COMPUTER MODULE CaN NOT FIND IT

driver control module and its location ???? Never heard of a driver control module . Or do you mean driver seat module ?

these are the modules on that vehicle

Programmable Parameters Index Module Calibration Updatable PMI Programable Parameter Vehicle Security Module No Yes

• 4WD ESOF
• Remote Keyless Entry (RKE)
• Overspeed Warning
• Beltminder
• Transmission Type
• One Touch Down
• Delayed Accessory
• Vehicle Speed Conversion
• Heavy Truck Tachograph

Instrument CLuster No Yes

• Body Security Module Present
• Overspeed Warning
• Beltminder
• 4x4 Present
• Air Suspension Module Present
• Speedometer Bias
• Tire/Wheel Size

Anti-Lock Brake System (ABS) Module No Yes Tire/Wheel Size Overhead Trip Computer (OTC) No Yes

• Fuel Tank Size
• Dual Fuel Tank Configuration
• Dual Fuel Tank (Distance to Empty Display)
• EATC present

Restraints Control Module (RCM) No Yes

• With Driver Airbag and Pretensioner/Without Passenger Airbag and IPAD
• With Driver Airbag, Passenger Airbag, Pretensioner and IPAD
• With Driver Airbag, Passenger Airbag and Pretensioner/Without IPAD

Powertrain Control Module (PCM) Yes Yes

• Fuel Octane
• Tire/Wheel Size
• Axle Ratio
• Transmission Type
• 4x4 Present
• Manual Shift on the Fly

Configurable Modules - Excursion

• 4-wheel anti-lock brake (4WABS) control module (if equipped)
• vehicle security module
• overhead trip computer (OTC) (if equipped)
• 4-wheel drive control module
• driver seat module (DSM)
• instrument cluster

What about your ignition module? I can't tell if you just replaced coils or ignition module included? Also, before buying anything, check voltage and ground for ignition module. Pink wire is voltage, black wire is ground.

The crank sensor sends ac signal to ignition module, the module converts signal to dc, something the computer can handle, then sends rpm signal to computer.

Which one ? your vehicle has six different ones !
The scan tool accesses the following module data lines:
?€¢
The electronic brake control module (EBCM) (UART)

?€¢
The engine control module (ECM) (Keyword 2000)

?€¢
The transmission control module (TCM) (UART)

?€¢
The inflatable restraint sensing and diagnostic module (SDM) (UART)

?€¢
The immobilizer control module (UART)

?€¢
The anti-theft module (UART)

I small computer box that performs engine or transmission or accessory functions. for example: ecm electronic control module. or tcm transmission control module. or pcm powertrain control module. or lcm lighting control module.or bcm body control module

The fuse box with spare fuses, fuse removal tool and relays are located on the left wheel arch inside the engine compartment.

23 - 5 Amp Unloader Relay (K9), Rear Defogger Relay, Combination Switch, Climate Control System, Clock, Instrument Cluster, On-Board Computer

31 - 5 Amp Climate Control System, On-Board Computer, Instrument Cluster, Clock, Chime Module, On-Board Display

45 - 7.5 Amp Wiper Relay, Wiper Motor Relay, Clock, On-Board Computer, On-Board Display Check Control Module

iIn the glove box

on-board computer 23 45 (10-93 to 09-95)

on-board computer 23 45 (10-95 to 09-96)

on-board computer module, center console

There are several computer modules involved in your antitheft and security system.
There is the Driver's door module, the right front door module, the right rear door module, the left rear door module, the dash integration unit, the rear integration unit, the instrument panel cluster, the theft deterrent module, the theft deterrent exciter module, the body control module and the powertrain control module. These are all networked together to form the perimeter security and anti-theft system.

Any problems you may be having with this system should be properly diagnosed. Diagnosis of this system must BEGIN with a complete scan of the onboard computer network so that fault codes can be retrieved. and the computer data checked and verified. This is the only way to correctly determine which part of the system is malfunctioning.

Wiring schematics are not designed to give you the location of these components. They only show the wiring connections that are made between them.

What exactly are you trying to fix?

This sounds like a bad computer, if your sure the coilpacks are good and you replaced the module and the new module is good and the wiring to the module is good then i would say the wiring to computer or bad computer, this module and coils are hidden in the rear of the motor and go bad often but if say there all good then my next step would be the computer,

The code 1698 is no communication from tcm (trany control module), this may be cause by a bad trany module computer or wiring to computer, more testing would need to be done before calling module bad,

It is called the transfer case control module, a dealer only part.

hello jaronricky , the Powertrain Control Module (PCM) is located right next to the power brake booster . 2000 crown vic