Question about 2005 GMC Canyon Crew

1 Answer

Door open but not

I have a 2005 GMC Canyon that says a door is open on the information center. I have grease the latches, disconnected the battery for 3hrs,contact cleaned all 4 switches, disconnected all the switches, bought a new switch and ran it through all the doors, checked continuity and the info center still says doors open. Any thing else to try before I give up.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 287 Answers

When you checked continuity did you check to see if there was continuity to ground ? (a rubbed thru wire)

Posted on Apr 14, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75077 Answers

SOURCE: door ajar warning light will not go off ...

One of the door ajar switchs in your dooors has failed.

Posted on Nov 24, 2008

  • 1 Answer

SOURCE: brake light switch

In the 04 models there has been a recall on a part in the brake lights. You can look it up and it gives you a number to call GMC. If you truck is one of the affected models they will replace it for you.

Posted on Jan 28, 2009

  • 19 Answers

SOURCE: Replace glass, drivers door on 1997 GMC 1/2 ton Truck ,2wd, Power windows

you might also have to drill out the rivets that hold the lock actuator on to be able to manage the last roller into the scissor assembly. Use larg 1/2 in sheet metal screws to reattach.

Posted on May 16, 2009

  • 3 Answers

SOURCE: 2002 GMC Savana van inner door latch broken

You can pick up the handle from your local GMC dealer. I paid roughly $90 for both (a bit high...but money well spent!) As noted, yes; you do have to remove the interior door panel. From there it's just a matter of removing 4 nuts (metric #10 socket), and replacing them back once the new handle is slipped into place! The bars that operate the door latches simply snap into the plastic clips attached to the handle assembly.
The operation sounds worse then what it really is. It took me longer to write up this review than it did to actually do the work! 5 minutes max...done!! Hell, if you're local; buy the parts

Posted on Sep 08, 2010

  • 1 Answer

SOURCE: 2008 GMC Acadia manual liftgate

2007 GMC Acadia manual liftgate will not open. Is there a way to bypass the electronic switch to get it open and replace the switch or latch?

Posted on Feb 27, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine will crank but no start , GMC 2007 Canyon


you have to reset the computer. 2 ways use your key to lock and unlock the door or use your remote to enter truck

Dec 25, 2014 | 2005 GMC Canyon

1 Answer

Locked radio 2006 gmc canyon


Most modern cars have a security code enable for the installed radio/cd players. This is an anti-theft device.

The initial documents given to the owner when the vehicle was purchased lists this code and how to reset it.

If you are second owner/original owner who has lost this information, then, you can approach gmc canyon dealer and they will have this code on their server. Normally a free service (I believe).

The security code is lost from the radio whenever keep alive voltage is removed from the radio. i.e. You disconnected or replace the battery.

I hope this helps.

Jul 23, 2014 | 2006 GMC Canyon

1 Answer

Where is the inside fuse box for my 2005 canyon 4door


All fuses and circuit breakers for a 2005 GMC Canyon are located in the engine compartment fuse block.

This subject is covered in the 2005 GMC Canyon Owner's Manual on pages 5-98 through 5-102.

If you do not have an Owner's Manual, you can download a free PDF version clicking on the following direct link:

2005 GMC Canyon Owner's Manual

Jan 04, 2012 | Cars & Trucks

1 Answer

2005 gmc denali cannot open rear passenger door from outside


do you mean when opening the door with the door handle,if so then does the handle have any resistance or does it move like there is nothing connected to it.if so then the rod that connects the door handle to the latch may have come disconnected,bent or the clips that hold it attached to the handle and latch may have broken or come unfastened.you will have to remove the inner door panel to gain access to this area.

Jun 13, 2011 | 2005 GMC Yukon Xl Denali

1 Answer

2005 GMC Canyon windows won't roll back up on driver and passenger side.


2005 gmc canyon.driver side window and lock does not work.have relpaced switch. the new switch now giving the same problem.

Jan 18, 2011 | 2005 GMC Canyon

1 Answer

2005 Canyon 5 cyl 4x4 is not working


tyr disconnecting the battery with the trunck in 2 wheel mode, leave off for 1-2 min. then reconnect and try again, there may also be a software update required to solve this!

Apr 16, 2010 | 2005 GMC Canyon

1 Answer

Can't get door open


wiring connections or lock latch frozen --to manually bypass latch or to unlock rear hatch -- in the bottom of door panel is a round access hole remove cover just clipped into place using a flashlight and a screw driver about 3 inches in on bottom is the lock latch and window lock latch connections if u pull back on the inner latch u will unlock the hatch which will allow u to open it[ when opened check the wiring connections for corrosion or damage if good ] now u can remove the whole hatch panel and check the latches and actuator the actuator and latches,and rod clips sometimes need to be lubed or sometimes the clips break or disconnect clips can be purchased at any auto store panel is clipped into place carefully pry from a corner and using a screw driver or panel tool pry straight back till panel clip pops replacement of panel put clips in place and push in panel

Feb 08, 2010 | 2005 GMC Envoy

2 Answers

IDLE CONTROL SYSTEM CODE PO506


You need the idle control solenoid replaced. It is the dealer that will fix it for you.

Good luck.

Jan 02, 2010 | 2005 GMC Canyon

3 Answers

I have a 2005 GMC Canyon that the battery was changed about a month in a half ago. Now, If I don't start the truck for a couple of days I have to get a jump start. What is my problem? I think the battery...


Something must be staying on or somehow draining the battery with the car off. Check to make sure lights aren't staying on, check the map lights, dome light, visor lights etc. Did you recently install any aftermarket electronic parts?

Nov 29, 2009 | 2005 GMC Canyon

1 Answer

Replace passenger side mirror, power


Open the door. Look for a cheap piece of plastic near where the mirror is located. Carefully pry the plastic off. There are 3 bolts. There is a wire harness connector. Unbolt the mirror and unclip the harness. Installation is reverse of removal. Easy job.

Jun 10, 2009 | 2005 GMC Canyon

Not finding what you are looking for?
2005 GMC Canyon Crew Logo

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...