and year for installing windshield wiper blades online or on my online resource.

Try getting Autozone and Advance Auto or Walmart to install for 'free' if you purchase them there, if you can't install them yourself.

What about the package directions are indecipherable?

Posted on Aug 01, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Replace rear wiper blade

buy a complete wiper arm from ebay or amazon because the original blade is not standard the center it thinker than a normal 10 inch blade ..the good thing is when you change the rear wiper arm you can then use normal 11 inch blades when you need to change again the cost of a new arm and blade is around £15 [2016 ] keep the original black cover nut because i found the replacement did not fit over the nut

Feb 08, 2014 | 2005 Hyundai Tucson

1 Answer

To replace rear wiper blade on nissan note 2010

Read the manual for my 2010 Note and it says to remove the old one simply rotate the wiper blade anti-clockwise until it comes free. I've done this and it feels like you're going to break it but it just comes free! then to fit the new one simply reverse the rotation. Simples.

Apr 06, 2012 | 2010 Nissan Note 1.6

1 Answer

How do I take a wiper arm of off the rear window of a Toyota celi

this either has a nut on the base of the arm that needs to be removed or if no nut. then pull the arm away from the glass and there will be a meatal tab at the base of the arm that will slide to the side with this slid to the side the wiper arm is unlocked and will pop right off

Jan 12, 2010 | 1984 Toyota Celica

2 Answers

How to remove and replace the wiper blades on an 06 Murano

Me again. After looking at the blade for 15 minutes or so I did the following. Remove the wiper blade from vehicle (makes it easier to work on). There is a little tab under the blade near the end of the wiper blade arm. Press it and slide/pull the wiper blade toward you. Now when you look at the wiper it seems like its a sealed unit. Check the ends and you will see the rubber is flexibe enough to allow you to slid the "wiper" out ot the blade. You can get the replacement refill (the wiper) or a replacement wiper blade (the whole unit) from the Nissan dealer. Take the refill and slide into the blade assembly. Take your time. You might have to straighten the blade a little so that the refile lines up with the holding tabs in the blade. Looks impossible, but once you've done it you'll be surprised how simple it was to do......****

Dec 21, 2009 | 2006 Nissan Murano

1 Answer

How to remove the rear arm wiper on toyota echo 2003 hatchback?

at the bottom of the arm where it joins the car there is a plastic cover you lift off and undo a 10 mm nut and the wiper comes off

Oct 26, 2009 | 2003 Toyota ECHO

1 Answer

How to replace the wiper insert at the back of

    1. Raise the rear wiper blade to the position as shown in the illustration where the meshing of the claw disengages with a clicking sound. NOTE: Be careful not to break the claw.
    2. Pull straight the rear wiper blade to vehicle's left from the wiper arm. NOTE: Do not fold the rear wiper arm with the rear wiper blade removed from it.1722d05.gif

    1. Place the rear wiper with the rear end of the rubber protruded from the blade stopper as shown in the illustration. NOTE: Do not pull out the wiper rubber forcibly, as the backing plates will become deformed or the blade claws will become damaged. HINT: The rubber can be easily pulled out by pushing the middle area of the blade.
    1. Install the 2 wiper rubber backing plates to the rear wiper rubber. NOTE: Be careful to observe and keep direction of curvature for correct replacement.
b. Insert the rear wiper rubber from the claw of the middle of the rear wiper blade into the rear end position.
c. After passing the rear wiper rubber through the rear end side claw, protrude it from the rear end stopper and pass it through the front tip side claw.

Sep 12, 2009 | 2005 Toyota Matrix

1 Answer

My 07 nissan murano rear windshield wiper doesn't work properly it goes the wrong way, not on the window.

You need to adjust the wiper arm location. Loosen the 12 mm or 10 mm nut that holds the rear wiper arm. Wiggle the arm until it comes off. Then turn on the rear wiper for a second and turn it off, leaving the key on. This way the rear wiper motor will do it's sweep, and them park where it's suppose to. Then reattach the rear wiper arm and secure the nut and recheck.

Thanks Jay!

Jul 20, 2009 | 2007 Nissan Murano SE

2 Answers

Replace rear wiper on 2005 Murano

You probably already figured this out, but you have to remove the wiper arm completely in order to replace the wiper blade.

The blades are an unusual size (somewhere around 14 1/2") and I believe they are only available from a Nissan dealership. They include printed instructions in the box but just in case, this is from the official Nissan service manual:



Apr 05, 2009 | 2005 Nissan Murano

1 Answer

How to change a 2006 Nissan Murano rear wiper balde

There are two ways. You can replace the rubber cartridge by simply removing any retaining clips from the end of the blade and sliding the old cartridge out, then sliding the new cartridge in and reclipping. Replacing the entire blade isn't that difficult either. Tilt the wiper back from the window so you can see where the blade pivots on a pin with clips holding the pin. Gently pry the wiper out from the clips on either side of the pin(you only need to pry on one) while pushing the blade in toward the wiper cover. It should pop out of the clips with a small amount of effort. You'll then have to weasel it out but it comes out pretty easily. Take off any adaptor that comes attached to the new 14" wiper and install.

Mar 28, 2009 | 2006 Nissan Murano

2 Answers

Rear wiper linkge BMWe46 touring 2003 year

Not sure about this exact car but 99% of all wiper motors are retained with a nut ythart lives under the base of the wiper arm and with three or 4 nuts from the rear of the motor. Take the wiper arm off, possibly requiring the use of a 10 mm wrench, and you will see a large nut, remove this. See if the wioper mote is accessed from the trunk, most likly under a clip in panal, split the electrical connector and remove the nuts holding the motor on. You will see that the collar that had the nut accessed from above will be stiff to move on the wiper shaft. Work it off, scotch brite the shaft, run a small wire brush down the typically plastic tube, lube the shaft with chassis grease or white grease, check that it moves freely in the collar and reassemble

good luck

Feb 06, 2009 | 1999 BMW 318 ti

Not finding what you are looking for?
2010 Nissan Note 1.4 Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides