Question about 2009 Jeep Wrangler

Open Question

2009 jeep wrangler won't start, the engine won't try to turn

Tried to start my jeep - won't turn over. Looked under hood, humming coming from fuse box.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: Jeep wrangler Fuse box

i had the same problem. i drive a 95 so im not sure if it differs from were the fuse box is. look righ above you pedals to your far left. it should be right there. also if you instruments went out it will be a 15 fuse. its a blue fuse. next my panel went out cuz of the wires on my transmission. if yor looking at your jeep at the front. the wires will be on your left. make sure they are not burned or anything. it will be right on the side of your tranny. mind got burned by the exaust so they were shorting. check that is and see if that is what is it. for a temp fix just put some electrical tap around the wires and you should be set for a wile. good luck

Posted on Jun 30, 2008

Mikey108
  • 475 Answers

SOURCE: 1989 Jeep Cherokee - Electrical Problem - horn, brake lights, blinkers, radio/cd...

There could be a fusible link under the hood off the starter relay that is burnt out.

Posted on Oct 13, 2008

  • 1 Answer

SOURCE: 1989 Jeep Cherokee - Electrical Problem - horn, brake lights, blinkers, radio/cd...

I think I have found the problem. When I wiggle the ignition switch the turn signals and radio go on and off so I feel the issue is in the ignition switch. From what I understand the actual electronics for the switch are at the base of the sterring column behind the lower dash panel and is connected by a rod that may need adjusting.

Posted on Jan 04, 2009

  • 16 Answers

SOURCE: Jeep wrangler Fuse box

You have two locations for the fuse box. One is either under the hood or behind the glove box. I would pull apart the glove box and take a look.

Posted on Jan 10, 2009

ZJLimited
  • 17970 Answers

SOURCE: i need a diagram of the fuse box under the hood,

You tell us Jeep Cherokee (Laredo), in a Grand Cherokee subforum? I confussed.

If this is a Cherokee, review the Repair Manual XJ Cherokee

If this is Grand Cherokee, review ths Repair Manual ZJ-Secc-8W-Wiring-Diagrams (page 7, 9 and 10 for location, details and description). The diagramas can find it in the next pages.

I hope help yuo with this (remember rated this help). Good luck.

Posted on Oct 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

03 wrangler wont start


A problem on the ignotion?
____________-
wifi obd tool for ipad iphone

Oct 08, 2012 | 2003 Jeep Wrangler

1 Answer

95 jeep wrangler 4.0,won,t start,dash lites won,t go on.replaced starter relay.still won,t turn over.


Try checking the battery and battery leads. Sounds as though you have a bad battery. Also check your fuses under the hood and dash.

Jun 03, 2011 | 1995 Jeep Wrangler

1 Answer

Both headlights out on 1997 Jeep Wrangler. Don't see a fuse in the box in the dashboard indicating headlamps. Looked in the engine compartment, but don't know which fuse to check.


There is a fuse box under the hood on the passenger side remove the cover and the #10 fuse is for the headlamps. Look on under side of cover for fuse #s.

May 19, 2011 | 1997 Jeep Wrangler

2 Answers

I have a 1999 jeep cherokee that wont start. it's not getting fire to the distributor. what may be the problem?


Most likely the ignition coil assembly, in some cases the ignition module is faulty.

Jan 26, 2011 | 1999 Jeep Cherokee

2 Answers

I need a diagram for the under hood fuse box. More importantly the specific 20 amp fuse labeled F21. What is it for. I have a 1998 jeep wrangler 4.0 4wd.


Are you sure that this is for 20AMP, according with the repair manual, the position 20 in the Power Distribution Center if for Power Motor ABS Pump, and is 10AMP.

Verify it..

Mar 17, 2010 | 1998 Jeep Wrangler

1 Answer

1989 jeep wrangler starts jumping and backfiring


Start with the basics...meaning check the spark plug wires and spark plugs. While under the hood, inspect all hoses for a vacuum leak(s). Then turn the ignition key on-off-on-off- on...leave in the on position and write down the number of flashes the check engine light indicates....2 flashes = #2....pause.....3 flashes = #3.
Let start from here. Are you able to perform engine repairs or diagnostics???

Jan 17, 2010 | 1989 Jeep Wrangler

1 Answer

Low beams went out at the same time. is there a


their is a fuse for each side but where ?? must be in the fuse box

Nov 22, 2009 | 2004 Jeep Wrangler

4 Answers

2006 Jeep Wrangler won't start


First, make sure you can turn the engine by hand. If you can't then the starter can't turn it either. Have someone else turn the key and look for the source of the click...may be a relay. Go over the starting circuit with a volt meter. Check for power at the starter main terminal and then with the key turned to "start" check for power at the trigger terminal on the starter. Check battery voltage and check relay operation.
You have a neutral safety switch on the transmission if its an automatic and a clutch switch if it's a stick. Check them as well. Make sure battery grounding on fender and block are also clean and secure.

Oct 01, 2009 | 2006 Jeep Wrangler

2 Answers

Engine will not turnover


If there is no power coming IN to the starter relay - the ignition module has failed.
Replace the Ignition.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

Sep 24, 2009 | 2008 Jeep Wrangler

2 Answers

When trying to start my 2003 jeep cherokee nothing happens. It is like as if the car is not connected to a battery because like I said nothing happens. When I looked under my hood of course my battery was...


Hi just because the battery is new does not mean anything turn on your head light to see if they come on, if not most likely the battery, if you have a volt meter I would check the battery. Now if the light do come on then I would check the fuse for the ignition system, pull the fuse complete out to check if it is blown. These two check I would start with. Please let me know how you make out.

Cheers

Aug 23, 2008 | 2004 Jeep Wrangler

Not finding what you are looking for?
2009 Jeep Wrangler Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...