Question about Ford Fiesta

1 Answer

Engine stalls when the car is running ,the engine stalls which obviously affects the servo system. Have changed fuel pump and also crank case sensor but still happens, probably once a day but is quite dangerous in traffic as servo also becomes inactive

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Spread the Word:

    An expert who has shared 5 answers on their Facebook wall.

  • Expert
  • 182 Answers

Change the servo and see, if the problem still remain apply some sublicatiosn

Posted on Apr 13, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Periodic stalling after running for awhile . when the key is turned on no power to the fuel pump. After setting a few minutes key is turned back on there is power to the fuel pump and starts


The fuel pump only turns on for 2sec when key is turned on for a fuel pump prime. The fuel pump will turn back on during engine cranking. The most likely cause of stalling on this particular vehicle is a weak/bad crank sensor.

Apr 06, 2015 | 1996 Jeep Grand Cherokee

1 Answer

What is the symptom of a bad crank shaft sensor


In most case's the vehicle will stall but won't continue to run or just a flat no start the crank sensor tell the computer the firing order and when to firer where the cam or distributor sensor tell the computer where number one cylinder is note that the crank sensor my hold both sensor in one. If you had a distributor less car it can affect both fuel and ignition system where as if you have a distributor it would more likely affect the fuel system only. I have seen bad sensor that just made for a poor run and low power do to a bad out put signal to the computer. Check it with a scope for a clean signal back to the computer.

May 25, 2014 | Audi A3 Cars & Trucks

2 Answers

Engine stall at iddle


Check for any cracked vacuum hose, Throttle clean it Check if you have any place sucking air.

Nov 22, 2013 | BMW 328 Cars & Trucks

2 Answers

My 1996 Chevy Camaro was running fine, up until last night. About halfway through my normal commute (70 miles), the gauges started bouncing all around and then the car stalled while driving. Pulling...


Hi

If your car stalled while you were driving it, look for an obvious reason first. Check to make sure you have fuel in the tank (if your gas gauge is working). Do not sit there and crank the car over, trying to get it to start, as you will quickly wear down the battery if it's not already bad.
Check the probable causes for this kind of problems:-
Ignition
The ignition system is composed of: ignition switch, neutral safety switch, security bypass, plugs, wires (if applicable) and a coil, or in the case of coil-over systems, many coils. The ignition is also tied into the computer. The crank and cam sensors tell the engine where top dead center is. Though these sensors do not usually cause a no start, if they break, the computer will go into "limp home mode," which allows you to get the car to a service station. The car will run badly, and may stall out on you. If the plug wires, plugs or coils are bad and are causing the engine to misfire, the engine will run rough. This may also cause the car to stall when driving. Generally, it will start back up, but it may be difficult to keep the car running.
Fuel
The fuel system is composed of a fuel pump, fuel filters, and fuel injectors or a carburetor. Some cars have a throttle body---this looks similar to a carburetor and has only one or two fuel injectors in the middle of it. The injectors feed all of the cylinders. In a multi-port system, each cylinder has its own injector. Should the fuel pump go bad, the car will stall while you are driving, as no fuel is getting pumped up to the engine. Bad injectors in a multi-port system will make the car run rough, which can cause a stalling situation, but generally, the car will restart.
Other Problems
There are other problems that can make a car stall---in the ignition system, the fuel system or in the drivetrain. If the timing belt breaks, the car will stall. If the computer itself stops working, the car will stall. Neither item will allow a car to start back up until it is repaired.All vehicles have an idle air motor or valve. The idle air is governed by the computer and changes the idle. When you turn on the air compressor, you use some engine resources. This makes the idle speed on the engine drop. The computer senses this drop and sends information to the idle air to turn up the idle so the car does not stall. If this part breaks, when you slow down to a stop or to turn a corner, the car may stall.
Because the running of a vehicle is complicated, there are many more things that can cause a vehicle to stall. These are the most common things that can cause a car to stall. Other things include wiring, fuses, relays, other sensors not working properly or at all, a bad alternator or a bad battery, or an overheating problem, just to name a few.

Please get back to us if you have further query or else please accept the solution.

Thanks for contacting fixya.com

Sep 12, 2011 | 1996 Chevrolet Camaro

2 Answers

I have a 92 Storm GSI. When driving down the road the car stalls like it is out of gas then starts running. I have replaced the fuel filter, pump and relay. Any other ideas?


For the age of this car it is a combination of both the fuel filter and pump, i owned one several years ago and found that the gas tanks are prone to rust inside, if you have replaced the pump and filter you may want to drop the tank again and check the screen on the pump if it is brown you have rust in the tank: another problem i had ( if you bought an oem pump ) they tend to slip out of position, you can tie the pump it place so it doesn't move......

Jun 29, 2011 | 1991 Geo Storm

1 Answer

02 gmc sonoma 4.3 engine starts and runs great for 30 minutes and then stalls like its flooded, if it sets after stalling for 30 minutes and cools able to drive home before starting to stall again. After...


Smell of the oil,to see if the fuel injector(spider)is leaking into the crank case,if so,the intake will have to be removed to repair the problem,oh,and change the oil.

Jul 11, 2010 | 2002 GMC Sonoma Extended Cab

2 Answers

Running engine stalled


There are many things that can cause a car to stall while driving it. An engine is made up of many parts, and many of those parts are either governed by a computer or provide input to the computer to help it determine settings for the things it governs. Every vehicle has a fuel system and an ignition system. The computer and its sensors monitor and govern the fuel and ignition systems.

If your car stalled while you were driving it, look for an obvious reason first. Check to make sure you have fuel in the tank (if your gas gauge is working). Do not sit there and crank the car over, trying to get it to start, as you will quickly wear down the battery if it's not already bad.

IGNITION:
The ignition system is composed of: ignition switch, neutral safety switch, security bypass, plugs, wires (if applicable) and a coil, or in the case of coil-over systems, many coils. The crank and cam sensors tell the engine where top dead center is. Though these sensors do not usually cause a no start, if they break, the computer will go into "limp home mode," which allows you to get the car to a service station. The car will run badly, and may stall out on you.


Because the running of a vehicle is complicated, there are many more things that can cause a vehicle to stall. These are the most common things that can cause a car to stall. Other things include wiring, fuses, relays, other sensors not working properly or at all, a bad alternator or a bad battery, or an overheating problem, just to name a few.

Aug 27, 2009 | 2004 Toyota Camry

1 Answer

My 88 s10 cranks but unless i pump gas pedle it shuts off. changed fuel filter and throtle body sensor still wont idle .press gas pedle it stalls out must pump pedle to keep it running


what engine does it have? 2.8 ? if so replce pick up coil in distributor /4.3 and 2.5 will do this also it affects pulse to injectors and on time firing

Jun 30, 2009 | 1988 Chevrolet S-10

3 Answers

Engine stalls when slowing down


I'm had a similar problem with my Caravan this past October. Ask your mechanic to check the fuel pump and oxygen sensor. There was a recall on Airtex fuel pumps in 24,000 2000 Caravans in 2006, so might want to see if it was one of the affected pumps and it can be replaced for free. Good luck!

Nov 25, 2008 | 2000 Dodge Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...