Question about 1998 Toyota Corolla

1 Answer

Corolla cruise control not turning on

Switch won't turn it on, fuse is good. What to check first?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 3 Answers

There should be a sensor near the brake pedal. When you press the brake the cruise turns off.

Do you get the light in the dash?

Posted on Sep 26, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
darkoh69
  • 77 Answers

SOURCE: brake lites out, turn signal and rear lites ok fuses good bulbs fine

its down near the pedal I think. Put your ear down near the pedal & push the pedal down with your hand, You should be able to here the switch/button clicking

Posted on May 10, 2009

  • 18 Answers

SOURCE: my cruise control will suddenly stop working and the cruise light

I had a similar problem and it turned out to be the brake fluid level. This may be an answer. Also have you had the brakes checked. The cruise control is integrated with the brakes. Any little thing wrong with them effects the cruise.

Posted on Oct 03, 2009

  • 26 Answers

SOURCE: cruise control problem

There are 3 places on the Rav4 where fuses can be located and checked. for the cuise control.

The back of the cruise control stacking switch has been know to fail (fall apart) and Toyota issued a TSB with replacement switch.

if it is the fuses then they most likely are related to cruise control system: Stop, Dome, Gauge and Igniton
The interior fuse box
The main engine fuse box (by brake fluid)
Cruise control ECU is under the glovebox.
Cruise control actuator is under hood (by driver side brake fluid/booster)Throttle position sensor (to detect if your foot is on gas pedal)
Cruise control switch on the clutch pedal too (if you have 5spd manual)
Brake lights are the deactivate signal for the cruise control


Posted on Oct 03, 2009

roniecon
  • 6826 Answers

SOURCE: 1986 Toyota Pickup Instrument lights and tail lights out

Even though the relay is activated,I assumed you checked the out put?Also,You checked the voltage at the light sockets?With a meter,or test light ,check the fuse for the cluster lps,adjust them to dim,and to bright,the meter should act accordingly on the fuse.If it does not,replace the dimmer control,or head light switch,witch ever controls them.This may allow continuity to the tail lights as well.If the fuse is dead for the cluster lights,replacing the dimmer control,or head light switch will solve the problem,or,from another fuse ,supply voltage to the cluster lp fuse,one that is only hot with the key on,cause if you do this the dash lights will come on,every time you run the vehicle,day,or night.

Posted on Dec 20, 2009

  • 1 Answer

SOURCE: 2001 Camry 2.2L Cruise control doesn't work

I had the same problem and trimmed the vacuum line ends to make a tight seal. I also had the trouble codes cleared. the problem has not come back yet.

Posted on Apr 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

CRUISE CONTROL WON'T WORK ON 2005 CHEVY TRAILBLAZER


check cruise control fuse and check the brake lights see if brake light working because the brake light switch will deactivate cruise control when brakes is applied.if brake lights dont work either fuse blowed or switch bad.if all is good have vechicle code scan because cruise control control by PCM and vechicle speed sensor and thottle actuator control motor.

Apr 17, 2013 | 2004 Chevrolet TrailBlazer

1 Answer

My 1999 Dodge Ram 1500 cruise control will not turn on. I've checked the fuses in the fuse box on the side of the dash but they were all good. Another issue i have occasionally is the brake light


Probably neither.
The brake light switch could knock out the cruise.
You might check the computer for trouble codes, but you'll probably need a shop manual to get the test procedures for the cruise control.

Oct 12, 2012 | Dodge Cars & Trucks

1 Answer

My headlights won't turn on, the yellow driving lights turn on but the headlamps won't. Also the lever that controls bright lights doesn't work but the turn signal and cruise control does.


First check the headlight relay by changing it with one of the same number in the fuse panel.If it checks out ok then you have a faulty headlight switch.

Nov 03, 2011 | 1994 Chevrolet Caprice Classic

1 Answer

Cruise control is out on my 09 silverado. small v-6. fuse is good. had throttle body replaced 3 months ago. 126k miles, i drive a lot. tried the top off the master cylinder trick. still won't work....


you could have a problem with the brake switch which de-activates the cruise when you push on the brake or a bad cruise switch or control module.have the cruise system checked out to find what is causing the problem first then go from there.

Sep 10, 2011 | 2009 Chevrolet Silverado 1500

1 Answer

My cruise control light does not turn on when I push the button. I am thinking it is a fuse but it is not labeled in the 2 fuse copartments. Can you please tell me which fuse is for the cruise control on...


Is your cruise control working? Check your brake lights and make sure that they are all working. If they aren't working your cruise control won't work that includes the light.

Sep 10, 2011 | 2000 Nissan Frontier

1 Answer

Same problem... No brake lights/cruise control of any kind.


Sounds like you brake lite switch is out of adjustment or a bad switch . most have a adjustment at the switch near the Brake pedal. Good Luck

Jul 09, 2009 | 2001 Porsche Boxster

2 Answers

1999 oldsmobile alero the traction and cruise not working


use a scanner to check the abs system . most of the time the abs brakes and traction control system work together. your cruise control . unit has a servo motor .in front right fender well. check the fuse and relay also the cruise control brake release switch. and the brake light switch.if all is good you have a cruise control module problems. dealer ship job.

Mar 31, 2009 | 1999 Oldsmobile Alero

1 Answer

2003 Denali Yukon, no Brake lights, no Cruise Control, fuse is OK


Check your brake light switch at the pedal. This controls the lights and disengages the cruise when stopping. I'd look there before I go anywhere else. There may just be a wire loose. Could be a simple fix.

Good Luck and hope this helps.

Mar 15, 2009 | 2002 GMC Yukon XL

1 Answer

Cruise control display


if you know where is the switch for it try to turn it off or read your owners manual

May 27, 2008 | 2005 Toyota Corolla

Not finding what you are looking for?
1998 Toyota Corolla Logo

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...