Question about 2007 Ford Fusion V6
In order to replace the rear spark plugs on a ford fusion with a 3.0l it requires removal of upper intake. Did you replace the gasket upon re installation? Check for vacuum leaks by lightly spraying some carb cleaner around the base of manifold. Good luck and always test drive to confirm repairs.
Posted on Dec 24, 2014
Sounds like you might have a bad fuel pump relay,
Posted on Apr 13, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Are you useing the recommened grade of fuel, the Taurus will have cold start issues if prem. fuel is used when 89 octane is recommened, saw this many times while working for ford.
Posted on Nov 02, 2008
depending on which trans it is there is a small dipstick on the trans at the front on the bottom these transmissions take a specific fluid so be careful
Posted on Nov 22, 2008
This sounds like a normal condition.What happens is the cold start emission reduction component monitor(software program in the computer) is running.
Cold Start Emission Reduction Component Monitor
The Cold Start Emission Reduction Component Monitor was introduced for the 2006 MY on vehicles that meet the
LEV-II emission standards. The monitor works by validating the operation of the components of the system
required to achieve the cold start emission reduction strategy, namely retarded spark timing and elevated idle
When the CSER strategy is enabled, the idle air control system will request a higher idle rpm, elevating engine
airflow. While this CSER elevated airflow is requested, the low airflow test compares the measured idle airflow from
the MAF sensor to the commanded idle airflow from the idle air control strategy.
Posted on Apr 02, 2009
This is straight from the owner's manual.
#1 Make sure the headlamp switch is in the OFF position and open the trunk.
#2 Carefully pull the carpet away to expose the backside of the tail lamp assembly.
#3 Remove the nut and washer assemblies, then pull the lamp assembly away from the vehicle.
#4 Remove the bulb socket by rotating it counterclockwise, then pulling it out of the lamp assembly.
#5 Pull the bulb straight from the socket.
Install new bulb(s) in reverse order.
Posted on Jan 23, 2010
SOURCE: 2006 ford fusion is idling rough
Have the fuel filter changed,then if this does not help,have the fuel pump pressure checked,and check for fuel contamination,fuel additives might help,heet,for moister,and lucas fuel treatment for contamination,and fuel cleaning,for the injectors.These are the best on the market.
Posted on Feb 12, 2010
Tips for a great answer:
Jul 29, 2017 | Ford Cars & Trucks
Feb 11, 2015 | Ford Cars & Trucks
Jan 29, 2014 | Ford Expedition Cars & Trucks
Jul 12, 2017 | 2000 Ford Ranger SuperCab
Sep 29, 2012 | 2010 Ford Fusion Hybrid
Feb 16, 2012 | 2006 Ford Fusion
Mar 15, 2009 | 2006 Ford Fusion
Dec 02, 2008 | 2000 Nissan Xterra
Jun 23, 2008 | 2007 Ford Fusion I4 SEL Sedan
Jun 13, 2014 | 2007 Ford Fusion V6
168 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: