Check engine light came on and neutral light flashing
SOURCE: mitsubishi 2003 outlander check engine light
anyone can go to auto zone and have the obd2 tool put on it for free and have them tell you what to do
SOURCE: Blinking a/c light on 2005 mitsubishi outlander
usually when the light is blinking you are either low on freon or have a controller problem
SOURCE: mitsubishi outlander 2003 air conditioner- works
check air conditioner compressor fuse or relay.if all is good.you have a open compressor clutch coil or a bad compressor.also check compressor clutch wire.
SOURCE: mitsubishi outlander cooling fans not operating
There is a Recall to replace your cooling fan module because of this concern.
Open your hood and look at the black box bolted to your radiator fan by the battery. If it does not have a green dot on it, you have not had the replacement fan module installed.
Contact your local dealer with your VIN handy to verify the recall has not been done and to schedule an appointment.
If the recall has been done, verify if you have power coming out of the module to the fans, as the fans do burn out eventually.... but rarely both at once.
SOURCE: how do you reset change oil light on mitsubishi outlander
Turn the key off.
Press the "Info" button on the left of the dash cluster until your maintenance miles/months screen is displayed.
Press and hold the "info" button until the maintenance screen begins flashing.
Release the "info" button and then push and hold it it for one second.
Your Maintenance intervals should reset to +6 months and +7500 miles since the last interval amount.
Note that if you have not reset it for more than one interval, you may need to do it more than once. If you have not done it for many intervals, you may need to have it reset with the scantool at a dealer, as I have run into a handful of vehicles that the oil change reminder locked up after 3-4 "intervals" were skipped/not reset.
Whenever this warning or any other stays on in the dash it is indicating that the systems control module has detected a fault, it then disables the system as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)
357 views
Usually answered in minutes!
×