Question about 2001 Chevrolet S-10

2 Answers

2001 Will crank but wont start

just bought this truck and it turns over....but wont start.....has good bat. has started every time till now.

Posted by on

  • jgwesterhold Jun 20, 2009

    Still stumped....I tried to start my truck three days in a row before I started looking for the problem, on the 4th day it started up and and has been fine since. If it is the fuel pump or relay would'nt it go out and not "fix its self"? Or was it not putting out enough pressure for a couple of days and then come back up?

×

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 29 Answers

Hi , these trucks are notorious for fuel pump issuse. (I have 2 in the shop now).First check for spark if spark is present then we need to check for fuel.if a presure gauge is avail,install the gauge and crank the engine.if presure increases to 50-60 psi fuek is probably not the issue. now if a gauge is not avail you can remove the air cleaner/snorkle assy.spray some carb cleaner in the throttle body,then try to start if (if it starts for a second the problem if fuel.now if it starts go under by the fuel tank,reach up (from the drivers side and unplug the fuel pump plug (4 wire) have some one crank the engine ande check for battery power on gray wire durring cranking,if battery power is present check black wire for good ground.if both power and grounds are present pump is no good.if now power then swap the fuel pump relay w/ same design relay (in the underhood relay center) relays are also a known issue w. the s and t trucks,good luck Thanks

Posted on Jun 18, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 52 Answers

Crack open one of the fuel injector lines, see if you have pressure, if not you have a fuel problem. Check the fuse, relay and finally the fuel pump. If it has fuel, pull a plug wire, see if ya got spark, if ya dont it's probably the module

Posted on Jun 18, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 2001 tundra turns over and everything works but wont start has half tank gas


If it has known good spark and fuel pressure try spraying carb cleaner in the throttle body while cranking engine to see if it will crank.

Sep 10, 2015 | 2001 Toyota Tundra

1 Answer

2001 Buick LeSabre wont start again for at least an hour after turning it off


When you say won't start.... Do you mean no crank or crank and not start?

May 30, 2015 | 2001 Buick LeSabre

1 Answer

Cranks but wont start


wiring is probably shot in it,buy a used column from a junk yard,they are around $75.00

Jan 15, 2013 | Cars & Trucks

1 Answer

2001 oldsmobile aurora cranks but wont start


Yes your brother is partially right. the code says that it is the sensor circuit. so test the sensor and the wires. Does it seem to turn over faster than usual? if so your suspicions would also be correct (timing belt).

Aug 07, 2012 | 2001 Oldsmobile Aurora

1 Answer

Will not turn over with new batterie


check battery voatage with a volt meter. After verifying 12v or better at starter, check power at starter cable terminal and verify ground at block is good. Then put volt meter across both battery terminals and try to start car. If battery voltage shows 9.5 or less while attempting to crank, change starter.
(make sure that there is 12v at the starter trigger wire with key in "start" before replacng)
(By battery "hot" you mean it's charged, not getting hot, correct?)

Apr 30, 2009 | 2004 Jeep Liberty

1 Answer

Resseting alarm lockout in 2001 Pontiac Sunfire


turning left and stalling sounds like your power steering pressure switch is bad.as for other problem try unlocking drivers door using the key this should reset the factory alarm. also make sure you didn't miss a wire when reconnecting bat. look for 12gauge red wire near bat. this goes to computer if not connected car will crank but not start.

Jul 21, 2008 | 2001 Pontiac Sunfire

2 Answers

2001 Jeep Gand Cherokee wont start on first try


i have a jeep grandcherokee 2001 in africa. had ecu problem. sent the part to use for repaired and the part was returned and no fault is found. engine is turning but car wont still start. I now bought the crampshaft sensor and relays. can you please suggest what other problems the car might have? Is there a any main jeep dealer in senegal? West africa.

email: osy@talk21.com.

Jul 20, 2008 | 2001 Jeep Grand Cherokee

Not finding what you are looking for?
2001 Chevrolet S-10 Logo

342 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...