Question about 2006 Hummer H3
Smells like gas after i drive and park it
Posted by Anonymous on
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I brought my 2006 H3 in to the dealer for the same thing. My blower stopped working all together but it started as an intermittent problem. He said he had to replaced a diode or resistor either behind the switch on the dash that controls the fan or on the fan motor itself. Have not had a problem since but that was only about 4 months ago.
Posted on Apr 09, 2009
SOURCE: My 2006 Hummer H3 is
It doesn't take long to learn when and how to use your
truck's 4WD system. Follow these steps and you'll feel confident about
engaging the system the next time you need to get out of a slippery
For a conventional system, where you can select 2WD or 4WD, the instructions refer to engaging 4WD. For trucks with permanent 4WD, they refer to locking the center differential.
Time Required: varies
Good luck and remember to rate this solution.
Thanks for using Fixya.
Posted on Mar 07, 2010
SOURCE: 2006 H3 Hummer fan problem
Hi if your internal fan not work in any position well i fixed up myself easy and save your money.
locate the fan motor air just outside right courtesy drawn document in front of passenger. go from down and look up you will see a motor with a big connector white with 2 screw secure inside the motor block. loose the two screws and pull out gently the connector from motor fan block. you will see a green multiresistor connected with this big connector. Usually the first + voltage connector is burnet out. disconnect the connector pull from resistor and check for any burn. in my case the first pin was burned out completely
you can buy another connector or you can clean the burned connector take out form connector weld a small copper cable of 5 mm dia from resistor to the burn cable and reconnect the connector without buy a new one. after replace again the resistor in the hole of motor blow with the 2 screw.
Done all work again without buy another new connector.
Gabriel from Italy Turin
H3 hummer 2007
loveling one and Humvee owner
Posted on Jun 11, 2010
Tips for a great answer:
Dec 06, 2016 | Hummer Cars & Trucks
Jan 01, 2016 | 2006 Hummer H3
Feb 27, 2015 | 2006 Hummer H3 SUV
Jan 31, 2011 | 2009 Hummer H3
Jul 15, 2010 | 2006 Hummer H3
Feb 18, 2010 | 2006 Hummer H3
Jul 19, 2009 | 2006 Hummer H3
83 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: