Question about 1998 Toyota Tacoma

Open Question

How to replace or adjust kickdown cable 1998 toyota tacoma

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: blower reisitor, 1998 Toyota Tacoma

The blower motor resistor is located in the heater box area, which is under the dashboard on the passenger side. You will find the resistor in the large squarish tube that leads to the center of the dash from the blower motor housing (right to left on an american vehicle). Unplug the large black wiring connector, remove the 2 phillips screws and the resistor is ready to pull out of the heater box.

Posted on Sep 19, 2008

emissionwiz
  • 75077 Answers

SOURCE: DOES A 96 TOYOTA TACOMA CLUTCH HAVE AN ADJUSTMENT

it is a self adjusting hydraulic clutch, if the clutch is engaging high on the pedal the clutch is worn out.

Posted on Nov 02, 2009

Testimonial: "THAT WAS FAST THANKS "

BillB-SA
  • 2761 Answers

SOURCE: thermostat replacement in a 1998 toyota tacoma

You're going to lose some coolant, so have a bucket or other container ready. Follow the upper radiator hose to the point where it's connected to the engine. The hose is clamped to a metal housing which is bolted to the engine. Remove the bolts (not the hose) and lift the housing to expose the thermostat (may require a little prying with a screwdriver or similar tool). Note how the old thermostat is fitted (which end is up), lift it out of the engine, and then remove all traces of gasket from the housing and the engine. Install the new thermostat and gasket, replace the bolts, add coolant as necessary, and you're done.

Posted on Jan 04, 2010

arauzvictor1
  • 466 Answers

SOURCE: how do i remove the manuel clutch to a 1998 tacoma

If you want to change the "Remove clucht trasmision bars front and rear, remove the cylinder in the booth attendant said you have to remove the gear-change broadcasts have jack-remove the bracket that supports the transmission back-to remove the exhaust pipe - Put the jack, remove the screws that attach the transmission with the engine off, remove the transmission clucht well ... You have to ensure the transmission on the jack will not fall

Posted on Jan 11, 2010

  • 37 Answers

SOURCE: replacing front struts on a 2007 toyota tacoma

REALLY HARD PROJECT, TAKE IT TO SEARS, IT WILL ALSO NEED FRONT ALLIGNMENT

Posted on Jul 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Rav 4 1998 Toyota stalling when coming to a stop, turning or placed in park. Occasionally misses (jerks) when accelerating from a stop or slowing vehicle.


Did they clean the idle air control motor. I done a few. You have to use a pick or paper clip works and dig the carbon build up out of them, with using a cleaner.

Oct 03, 2014 | 1998 Toyota RAV4

2 Answers

Where is the Clutch Adjustment located on a 1996 Toyota Tacoma?


Hi,
The adjustment is in the clutch slave push rod and master( where the pedal push rod attaches the master cylinder ) if it uses a hydraulic type.
If it is cable type, the adjustment is on the cable front of the firewall, where the cable comes out from bulkhead.

Hope that helps!

Dec 07, 2011 | 1996 Toyota Tacoma

1 Answer

How to adjust the kick-down on the automatic gearbox on 1998 toyota VX diesel


Get a friend to depress the throttle fully. Make sure the opening value is fully open, take of air intake to view. Release the throttle. Now check that the kickdown cable is not slack. If it is loosen the outer cable nut and adjust so that the outer cable is 1mm from the stopper, that is from the rubber crommet where the cable comes through. The stopper is the big round thing.

Aug 31, 2010 | 1996 Toyota Land Cruiser

1 Answer

How do you tighten belt on a steering pump. Toyota Tacoma 2001, V6 prerunner


YOU ADJUST POWER STEERING BELT TENSION BY LOOSEN THE LOCKBOLT AND ADJUSTING BOLT TO IDLER PULLEY.

Apr 19, 2010 | 1998 Toyota Tacoma

1 Answer

Tacoma runs through all the gears but won't shift into overdrive


Check the bracket where your throttle cable is connected to the engine. There should be 2 cables. One of them is the throttle cable, the other is what I call the "kickdown cable" which tells your shift computer when you punch it and tells it to down shift. It can also affect the shifting ability. It is possible that cable has come off or so loose its not functioning properly. Of course it is also possible that your bands are ate up and you no longer have overdrive anymore. Try manually shifting from drive to overdrive see if that helps.

Feb 28, 2010 | 2006 Toyota Tacoma

1 Answer

How to repalce kickdown cable of toyota camry


you have to remove the trans pan and the valve body in the transmission

Feb 24, 2010 | 2000 Toyota Camry

1 Answer

Adjust kickdown cable


If it is an overdrive, there isn't a kickdown cable. I would suspect something wrong with the engines output.

Apr 01, 2009 | 1997 Plymouth Breeze

2 Answers

Adjusting the auto kickdown on a 1994 Isuzu Mu 3.1 Deisel


there should be a cable that runs off the throttle body

Jan 31, 2009 | 1994 Isuzu Trooper

1 Answer

Starter will not turn off, 1998 toyota tacoma


Either the starter has failed or you have a bad ground. I would say starter.

Jan 09, 2009 | 1998 Toyota Tacoma

Not finding what you are looking for?
1998 Toyota Tacoma Logo

Related Topics:

158 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...