Question about Mercury Sable

Open Question

Powertrain malfunction Sometimes when I put My car in gear to drive it does This hard ****. This been happening off and on but today This light came on with ridges around and a exclamation signal in the middle. What is My car problem?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
ddismuke04
  • 2 Answers

SOURCE: I also started getting a warning light today 'powertrain malfunction' on my 2002 Jaguar x-type

You might have to change the shift cable. I had the problem last year (2007), worked perfectly after that......:)

Posted on Oct 04, 2008

Ad
  • 345 Answers

SOURCE: light on dash with triangle and exclamation in middle with

traction control light,get it put on a computer it will tell you what part has failed..

Posted on Dec 06, 2008

  • 434 Answers

SOURCE: 2005 chevy silverado 1500, service 4 wheel drive, gears

Sounds like a bent fork in the transfer case. It is a common problem with your truck. The transfer case is a np236. If it just recently started doing this, the rebuild will cost around $800. If the 4wd has been acting up for a while, the planetary will probably need changed, which is another $200.

Posted on Jun 28, 2009

  • 11 Answers

SOURCE: Mazda 626 - Hard to shift into gear.

With any vehicle that has a hydraulic clutch, a worn master cylinder or slave cylinder will give this very symptom. First step is to check the fluid in the resivor. If it is low, you will want to check for fluid bypassing the seals. Be sure to check under the rubber dust cover as fluid can collect there and not be readily visible. Also, if the fluid in the resivor is dark colored, it is an indication of the internal seals going bad and you will need to replace the cylinders.

Posted on Aug 17, 2009

  • 60 Answers

SOURCE: 2004 honda accord engine light on and jerking

Sounds like the EGR Valve, Get the check engine light checked at your local garage or autozone or advance auto.

Posted on Aug 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 wrench light is on


Powertrain Malfunction (Wrench) Warning Indicator (base instrument cluster)
The instrument cluster receives the powertrain status from the PCM over the high speed CAN. When a powertrain system concern is detected, the PCM sends the instrument cluster a command signal to illuminate the powertrain malfunction (wrench) warning indicator. If the 4WD control module detects a failure with the 4WD drive system, the 4WD control module sends a message to the instrument cluster over the CAN to illuminate the powertrain malfunction (wrench) warning indicator. On 4.6L engines, if the transmission control module (TCM) detects a failure with the transmission, the TCM sends a message to the instrument cluster over the CAN to illuminate the powertrain malfunction (wrench) warning indicator.
better have it checked !
Bett

Sep 10, 2016 | 2006 Mercury Mountaineer AWD

1 Answer

1999 ford tauras , engine races when i was driving it. didnt really pick up speed , just sounded like it


It sounds as if your automatic transmission clutch pack is slipping. You could try changing transmission fluid, but sometimes that may make it worse. You're likely in line for a new transmission. It will continue to get worse until your car will not go at all, or it may only be worse in certain gears, depending on which clutch disk is slipping.

Jan 22, 2014 | Ford Taurus Cars & Trucks

1 Answer

Gear shift seems broke, it won't go into any gear i have a 2005 chevy uplander just happened today with no warning went to reverse, tried to put into drive and there was nothing it just looks broke.


Check linkage at transmission. Cable end may have popped off ball fitting. Just snap it back on .it will pop off sometimes if you shift it hard . Hope this helps

Oct 13, 2013 | 2005 Chevrolet Uplander

1 Answer

I have a 02 Cavalier that when your driving the Trac off light comes on when the light is on it runs rough and shifts hard but if i put it in park turn it off and restart it it's fine


There is a malfunction in you antilock brake/traction control system. When the TRAC light is on, the computer is trying to tell you either 1. That the traction control is active and is controlling your brakes, engine and transmission to stop a wheel skid, or 2. There is is a malfunction in your traction control system.

In the first case above, the TRAC light will only be on for a few seconds until the conditions causing your wheels to slip no longer exist. If the light is staying on even though there is no way your wheels are slipping or skidding, then this is a malfunction. You must scan both your Powertrain Control Module (PCM) and your Antilock Brake System (ABS) module to properly diagnose a problem with this system.

Jul 16, 2011 | 2002 Chevrolet Cavalier Coupe

1 Answer

Check engine light came on today honda accord v6 2003 at 97k miles. car makes a thump sound when put into reverse hot or cold. sometimes when i turn and accelerate i can reproduce this feeling moving...


Take your car to a mechanic or your local auto parts superstore and have them read/scan the codes for the reason for the check engine light. A good place to start.

Apr 01, 2010 | 2003 Honda Accord

1 Answer

I went to start my car today. The car started fine, but then a light saying "airbag fault" came on. I went to put the car in reverse and back out of my driveway, and the gear shifter would not move. But it...


Hi,

The Airbag and Transmission circuits are independent of each other.

There is a possibility of a computer malfunction, but this can only be determined by taking the vehicle to your nearest VW Dealership, and have the workshop scan your computer for Fault codes.

This will identify the problem immediately...


Hope this helps....

Nov 12, 2009 | 2003 Volkswagen Passat

1 Answer

I also started getting a warning light today 'powertrain malfunction' on my 2002 Jaguar x-type


You might have to change the shift cable. I had the problem last year (2007), worked perfectly after that......:)

Oct 03, 2008 | 2002 Jaguar X-Type

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

fordexpert

Level 3 Expert

5546 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...