Question about 2006 Kia Sedona

1 Answer

Ignition fuse switch keeps blowing

Replaced the fuse about a week ago and it worked fine, now everytime I put a new fuse in ignition sw1 it blows. AS soon as the key is turn slightly it blows the fuse car cranks but no ignition..Thansk Leo

Posted by on

  • Leo Rines
    Leo Rines Apr 13, 2014

    I removed the fuse block and no wires were exposed back to the firewall where they enter the inside. I did a bipass on the fuse with a jumper so I could move the van in te garage, I then placed another fuse in the slot and it started working again. is it possible. bad relay in te same box for ignition?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Kia Master
  • 987 Answers

You have a short in that circuit chck your harness for wiring that might be exposed to ground or pinched

Posted on Apr 13, 2014

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
dttech
  • 4803 Answers

SOURCE: the fuel injector fuses keeps

There is a short circuit to ground on one of the circuits that the fuse protects. I need more information about your car and exactly which fuse is blowing. (Year, Make, Model, Engine size) All of the circuits powered by that fuse must be traced to find exactly what is causing it to blow. Most of the components can be eliminated as the cause by unplugging them one at a time and checking the fuse connector with a test light. (Otherwise, you could go through a lot of fuses trying to figure it out.)

Posted on Dec 24, 2010

  • 14036 Answers

SOURCE: fuse for the dash keeps blowing on 2001 kia

SOUND LIKE YOU HAVE FAULT IN THE TCM OR PCM.THE TRANSMISSION SHIFT SOLENOID FAULTY. YOU NEED A GARAGE OR TRANSMISSION SHOP TO USE DIAGNOSTIC EQUIPMENT TO LOOK FOR TRANSMISSION FAULT CODE SINCE TRANSMISSION IS TCM AND PCM CONTROLLED.

Posted on Jun 13, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 Bonneville! Several weeks ago, had trouble turning the key in the ignition - sometimes would turn, sometimes wouldn't. Then the Service Engine Soon light came on and the car stalled out a few times...


Service Engine Soon came back on and the car is again stalling ????? Did you have it checked for DTC'S - diagnostic trouble code's ? Service engine soon light on , codes will be present !

Apr 20, 2017 | 2001 Pontiac Bonneville

1 Answer

MY TAIL LIGHTS AND POWER WINDOWS BLOW A FUSE,AS AS SOON AS I TURN IGNITION ON.What could it be?


replace the tail lamps... one is dead shorting (filliment broken and grounding to the body of the bulb).

Mar 27, 2013 | Cars & Trucks

1 Answer

Starter Fuse Keeps Blowing When I Try To Start My 2001 Camry


The starter has gone to ground. This is either a coincidence of age or the repair shop left something disconnected that has slapped around and grounded the starter or some of their other work has shifted around and done it. It could just be a coincidence. If it went to ground internally, it will need replacing. If something shifted and grounded it out, putting that something where it belongs and THEN replacing a fuse should fix it. Most shops reuse your starter on their new engine.

Apr 16, 2017 | Toyota Camry Cars & Trucks

1 Answer

6 months ago, replaced head gaskets. 1 week later, service engine soon light came on. Tech said it was an oxygen sensor. Cleared code. 3 weeks ago, got oil change, replaced headlights and replaced...


CHECK TURN SIGNAL FUSE.IT COULD BE BLOWED OR YOU HAVE FAULTY TURN SIGNAL SWITCH.BECAUSE BACK LIGHTS AND TAIL LIGHTS SHARE SAME CIRCUIT WITH TURN SIGNAL SWITCH.

Jun 26, 2011 | 1999 Chevrolet Venture

1 Answer

I have a 1993 ford explorer, every time i turn the ke to the run position, it blows the ignition 60amp maxi fuse under the hood. The first time this happened, I replaced the fuse and the SUV ran fine for a...


I'm no expert but when you turn key to run position, this turns the fuel pump on if the pump is faulty i would think it would blow the fuse also. Or its your theory a short in the ignition system wiring.

Mar 20, 2011 | 1993 Ford Explorer Limited

2 Answers

Starter/Fuel Pump fuse, or the Relay Fuse blow


the fuel pump comes on when you turn the key on the starter comes on when you turn all the way to start so i would think the short is in the fuel pump if it blows by just turning the key on

Jul 17, 2009 | 2002 Chrysler Sebring

1 Answer

1997 Nissan Altima problem


Check your battery fuse mine just also did that and it was the fuse under the hood. Location of fuse box is by the battery and it should be the big fuse close to the middle

Nov 03, 2008 | 1997 Nissan.5 Altima

Not finding what you are looking for?
2006 Kia Sedona Logo

615 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

yadayada
yadayada

Level 3 Expert

77499 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...