Question about 2004 Lexus RX 330
VSC PLUS TRC OFF AND ENGINE CHECK LIGHT ON WHILST MOVING
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
My car (06 GS430) began giving me more frequent "Check VSC" warnings. (Code P0455 in my case. Really glad I bought that OBDII tool--resetting the codes is a snap!)
I knew that a loose gas cap could cause this, so normally I just give it a twist and it tightens. Now I found that no matter how many "clicks" I tightened the gas cap, it would not cinch down snug. The lightest turn the opposite way would open it.
I was all set to head over to CarQuest for a replacement filler cap. But I thought I'd inspect mine first just to see why it stopped holding. Upon inspection, I saw that what holds the cap in place is compression of the rubber O-ring at the back of the cap, which compresses against the filler neck. That apparently was no longer happening.
I carefully removed the O-ring from the cap--using screwdrivers to lift it over the edge of the groove it sits in. Like removing a bike tire from the rim--work your way around. Then I cut a strip of electrical tape about 10" long, and 1/4" wide. I wound this into the curved groove where the O-ring normally sits, just to build up a little thickness. Put the O-ring back in place. Done.
Now the cap tightens like it's supposed to, and thus far, it has stopped the VSC error codes. Don't know if it will fix your issue or not, Good luck.
Posted on May 09, 2009
First check and make sure your gas cap is tight, if this does not resolve the problem read below.
A vacuum hose has become disconnected, more than likely due to having your air filter replaced. The VSC and Check engine light typically don't come on until after 150-200 miles after the vacuum hose was pulled out.
The fix: on the right-hand-side of the engine compartment behind the big plastic housing that holds the air filter you will find a black rubber hose that is not connected to anything. Squeeze the finger clamp on the hose and slide the hose back onto the half inch nipple on the back of the air filter's plastic housing.
In order for the VSC and Check engine light to be turned off, you will need to open the fuse box, right-side of the engine compartment, and pull the 20 amp EFI fuse for 10 seconds. This will reset the system. The fuse location is marked on the lid of the fuse box, also I believe the EFI fuse is the only 20 amp fuse
. This will help. Thanks, please keep updated. please do rate the solution positively .thank you for using fixya
Posted on Dec 29, 2009
I have a a 99 gs 300, check engine light is on as well as the vsc light. What is that and needs to be to done to fix it.
Posted on Nov 02, 2010
Tips for a great answer:
Nov 25, 2015 | Toyota Cars & Trucks
Nov 21, 2014 | Cars & Trucks
Apr 24, 2014 | 2007 Chrysler Town & Country LX New Cars
Apr 11, 2014 | 2005 Toyota Avensis 2.0
Feb 28, 2013 | Cars & Trucks
Dec 14, 2012 | 2001 Toyota 4Runner
Feb 27, 2010 | 2000 Toyota Land Cruiser
Jul 22, 2009 | 2003 Toyota Corolla
Jul 09, 2009 | 2004 Toyota Corolla
404 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: