Question about 1995 Ford Probe

1 Answer

Where is the transmission oil pan located on a 95 ford probe??

Where is the transmission oil pan located?? I found one located on the front by the electric fans for radiator... is that the only Transmission oil Pan... I took off that pan hardly any oil came out, I also took out bolt on side of transmission hardly any oil came then got to looking on internet. Now I have a 1/2 in drive Plug I need to remove. Because I guess its the one that needed to be removed to began with cause dipstick still says full with front trans. pan off, the hole on side of trans. is that where I'm suppose to fill the Trans at?? I put some down the dipstick tube and it shows overfilled .. thanks David...

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Ford Master
  • 987 Answers

It fills through the dipstick tube, with engine running,

Posted on Apr 13, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75051 Answers

SOURCE: 1999 Ford Explorer Oil Leak

You most likely hit a curb, the pan is cast aluminum and will break like glass if you hit a curb, the pan can be changed without removing the engine, it is very time consuming, but it can be done.

Posted on Aug 31, 2008

  • 1 Answer

SOURCE: 97 ford contour gl, info on transmission pan filter installation?

trans filter can only be replaced by taking the trans apart. absolutely not worth it.

Posted on Apr 12, 2009

  • 1348 Answers

SOURCE: Transmission oil change on 84 ranger with 5 spd

it is inset type ,a hex or square that fits a 3/8 ratchet.
if there is a bolt head,that is for the oil

Posted on May 13, 2009

  • 16 Answers

SOURCE: how to add fluid to a 5R55W ford transmission?

oh boy! good luck with that one! your right, there is NO filler tube (some idiot imagioneers not so bright idea at Ford), the only way to fill that trans. is through the filler/drain plug, it serves BOTH purposes! stupid? yes MOST DEFINATLY agree! you'll need to purchase a kit from the dealer (of all places) along with the use of (oops),
a compressor and a brake bleeder/filler kit in order to fill the case itself. You can atleast fill the torque converter manually before you install a new, or re-install your old one. I highly recommend replacing it as they too are a problem child as well (clattering noises from internal broken parts inside it). Sorry for the sarcastics, but this trans. is 1 of Fords engineers much BIGGER screw ups! Good luck! oh, p.s. make sure you use ALL new Mercon V fluid ( obviously the "new" trans., but the converter as well.

Posted on May 28, 2009

  • 25 Answers

SOURCE: need to know placement of transmission pan, automatic, filter in or out?

Trans pan is going to be the very lowest part of your transmission. The filter swap is just slightly concerning. Not to be rude, but you might want to have an assistant that is familiar with trans basics to walk you thru the first one if locating the pan was difficult.
If you feel that the filter swap is something you would like to do, start out by getting the filter kit and reviewing the included instructions. If they are not able to give a full and detailed explanation, they sometimes include a number to call. Dont bother. Just come back here and ask!
Automatic transmissions do not come with a drain plug. You will need to loosen all the small bolts around the edge except for one, to keep the entire pan from crashing to the ground and splashing oil everywhere. pull the edge down and into the drain pan goes the trans fluid. The filter is right under the pan. Cant miss it.

It is real important to be as clean as possible. No contaminants in the trans. If you can, pressure wash the area first and stay operating room clean!
Good Luck to ya

Posted on Jun 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I change my oil pan gasket on my 95 ford Thunderbird, thank you first time car owner


Lift your car and place on jack stands. Then drain engine oil from pan. If there is/are any other steering or suspension components under oil pan, remove these first. Then, begin removing all bolts that hold pan in place. There should be a few bolts that come from the rear of the transmission section that also hold engine oil pan. Remove these. Once all bolts are removed, use a rubber mallet to tap oil pan until is breaks loose. If hard to remove, use a pry bar or flat head screw driver to pry oil pan off. Install in reverse order.

Dec 30, 2016 | Ford Cars & Trucks

1 Answer

Where do I add Transmission fluid on a 95 ford Probe??


So you know, I am not insulting you. I don't know what you know or what you don't know. From your symptoms, I'm confused. If you pulled the trani pan down and the trani dip-stick still read "Full", you pulled the wrong dip-stick. Your transmission takes Mercon and you will need a narrow funnel that will fit inside the trani dip-stick tube. Follow the dip-stick tube all the way to the bottom and verify that it goes to the transmission. When you pulled the trani pan down you should have four or more quarts empty into your drain-pan. Until you can confirm that the the trani is properly filled, don't continue to use the car. Running the engine while the trani is empty can damage internal componants. If you have any questions, please write back, good luck.

Apr 13, 2014 | 1995 Ford Probe

1 Answer

I have a 95 t-bird and oil leaks in front by the oil pan having to put oil in it once a week could be the gasket around the the oil pan


It could be the oil pan gasket or the front seal behind the harmonic balancer(which is quicker and easier to fix) and it sounds more like the front seal is your issue.

Feb 18, 2011 | 1995 Ford Thunderbird

2 Answers

Weres the oil pan on ford explorer


The oil pan is where the oil collects on the bottom of the engine before the pump picks it up and circulates it back up through the engine. So it will be the bottom most thing, bolted directly to the bottom of the engine block. Generally found about centered between the front wheels. Hint, looks like a pan with many little bolt heads around its outer perimeter. Rarely obstructions from the road puncture it, and often times with age its gasket leaks.

Oct 03, 2010 | Ford Explorer Cars & Trucks

1 Answer

Transmission control solenoid location for 1993 buick regal


These solenoids are inside the transmission.
The main one you are referring to would be the big one near the front of the transmission with the pan off.
Be warned that if you try to remove the pan lots of oil will start pouring out.

Apr 07, 2010 | 1998 Ford Explorer

1 Answer

How difficult is replacing an engine pan and gasket on 95 ford f150 4.9 litre 2wd


  1. Drain the oil and the coolant
  1. Raise the vehicle on a lift. Disconnect the battery to starter relay cable at the starter motor and remove the bolts and starter motor.
  1. Remove the engine front support insulator-to-support bracket nuts and washers on both supports. Raise the front of the engine with a transmission jack and wood block and place thick wood blocks between the front mounts and engine. Lower the engine and remove the transmission jack.
  1. Remove the oil pan attaching bolts.
  1. Remove two bolts securing oil pump and screen bolts and drop them in the pan
  1. Remove oil pan

Mar 17, 2010 | 1995 Ford F150 Styleside Regular Cab

2 Answers

Torque specs for the trans pan bolts 1990 ford probe automatic?


The tightening is less torque, buyt rather gasket and pan squish.... barley gets tight, but too much and leaks happen.

Be certain to reform the pan bolt holes before you replace the pan.

So tightening happens evenly and stop just as the gasket shows deformation. This is after even tightening 2 or 3 steps....

Sep 20, 2009 | 1990 Ford Probe

2 Answers

Need to know placement of transmission pan, automatic, filter in or out?


Trans pan is going to be the very lowest part of your transmission. The filter swap is just slightly concerning. Not to be rude, but you might want to have an assistant that is familiar with trans basics to walk you thru the first one if locating the pan was difficult.
If you feel that the filter swap is something you would like to do, start out by getting the filter kit and reviewing the included instructions. If they are not able to give a full and detailed explanation, they sometimes include a number to call. Dont bother. Just come back here and ask!
Automatic transmissions do not come with a drain plug. You will need to loosen all the small bolts around the edge except for one, to keep the entire pan from crashing to the ground and splashing oil everywhere. pull the edge down and into the drain pan goes the trans fluid. The filter is right under the pan. Cant miss it.

It is real important to be as clean as possible. No contaminants in the trans. If you can, pressure wash the area first and stay operating room clean!
Good Luck to ya

Apr 29, 2009 | 1995 Ford Probe

2 Answers

Can't find the oil filter where is it located 95 chevy blazer


The drivers side of the motor toward the transmission. It is sometimes hidden by the exhaust but look next to the oil pan. It is a vertical oil filter.

Aug 05, 2008 | 2000 Chevrolet Blazer

Not finding what you are looking for?

Open Questions:

See all 1995 Ford Probe Questions

1995 Ford Probe Logo

401 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...