Question about 1994 Geo Prizm

1 Answer

No brake lights geo prizm - 1994 Geo Prizm

Posted by Anonymous on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 19 Answers

If your instrument panel light isnt working when headlights are on it will be the fuse. I accidentaly shorted when fixing my cigarette lighter and this happened to me. The fusebox is located just behind the battery on the drivers side just under the hood. There are usualy a couple of spares there and a diagram under the lid of the fusebox. Hope this helps.

Posted on Sep 06, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
bryant329
  • 125 Answers

SOURCE: 1996 geo prizm

you'll have to pull off the interior panel. window in the up position. on the lock cylinder there is a clip that you have to pull off and an arm that actuates the lock. pop the lock out. reverse to install.

Posted on Sep 22, 2008

  • 142 Answers

SOURCE: 1994 GEO Prizm Fuel Guage

You need to replace your fuel sending unit. It is located inside of the gas tank.
Please remember to rate this solution.

Posted on Feb 12, 2009

  • 1 Answer

SOURCE: Geo Prizm brake lights

I had the same problem, what I did to fix it was as follows:

  • Removed the plastic light holders from the tail lamp.
  • On each of the three bulbs there is a ground wire that is attached to the plastic light holder via a screw. Remove these connections and clean, I used some very light sand paper.
  • Reassemble, Worked like a Charm for me, and I save a $90 charge from Firestone by doing it myself...

Posted on Apr 13, 2009

Molson02536
  • 3854 Answers

SOURCE: geo prizm stereo radio wiring diagram

1994 Geo Car Stereo Wiring Schematic
Car Radio Battery Constant 12v+ Wire: White
Car Radio Accessory Switched 12v+ Wire: White/Black
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Red/Yellow
Car Stereo Dimmer Wire: Red/Green
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): White
Left Front Speaker Negative Wire (-): Black/Blue
Right Front Speaker Positive Wire (+): Blue
Right Front Speaker Negative Wire (-): White/Red
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Light Green
Left Rear Speaker Negative Wire (-): Light Green/Black
Right Rear Speaker Positive Wire (+): Gray
Right Rear Speaker Negative Wire (-): Gray/Black

Posted on Dec 23, 2009

no_signal_sw
  • 273 Answers

SOURCE: 1991 geo prizm, battery light

Yes, it could be. Or you can check your battery. And try adding brake fluid to your master cylinder. That sometimes will cause the brake light to come on. Or check your emergency brake. Hope this helps, James Booth.

Posted on May 17, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The interior brake light on my console is illuminated.


The brake warning light tells the driver the parking brake is on, or the fluid in the hydraulic system is low.
If the parking brake is not on, and the fluid level is ok, it could be the parking brake switch or the fluid level sensor.

Jan 28, 2013 | 1996 Geo Prizm

1 Answer

My 1990 geo prizm brake light comes on when I start to stop and turns off when I stop


You need to replace the brake light switch, it is located above the brake pedal and is actuated by the brake pedal arm.

Jun 12, 2012 | 1990 Geo Prizm

3 Answers

1990 geo prizm brake lights only work when car is off


in front were the brake is try to c if there is a guage like a small little wire

Nov 16, 2011 | 1990 Geo Prizm

1 Answer

1991 geo prizm, battery light and brake light in the dash stay lit when you start the car. The car still runs fine just the dash warning lights stay on. The alternator was replaced maybe three years ago,...


Yes, it could be. Or you can check your battery. And try adding brake fluid to your master cylinder. That sometimes will cause the brake light to come on. Or check your emergency brake. Hope this helps, James Booth.

May 17, 2011 | 1991 Geo Prizm

1 Answer

1995 geo prizm ebrake light is on. Is this a faulty sensor? I heard it could have an brake indicator wire that makes contact with to let you know youre pads need to be changed.


Your brake pads don't have any kind of wire going to your brake pads that will make the brake light come on, check your master cylinder for low on brake fluid, if low look in back of tire's for wetness, if none, top of master cylinder with DOT 3 brake fluid, and have your brake pads checked for wear.

Dec 09, 2010 | 1995 Geo Prizm

2 Answers

Where is the brake switch located on a 1990 geo prizm?


Brake Light Switch The brake light switch is located at the top of the pedal arm. It is the switch which turns the brake lights on when the brakes are applied. The plunger type switch is held in the off position by the normal position of the brake pedal; when the pedal moves during brake application, the switch plunger moves forward and the brake lights are brought on. The switch is almost always the first place to look for the cause of the brake lights flickering over bumps or staying on without use of the brakes. If the brake lights fail to work with the brakes applied, check the fuse first and then check the switch.

Oct 27, 2010 | 1990 Geo Prizm

1 Answer

My brake lights won,t go on in my 1993 geo prism


I would check the brake light fuse and the brake light switch under the dash on the brake pedal lever. And, of course, check the bulbs themselves.

Oct 19, 2010 | 1993 Geo Prizm

1 Answer

Brake lights


replace th brake light switch

Apr 19, 2009 | 2001 Chevrolet Prizm

1 Answer

Brake lights


The brake lite switch is most likely stuck on, it is on the arm that goes to the brake pedal, it will have at least 2 wires in the connector to the switch.

Jul 31, 2008 | 1993 Geo Prizm

Not finding what you are looking for?
1994 Geo Prizm Logo

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...