Question about 2011 Hyundai i30

Open Question

Hyundai i30 problems

When driving boot lock sounds like its locking and unlocking while dash-board boot warning light flashes. Boot door pops using remote but lock doesn't release. Also cabin lights don't go on when the doors open.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 25 Answers

SOURCE: Imobilising car alarm on Hyundai Getz

it may be worth while changing the battery in the remote as it takes more power to send the frequency to disarm than to illuminate the l.e.d.

Posted on Aug 23, 2008

Ad
  • 958 Answers

SOURCE: 2001 Hyundai Elantra door locking problem

there is a short or a signal from the un-locking switch that is triggering your locks.

you have a switch manually to lock and un-lock your doors, the unlocking circuit is making contact.

you can try playing with your switch to un-short the switch or open it up ang check it.


tnx 4 using fixya,

drcool

Posted on Sep 26, 2008

  • 2 Answers

SOURCE: Door locks don't work

Disassemble the paneling on left side ,under the steering wheel. Remove all screws and pull out the panel until you can you can reach behind it to remove the two Black Relays, on the side closest to Steering wheel. Remove the Relay covers, Clean the contacts with a 1/8 fine strip of 600 wet/dry sand paper. Only place the paper between the contacts, and pull out while holding slight pressure on the relay Armature. Turn over the sandpaper and repeat once again. Very gently press the TOP resting contact pad closer to the armature, to lessen the gap between the contact points, so the armature doesn't have to travel as far to reach the closed contact position. Repeat the above with the other2nd Relay. Replace the covers, reinstall the relays And test the Door locks prior to buttoning up the paneling. Note, a pair of long needle nosed pliers will help in removing the relays. Just Grip the relay and rock in Forward and Backward as you apply upward pressure.

Posted on Oct 09, 2008

232K7
  • 26 Answers

SOURCE: when locking my hyundai tucson with the remote fob

have they always been that way?

these setting can be changed with a Hy-Scan at any hyundai dealersip.

Posted on Apr 14, 2009

  • 1 Answer

SOURCE: 2003 Hyundai Sonata Door Lock Problem

I had this problem. Through some research and asking some service personnel I found out it is a fairly easy fix. You will need to buy a new relay switch for the door locks. The dealer will/should know what you need. They are located (two of them, buy two and replace both) on the back side of the fuse box. It is not that easy to get back there. I had to lay on my back with my head up under the instrument panel. They are visible and can be removed if you take some time and be careful. Once I knew what I was looking at, it was easy to replace and the remote works like a charm. You can go to an auto supply, like Autozone, and they should have a schematic to show you where these relays are.

Posted on Jun 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I lock a renault megane 56 plate without the key card as it is not working


Locking/Unlocking the doors from the outside
This is done using the RENAULT Card; see the "RENAULT Card" information in Section 1.
In certain cases, the RENAULT card may not work:
- if the RENAULT card battery is weak, flat, etc.
- if equipment operating on the same frequency as the card (mobile phones, etc.) is used;
- vehicle located in a high electromagnetic radiation zone.
It is then possible:
- to use the key integrated into the card to unlock the front left-hand door;
- to lock each of the doors manually;
- to use the interior door locking/unlocking control (refer to the following pages).
Using the key integrated in the RENAULT card
Insert key 1 into the lock in the driver's door and lock or unlock. Locking the doors manually
Turn screw 2 with the door open (using the end of the key) and close the door.
This means that the doors are then locked from the outside.
The doors may then only be opened from the inside or by using the key in the front left-hand door. Interior locking/unlocking door control
Switch 3 controls the doors, boot and, depending on the vehicle, the fuel filler flap simultaneously.
If a door or the tailgate is open or not closed properly, the doors and tailgate lock/unlock quickly.
If you need to transport objects with the boot open, the other opening elements can still be locked: with the engine stopped, press switch 3 for more than five seconds to lock the other opening elements.
Locking the doors without the RENAULT card
For example, in the event of a discharged battery or the RENAULT card temporarily not working, etc.
With the engine switched off and an opening element (door or boot) open, press and hold switch 3 for more than five seconds.
When the door is closed, all the doors and the tailgate will be locked.
Unlocking the vehicle from the outside is only possible with the RENAULT card in the vehicle's access zone or using the key integrated in the RENAULT card.
Door and tailgate status indicator
With the ignition on, the warning light integrated in switch 3 informs you of the locking status of the opening elements:
- indicator light on, the doors and tailgate are locked,
- indicator light off, the doors and tailgate are unlocked.
When you lock the doors, the indicator light remains lit and then goes out.

Dec 12, 2015 | Renault Megane Cars & Trucks

1 Answer

My i30 boot open warning light staying on when boot is closed


Check the switch position. See if the light goes out if you manually depress the switch. If it does, raise the switch

Sep 13, 2014 | Cars & Trucks

1 Answer

How to fix sticking central locking on Hyundai i30?


Bring vehicle to dealer, they probably know whats going on.

Apr 25, 2014 | 2010 Hyundai i30 1.4

1 Answer

Central locking disengages then engages while i am driving


it sounds like your ignition (a box where many switches open or close when you start the car) they get bad connections after a decade or so

Nov 13, 2013 | 2003 Renault Megane

1 Answer

Beeping from the dash and saying its the boot lid open


yor boot lid light switch is probably on yor boot lock or catch if you have a warning lamp you have a switch either part of yor locking device or a button somewhere around the lid usually under a rubber grummet
arnie

Mar 10, 2013 | Cars & Trucks

1 Answer

Car alarm goes off randomly when driver door is locked. Dealer replaced both the front and rear driver side door locks, relying on codes. Neither lock replacement fixed the problem. We drive down the...


Sounds like a bad door switch on one of the four doors. The switches have multiple contacts to serve both the dome light and the alarm system. The actual switch button is under a rubber boot with ribbed sides. The switches themselves are under the interior trim behind the doors.

Jan 09, 2011 | 2006 Volkswagen Jetta

2 Answers

Trunk lid will not close and latch


need to have the clasp adjusted lower to grab the latch

Dec 19, 2010 | 2003 Audi A4 Cabriolet

1 Answer

How do i manually release the rear door on a ssab 9-3 2003 as the door module has failed


Trunk Lock After Closing
--------------------------
Desc.: What happens to the trunk lock when closing it.

Settings:
Yes: Automatically lock Boot on closing
No: Boot can be reopened using micro switch button located on the trunk/boot

* Trunk Lock After Drive Off
----------------------------
Desc.: Should the trunk be locked at drive off or after 30 sec.?

Settings:
Yes: Trunk/Boot will automatically lock when vehicle increases speed
No: Trunk/Boot will remain closed, however will be in the unlocked
condition if No was selected in the previous option.

* Door & Trunk Unlock at Key Out
--------------------------------
Desc.: When the is removed from the center console should door/trunk
be unlocked?

Settings:
Yes: All Doors & Trunk/Boot will Unlock when the Key is removed from
the Ignition Switch If Driver frequently locked all Doors when
driving
this feature would be beneficial.
No: Doors and Boot will remain in the same condition as they were
prior
to Key removal

* TSL Locking Logic (Theft Security Locking/Deadlock)
-------------------
Settings:
TSL at first Press: Default Setting. All Doors will lock in Deadlock
Mode
TSL at Second Press: All Doors will lock in Deadlock mode at the second
press of the Remote.

* Lock /Unlock Acknowledge
--------------------------
Settings:
None : No acknowledge will be visible
Indicators: Indicators will blink as acknowledge

* Follow Me Home Function
-------------------------
Settings:
Tail Light: When selected Tail Lights will be illuminated
Back Up Light: When Selected Reverse Light will be activated


Tech 2 Body Exterior Lighting & Horn
====================================

* High Beam Follow me home Active Time
--------------------------------------
Desc.: Follow Me Home Active Time can be adjusted between 0- 10 minutes

Settings:
This Feature can be turned on or Off .Yes / No can be selected.
Low Beam Automatic / Low Beam also in Position 0 (light switch)
Yes / No
Follow Me Home Active Time
- Daytime Driving Lights can be activated

* Parking Lights
----------------

Settings:
Act as Lead Me To the Car Light.

* Park Light On Reminder
------------------------
Settings:
On / Off
If Ignition is turned Off and the parking lights are active, Driver will
be warned if set to on.

* Show Trailer Light Outage
Desc.: REC will detect blown trailer light and display on SID

Settings:
Yes or No

* Trailer Light / Fog Light off
-------------------------------

Settings:
Yes: Fog Light Rear will be disabled When Trailer is connected Yes
No

* Horn Lock Unlock Acknowledge
------------------------------
Settings:
On: Horn will honk when car is locked
Off: Horn will not honk if car is locked


Tech 2 Body Locking
===================

* Panic Alarm Activation (Vehicles fitted with /Alarm only)
-----------------------------------------------------------
- Panic Button / Locking Switch
Central Locking Switch Driver /Passenger

Settings:
- Panic Button on Remote and locking switch inside vehicle will
activate alarm
- Panic Button will activate Alarm only
- Locking Switch inside vehicle (driver /passenger will activate
alarm only
- No Panic Alarm function required.

* Unlock Logic
--------------
Settings:
All at first press : All Doors will open & Fuel Lid will unlock if the
Driver or Passenger Door Switch is activated
Driver Door & Fuel Lid at first press : Only the drivers Door will unlock
& Fuel Lid will unlock when door
switch is activated

* Remote unlocking One Press
----------------------------
Settings:
All at first press: All Doors will open & Fuel Lid will unlock if the
Remote is pressed
Driver door & Fuel Lid at first press: Only the drivers Door will unlock &
Fuel Lid will unlock when the Remote
is pressed

Dec 17, 2010 | 2003 Saab 9-3

2 Answers

Cant get into boot


hi from uk as a getz owner(my wifes car) i do understand problem may i suggest this is most probably the lever on rear of the lockwhich is behind the cover on boothatch is probably loose hence when key is used the lever that connect to rod link and releases latch is slipping on key lock operation but when c/locking is used on drivers door it opens boot latck by motor no problem SO remove the panel from hatch held by screwsnear screen and pop plastic buttons on surround you will now have visual access to lock mech's and by using info provided above ? i am sure you can sort the problem if you use both key in lock operation and c/locking method to observe linkage it may be as suggested or a simple little ajustment of rod linkage hope this helps/inspires you ? best wishes from n/west uk lanc's

Dec 01, 2009 | 2003 Hyundai Accent

Not finding what you are looking for?
2011 Hyundai i30 Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...