Question about 2002 Audi A4

Open Question

Diagnosis trouble codes p0332 - 2002 Audi A4

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2000 Buick le sabre custom. Service engine light came on when I had transmission and rear end rebuilt. I had the codes pulled ( P0332 and P0742) P0332 was the knock sensor. I replace that but...


IF you have just had the transmission rebuilt and you know the codes for the fault then I would be taking the vehicle back to the shop that rebuilt the transmission and have them fix it. It may be that a wire was not connected but should that not be the case it is up to the shop to fix any faults.. The engine light can be turned off after the fault is fixed by using a scanner which the shop should have,

May 04, 2014 | Cars & Trucks

1 Answer

Code p0332


P0332 Knock Sensor 2 Circuit Low Input (Bank 2)
__________
car code reader

May 14, 2013 | 2004 Chevrolet Avalanche

1 Answer

I have a 2002 Yukon P0332 Code


when you replace sensor trouble codes must be cleared out. or it will keep showing up, like yours

Feb 15, 2013 | 2002 GMC Yukon XL

1 Answer

Have a code come up p0332 on a cadilillac 2004


P0332 DTC Code - Knock Sensor 1 Circuit Low Input (Bank 2)
A knock sensor tells the engine computer when one or more of your engine's cylinders are "knocking", that is, exploding the air/fuel mixture in a way that delivers less power and can be damaging to the engine if prolonged.

The computer uses this information to tune the engine so that it doesn't knock. If your knock sensor on Bank #2 is generating a low output voltage (perhaps under 0.5V), then it will trigger a P0332 DTC. This P0332 code may show up intermittently or the Service Engine light may be lit constantly. Other knock sensor related DTC codes include P0325, P0326, P0327, P0328, P0329, P0330, P0331, P0333, and P0334.

You may notice drivability problems including fluctation engine RPM, a loss of power, and perhaps some hesitation. There may also be other symptoms.

Potential causes for a P0332 DTC include (but are not limited to):
The knock sensor is faulty and needs to be replaced
There is a wiring open/short/fault in the knock sensor circuit
The PCM/ECM has failed

For aditional details, just Contact Us.

Hope this helps; just keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Have a nice day and thanks for using FixYa.

Jose.

Oct 19, 2011 | 2004 Cadillac Escalade Ext

1 Answer

ABS light comes on... but no noticble degradation in operation etc.


Most likely a wheel speed sensor, hopefully... The only thing that will change when the ABS light is on is that the ABS will not function as long as the indicator is on. I hope this info helps.

When the airbag system is in functioning condition, the airbag warning light will remain on for about 7 seconds and go out when the ignition switch is set to ON .

If there is any malfunction, the airbag warning light will either stay on or off continuously. In such cases, perform on-board diagnostic in accordance with the specified procedure to determine trouble codes.


  1. Turn ignition switch ON (with engine OFF ).
85091723



  1. Connect DIAG. terminal to No.2 terminal of diagnosis connector located inside lower cover.
  2. Check in accordance with the trouble code indicated by the AIRBAG warning light, and record the trouble codes.
  3. Turn the ignition switch "OFF " and remove the DIAG. terminal from No.2 terminal of diagnosis connector.
85091724


HOW TO READ TROUBLE CODES
The ABS lamp flashes a code corresponding to the faulty parts.

The long segment (1.2 secs on) indicates a "ten", and the short segment (0.3 secs on) indicates a "one".





NOTE: This is the only information provided by the manufacturer for clearing diagnostic trouble codes.

97511505


CLEAR MEMORY
After eliminating problem as per trouble code, clear memory as follows:

Make sure ignition switch is ON (and engine off). Connect one DIAG. terminal (1) on diagnosis connector (2) terminal No.1.

where warning light is flashing, connect the other DIAG. terminal (3) on terminal No. 2 for at least three seconds . After memory is cleared, normal warning light flashing rate resumes. (Warning light flashes every 0.6 seconds (ON-OFF operation.) Memory cannot be cleared if any problem exists.

After clear memory and then DIAG. terminals (1) and (3), extract from diagnosis connector (2)

Jul 27, 2011 | 1999 Subaru Legacy

1 Answer

Diagnostic Trouble Code 332 JEEP LIBERTY ? WHAT IS THIS ?


2005 Jeep will be OBD II compliant and the trouble code(s) will be 4 digits after a P,B or U. Are you sure you wrote it down right?
For example P0332 for your car is Knock Sensor 2 Circuit Low Input (Bank 2)

Potential causes for a P0332 DTC include (but are not limited to):

  • The knock sensor is faulty and needs to be replaced
  • There is a wiring open/short/fault in the knock sensor circuit
  • The PCM/ECM has failed
Possible Solutions
  • Verify the resistance of the knock sensor (compare it to factory specs)
  • Inspect for broken/frayed wires leading to the sensor
  • Check the wiring and connections leading to/from the knock sensor and PCM/ECM
  • Verify proper voltage is reaching the knock sensor (e.g. 5 volts)
  • Verify proper grounding of sensor and circuit
  • Replace the knock sensor
  • Replace the PCM/ECM

Jan 25, 2011 | 2005 Jeep Liberty

2 Answers

Code p0332 and p0420


16716/P0332 - Knock Sensor 2 (G66): Signal Too Low Possible Symptoms
  • Irregular rpm
  • Drivability problems
  • Loss of power
  • Engine damage
Possible Causes
  • Circuit G66 short to Ground
  • Circuit G66 open
  • G66 improperly torqued
  • G66 damaged
  • Control Module damaged
16804/P0420/001056 - Catalyst System; Bank 1: Efficiency Below Threshold Possible Causes
  • Leakage in Intake and/or Exhaust System
  • Catalyst faulty
  • Oxygen Sensor(s) faulty
  • Oxygen Sensor(s) Control faulty
Possible Solutions
  • Check Intake and Exhaust System for Leaks
  • Check Catalyst
  • Check Oxygen Sensor(s)
  • Check Oxygen Sensor(s) Control
    • Perform Oxygen Sensor(s) Aging Check

May 03, 2010 | 2000 Chevrolet Monte Carlo

1 Answer

How do you correct repair code P0332 and how what should the cost be for a 2004 gmc denali?


P0332 Is set by a knock sensor, desiganted by GM as "Knock Sensor 2".

There could be many causes for this, from a misfire, to a loose sensor; so an appraisal from anyone without access to the vehicle is out of the question.

Dec 01, 2009 | 2004 GMC Sierra Denali

1 Answer

I have a 2002 chevy silverado 1500HD w/ 6.0 knock sensers


Your sensors that you changed were probably good.here's a link on your code. P0332 OBD II Trouble Code

May 04, 2017 | 1999 Daewoo Lanos

Not finding what you are looking for?
2002 Audi A4 Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76051 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14362 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...