Question about 2005 Toyota 4-Runner SR5

Open Question

How do you replace the rear speed sensors - 2005 Toyota 4-Runner SR5

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What are the probable causes of DTCs C0222, C0226, and C0237?


Brent, Check and clean connections(use electronic contact cleaner), make sure wires are not damaged. Check grounds from EBCM controller. Check links below and don't be afraid to google search for more info.
C 0222 Missing Right Front Speed Signal
C 0226 Missing Left Front Speed Signal
- Faulty Right/Left Front Speed Sensor
- Right/ Left Front Speed Sensor harness is open or shorted
- Right/ Left Front Speed Sensor circuit poor electrical connection
- Faulty EBCM

C 0237 Erratic rear speed signal
- Faulty Rear Speed Sensor
- Rear Speed Sensor harness is open or shorted
- Rear Speed Sensor circuit poor electrical connection
- Faulty EBCM


How fixed Chevy with an Abs and Brake light on

https://www.google.ca/url?sa=t&rct=j&q=&esrc=s&source=web&cd=3&cad=rja&uact=8&ved=0ahUKEwi0i8zz5YzLAhWD74MKHffwDLQQtwIIITAC&url=https%3A%2F%2Fwww.youtube.com%2Fwatch%3Fv%3DR_5WZUebDx8&usg=AFQjCNHimqe_Fje8AySjD5N0Wh8z8dQuuw

How To Install Replace Front ABS Sensor and Harness 2000 06 Chevy Suburban...

Feb 23, 2016 | 2003 Chevrolet Tahoe

1 Answer

1995 dodge 4x4 1500 ram speedometer quit working , won't go into overdrive , the 4 wheel drive will not en gauge , I have replace the speed sensor on the rear end and replace the speed sensor on the t


The sensor in the differential is for the ABS. Did you replace the sensor for the speedometer in the end of the transmission?
And is the check engine light on ?

Jul 04, 2013 | Cars & Trucks

1 Answer

Replace the rear speed sensor 2005 chevy silverado


For complete procedure to replace rear speed sensor,click the link below and follow the procedure:---
http://repairhelpcenter.blogspot.com/2012/11/chevy-silverado-rear-speed-sensor.html
----------
Thanks.

Nov 06, 2012 | Cars & Trucks

1 Answer

I have a 1999 dodge ram 2500 with a diesel. i changed both speed sensors and my speedo dont work and my abs, light and brake light is on as well, when they run a code scanned no codes come up for the


NO code ? the first thing is to make sure all the fuse are good, the next thing is to connect a scan tool and check for readings to speed sensors.

Some of these use the wheel speed sensors to control the speedo and abs , the speed sensors in the transmission are used to control gear shifting, make sure the wheel sensors are working, the most common problems are the wiring to the rear sensor and the rear sensor itself, check on the rear end on the top and make sure connection is good and maybe replace that sensor and see what happens, i have run into this problem a few time but some were diffrent. one was a bad rear speed sensor another one was the cluster and the last was the abs module.

I would start with checking all the fuses first, then move on to replacing the rear speed sensor located on the rear top of the diffrential . good day.

May 19, 2012 | Cars & Trucks

1 Answer

1999 dodge ram van speed sensor wiring diagram. I put a new sensor in and it still doesn't work is there a fuse or something else I'm missing


ive run into this a few times, its a bad cluster or if theres a speed sensor on the rear diff then replace that also and see if that works. i had a few of these with the same problem and replace speed sensor in the trany and still no speedo and then replaced the rear diff sensor for abs on the top of the rear diff and that solved the problem.

Jun 15, 2011 | 1999 Dodge Ram

1 Answer

2002 jeep liberty sport my speed sensor went so i changed both and the computer says its still the speed sensor whats wrong...


I assume you replaced the input and output speed sensors on the transmission?

The speed sensor for the speedo is located in the rear differential. Look on top of the center of the rear differential and you should see a sensor bolted to it with two wires. Check the wiring harness to the sensor. Sometimes they rub through on the E-brake cables. If the wiring is good replace the sensor in the rear differential.

Mar 30, 2011 | 2002 Jeep Liberty

2 Answers

1999 Chevy Tahoe 4dr 4wd. Brake light comes on when pedal is slightly pressed then off again when pressed in more then on again when fully pressed.. Has a new switch and the problem occured before a new...


Hi


To start with check the Speed Sensor on the front and rear. Usually the issue is with the rear speed sensor which can be replaced easily and will cost you around $25-$40.
There is a sensor at the top of the rear differential for the ABS system. When the ABS sensor on the diff goes bad the Speedo no longer will work, the odometer stops recording mileage and both brake and ABS light comes on. You also loose O/D or "Lock-up" in the torque converter. The sensor is inexpensive and can be changed in about 30 mins.
Replace rear differential speed sensor as follows:
a) Remove parking brake cable bracket (1/2" socket)
b) Remove speed sensor bolt (9/16" deep socket)
c) Remove metal speed sensor cover
d) Remove speed sensor from rear differential housing (use channel lock pliers, twist gently back and forth while applying upward pressure. Once the speed sensor has a small gap between it and the rear differential housing, insert a flat-blade screwdriver and gently apply upward pressure while gently twisting speed sensor back and forth.
e) Disconnect speed sensor from speed sensor cable
f) Lubricate new sensor with WD-40, insert into rear differential housing. It will NOT go in all the way by hand, so do NOT force it nor hit it with anything made out of metal.
g) Replace metal speed sensor cover
h) Insert speed sensor bolt and tighten LIGHTLY until a small amount of pressure is felt. Tap speed sensor with rubber hammer until it pops into housing. Finish tightening of speed sensor bolt.
i) Replace brake cable bracket, replace 1/2" nut and tighten
j) Disconnect positive battery cable for 2 minutes, reconnect positive battery cable

Please do accept the solution if the issue is resolved or else revert for further assistance.


Thanks
Rylee

Jan 21, 2010 | Chevrolet Tahoe Cars & Trucks

4 Answers

Abs light and brake light came on wont turn back off


There is a sensor at the top of the rear differential for the ABS system. That sensor went bad and replacing it took care of the problem. What caused mine to go bad was apperantly water got into the differential when launching and loading my boat. check to see if gear lube needs to be replaced also.
The answer above is perfectly correct. When the ABS sensor on the diff goes bad the speedo no longer will work, the odometer stops recording mileage and both brake and ABS light comes on. You also loose O/D or "Lock-up" in the torque converter. The sensor is inexpensive and can be changed in about 30 mins. Good Luck!
I second the second answer :) My ABS light was on, my BRAKE light was on, my CHECK ENGINE light was on, my SPEEDOMETER wouldn't work below 35 mph, then quit working alltogether. Once the speedomenter quit working the odometer and cruise control quit working. I replaced the rear differential mounted speed sensor ($33) and then reset the CHECK ENGINE light by disconnecting the positive battery cable for a couple of minutes. EVERYTHING then worked.
Replace rear differential speed sensor as follows:
a) remove parking brake cable bracket (1/2" socket)
b) remove speed sensor bolt (9/16" deep socket)
c) remove metal speed sensor cover
d) remove speed sensor from rear differential housing (use channel lock pliers, twist gently back and forth while applying upward pressure. Once the speed sensor has a small gap between it and the rear differential housing, insert a flat-blade screwdriver and gently apply upward pressure while gently twisting speed sensor back and forth.
e) disconnect speed sensor from speed sensor cable
f) lubricate new sensor with WD-40, insert into rear differential housing. It will NOT go in all the way by hand, so do NOT force it nor hit it with anything made out of metal.
g) replace metal speed sensor cover
h) Insert speed sensor bolt and tighten LIGHTLY until a small amout of pressure is felt. Tap speed sensor with rubber hammer until it pops into housing. Finish tightening of speed sensor bolt.
i) replace brake cable bracket, replace 1/2" nut and tighten
j) disconnect positive battery cable for 2 minutes, reconnect positive battery cable
h) start vehicle, enjoy,

Oct 21, 2009 | 1998 Dodge Ram 1500 4WD

2 Answers

How do I replace the right rear wheel ABS speed sensor on an 05 Toyota Tacoma 4WD ?


REPLACEMENT

HINT: The replacement procedures for the RH side are the same as those for the LH side.

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  2. REMOVE SPEED SENSOR REAR LH
      1. Disconnect the speed sensor connector.
      2. Remove the nut and speed sensor rear. NOTICE:
      • Do not attach any foreign matter to the sensor tip.
      • Ensure that no foreign matter enters the sensor installation hole.
    1. INSTALL SPEED SENSOR REAR LH
      1. Install the rear speed sensor with the nut. Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.) NOTICE: Make sure that the sensor tip is clean.
      2. Connect the speed sensor connector.
    1. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL Torque: 3.9 Nm (40 kgf-cm, 35 inch lbs.)
    2. CHECK ABS SENSOR SIGNAL
d807a26.gif

Sep 26, 2009 | 2005 Toyota Tacoma

2 Answers

Where wheel speed sensor is located on 2001 pontiac grand am se


2001 Pontiac Grand Am 2.4L SFI DOHC 4cyl

Vehicle Speed Sensor - Location:
The speed sensors are built right into the wheel bearings of your vehicle, at the front and rear locations. They work both with the anti-lock brakes and with the traction control systems on the vehicle.

Removal & Installation
Front
The front wheel speed sensor is part of the hub/bearing assembly. Refer to Wheel Hub and Bearing Replacement in Front Suspension for service procedures.
Rear
The rear wheel speed sensor is part of the hub/bearing assembly. Refer to Wheel Hub and Bearing Replacement in Rear Suspension for service procedures.

I hope help you with this (remember rated this help) Have a nice day, good luck.

Sep 23, 2009 | 2001 Pontiac Grand Am SE

Not finding what you are looking for?
2005 Toyota 4-Runner SR5 Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...