Question about 2007 Hyundai Santa Fe Limited

Open Question

How to access climate control to fix bulb on hyundai sante fe 2007

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 566 Answers

SOURCE: 2007 Hyundai Santa Fe - Replacing fog light

hi have not had pleasure of this on santa fe yet? but will try to help dependant of which side o/s or n/s ? i would first remove the screws holding the front of the under engine plastic cover/shield and drop down sufficient to gain view/access? to the rear of fog lamp then if a cover is on? try turning anti clock to remove? or if rubber cover pull off? then the bulb and clip should be visible? unplug the wire from bulb then the spring clip holding bulb in place normally just sring the 2x top ends together and swing down/clear to remove bulb? refit new bulb correctly! pay attention to position old bulb positioned? then clip securely and re connect wire at this stage it would be best to ensure bulb works ?? before you re assemble all else? wish you luck and hope this helps with your problem ?

Posted on Oct 28, 2008

Ad
  • 1 Answer

SOURCE: Brake bulb

Open the back hatch and in the well of the hatch you'll see two big screw that hold the black trim that holds all the lights on the rear right side and the same for the left. Once you take of the whole console (it's a little tricky you'll have to pivot it like opening a car door for it to come off) inside back you'll see all the light socket pushed into the console. Turn and pull out for each socket and then you'll see each light bulb. from there just replace the bulb.

Posted on Dec 23, 2008

  • 10 Answers

SOURCE: My 2007 Sante Fe fog lamp bulb went out and I wasn't able to

Step:
1. Turn tires away from vehicle
2. There is a plastic covering in front of the wheel that usually goes around the wheel well. There are plastic thumb pins on the outer edges of this plastic covering. Remove the thumb pins and this plastic piece will come off.
3. Behind this you will find access to your fog lights.
4. Remove/Replace just like an ordinary head light.

Posted on Jul 17, 2009

seanpwright
  • 2030 Answers

SOURCE: HOW TO CHANGE SPARK PLUGS IN 2007 HYUNDAI SANTE FE

its pretty simple...

1) let engine cool down all the way
2) pull plug wires off plugs one at a time.
3) remove plugs with proper spark plug socket.
4) replace plug
5) replace wire
6) move to next one.

Posted on Nov 13, 2009

  • 1 Answer

SOURCE: Sante Fe 2007 Headlight not working but bulb is ok

In the 07 owners manual, ch 6 [Do it yourself maint.] shows the accessory fuses to the left of the steering wheel. [Just fwd of the drivers left knee.] There is a panel you can open revealing the fuse box. My book leads me to believe you should first check Fuse #7. This should control the headlamp and an instrument cluster, [which you may or may not have.] Do all your instruments work? If not, this may be your problem. The only reason I know about this is, I just had the same problem and replacing the bulb did not work. I hope this helps. If you don't have a manual, you should order one at the dealer or online. It is a necessity. good luck

Posted on Jan 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the auxiliary input in 2007 sante fe elite


If you don't see anything on the radio saying "auxiliary output" with a little earphone jack then you aren't Aux ready.

You might be able to go to a stereo shop and have them install an auxiliary output plug. They will pull the factory stereo out and splice/plug in an output wire that you can plug your iPod into.

Mar 28, 2014 | 2007 Hyundai Santa Fe Limited

1 Answer

2007 Sante Fe SE, Left turn signal light comes on when you apply the brakes


Most likely you just need to replace the bulb, fuse or flasher fuse. The flashing is usually a warning that one of those three is out.

Oct 15, 2013 | Hyundai Santa Fe Cars & Trucks

1 Answer

WHAT DOES THE REAR BLINKER BULB FOR THE 2007 SANTE FE LOOK LIKE?


Silly Question

Take the old one out & go to
the parts store for a new one

Dec 14, 2012 | Cars & Trucks

1 Answer

Where is the purge control valve on a 2007 sante fe


Hello,
Here is the picture to clear your doubts.
arjuun_4.jpg

If you like my answer kindly rate and a testimonial is accepted.
Thanks

Jul 10, 2011 | 2007 Hyundai Santa Fe Limited

1 Answer

How do you access the outside tail light to change the bulb on a 2008 Hyundai Sante Fe?


You can access the bulb by going to the rear of the car and removing the internal side panels at the opposite side of each tail light. You should see the covering and the socket for the light which you need to remove to gain access to the bulb.

Apr 04, 2011 | Hyundai Santa Fe Cars & Trucks

1 Answer

My 2007 Sante Fe fog lamp bulb went out and I wasn't able to


Step:
1. Turn tires away from vehicle
2. There is a plastic covering in front of the wheel that usually goes around the wheel well. There are plastic thumb pins on the outer edges of this plastic covering. Remove the thumb pins and this plastic piece will come off.
3. Behind this you will find access to your fog lights.
4. Remove/Replace just like an ordinary head light.

Jul 17, 2009 | Hyundai Santa Fe Cars & Trucks

1 Answer

How do I change the dash board light bulbs in 2002 Hyundai Sante


first remove the ashtray. there will be 2 screws where the ashtray used to be. remove those. then you just have to pry the panel off it will feel like it will break but then you hear a pop a couple of them. and then you replace the lights

Nov 25, 2008 | 2002 Hyundai Santa Fe

1 Answer

2007 Hyundai Santa Fe - Replacing fog light


hi have not had pleasure of this on santa fe yet? but will try to help dependant of which side o/s or n/s ? i would first remove the screws holding the front of the under engine plastic cover/shield and drop down sufficient to gain view/access? to the rear of fog lamp then if a cover is on? try turning anti clock to remove? or if rubber cover pull off? then the bulb and clip should be visible? unplug the wire from bulb then the spring clip holding bulb in place normally just sring the 2x top ends together and swing down/clear to remove bulb? refit new bulb correctly! pay attention to position old bulb positioned? then clip securely and re connect wire at this stage it would be best to ensure bulb works ?? before you re assemble all else? wish you luck and hope this helps with your problem ?

Oct 28, 2008 | 2007 Hyundai Santa Fe Limited

Not finding what you are looking for?
2007 Hyundai Santa Fe Limited Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8737 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...