Question about 2003 Cadillac Seville

1 Answer

Pulled relay for starter then replaced relay now it starter wont work

Starter wont work after pulling the relay for the starter and put it back

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert that hasĀ over 500 points.


    An expert who has answered 200 questions.

  • Expert
  • 257 Answers

Same relay? was it bad? chk fuse now!. lol.

Posted on Apr 14, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Aurora 4.0 im stumped checked starer relay and car still wont start clicking ssound comin from backseat jumped it whats wrong

What year vehicle ? The clicking sound you hear from bake seat is probably a relay ! There is a fuse / relay box under the back seat ! How did you check the starter relay ? Just pull it out an look at it ? Was it #36 START 1 Relay
-- Starter Solenoid and PCM in the under hood fuse / relay Box ?
This relay is computer energized - PCM supply's a ground to circuit 447 which energizes the relay sending voltage to the starter S terminal engaging the starter . Do you have a test light or a volt ohm meter ? If you pull out the starter relay an look on the bottom you will see some numbers , 85,86 an 30,87 . match them up to the holes they came out of . Check out this video on YouTube ,you can check for voltage an computer control . Is the SECRUITY light lit on the dash ?
This VEHICLE RELAYS Operation Diagnosis VEHICLE RELAYS Testing from the relay base

Aug 11, 2015 | Oldsmobile Aurora Cars & Trucks

1 Answer

For ranger new starter wont stop running

Starter Relay The starter motor solenoid relay switch (11450) consists of a pull-in coil, a contact disc, and two terminal contacts. Battery voltage is always present at the relay positive terminal. When the ignition switch (11572) is in the START position, the pull-in coil is activated and pulls the contact disc into contact with both terminal contacts. This allows battery current to pass through the starter motor solenoid relay switch to the starter solenoid (11390). The starter solenoid is deactivated when the ignition switch is in the RUN or OFF position.
Maybe something is hooked up wrong ! Or the starter relay is bad

Mar 11, 2015 | 1998 Ford Ranger

1 Answer

What can I check next after replacing starter the car still wont turn over. not a sound.

The starter wire runs from the ignition switch to the neutral safety switch (located on the transmission), then to the fuse and relay, then to the starter solenoid. Pull the crank/starter fuse look at it, put it back in if it is good. This gets rid of corrosion problems. Try to start. If it doesn't I would go to the safety switch next.

Nov 15, 2014 | 2003 Dodge Stratus

1 Answer

Chevy colorado wont turn over or start

first check to see if batteries has full charge if so pull shifter to nuetral for automatic trans and try if no go put shifter back in park check each fuse and starter relay some times their will be a like relay you can switch places with for test purpose if none of these do the trick you may need a new starter

Jan 21, 2013 | Chevrolet Colorado Cars & Trucks

1 Answer

I have a 1988 deville and the starter went, replaced the starter now the car won't start at all, the starter is in right and the relay clicks but it wont start. is there a security lockout that wo

What relay ?
You may have the wire from the key switch on the wrong terminal.
If the car has an anti-theft system the key lock may not be reading the chip in the key.
Can you jumper the starter solenoid and make the starter work ?

Jul 19, 2012 | 1988 Cadillac Sedan DeVille

1 Answer

My non turbo 91 gto wont start. my immobiliser light flashes 10 times once i have try 2 start then goes blank. but when i pull the key out it goes back to its normal flashes. i beleave its a market...

The 1991 mitsubishi did not have fancy anti theft just a starter imbolizercheck the battery make sure it can crank and the light can you light turn on and does the horn work? If you want to defeat it you will need a toothpick this is only if it is the starter relay at fault take the key out of the ignition put in neutral someone in the car to step on the brake just in case you do this in gear and it runs you over. Find the starter relay it in thhe engine fuse box location take the cover off the relay and expose the switch put it back in its socket collapse the relay and it should crank the starter now if this is a stick have the helper step on the clutch it should crank, now have them put the key on collapse the starter relay key on stpe on the slutch the car should start warm it up and turn it off get that tooth pick make the relay collapse start the car

Aug 21, 2011 | 1991 Mitsubishi 3000GT

1 Answer

When i try to start my 92 Seville it sounds like the starter is wining and wont crank over

Sounds like your starter drive located on the nose of the starter has gone bad. Time to replace your starter or you can pull the starter off of the engine and take the starter nose off and replace just the drive unit, It's a little involved with putting back together due to the brushes having to be pulled back during assembly.

good luck,


Jul 21, 2011 | 1992 Cadillac Seville

2 Answers

My saturn SL2 died at idle...and now wont crank over...there is juice to the starter and the battery has 13.1 volts

Any starter clicking noises? Try moving the shifter to "N" neutral and try starting the car.
IF that is not successful, find the starter relay in the under-hood fuse box, replace the relay with an identical relay from the under-hood fuse box and see if it will start. This will then eliminate the park/neutral start switch and the starter relay.
Let me know what you find.

Dec 02, 2009 | 1993 Saturn SL2

1 Answer

1999 Dodge durango 5.9 starter clicks but wont turn over replaced starter/battery good as well as the starter relays

pull starter back off but do not disconnect cables, then try key again, if starter spins use a large standard screwdriver to turn the flywheel through the starter mounting hole,if it doesnt move u have motor trouble

Oct 03, 2009 | 1999 Dodge Durango

3 Answers

It want start

Double check your connections and replace the fuse. That sound usually indicates there is a short.

Aug 27, 2009 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
2003 Cadillac Seville Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides