Question about 1994 Jeep Cherokee Country

1 Answer

Brakebackligts doesnt funk - 1994 Jeep Cherokee Country

Posted by on

  • yadayada
    yadayada May 11, 2010

    funk????

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

Try writing this in a language us aliens can read!!! I'm in the USA and proud of it!!!

Posted on Jun 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Hi I have Isuzu big horn 96 and it started to run rough like it was starting to miss and is hard to start some times is it to do with air


First off, I'd make sure the air filter is clean. If that doesn't work, try running some high octane through it, too low an octane will make the engine knock and ping and run roughly, ( or use Methyl Hydrate) that;s what's in gas line antifreeze, just boosts the octane and cleans fuel injectors. There's a few cheap ways to rule out to the expensive ones. If those fail, you could try doing a rad flush, problems with the cooling system can have strange effects, Gunk makes a good Rad Flush. I hope it's one of the simple cheap repairs, good luck, Grim

Aug 19, 2015 | Isuzu Cars & Trucks

1 Answer

My truck wont turn over and my starter i had that all checked fuse been checked


Make and model?! It helps. Not everything is alike.

I just had same problem on another car (Jeep) Despite me getting a new battery it turned out to be SURPRISE! the battery.
Take and get battery checked. Its amazing how often they are the culprits even when you're convinced they aren't.

But... the ignition rod sounds like its funked up.
Try here.

Steering Column Stuck in park Ign rod problem Ford Truck Enthusiasts Forums

Feb 11, 2015 | Cars & Trucks

1 Answer

Gmc jimmy 1998 starting problem?


Most likely the antitheft. This link explains.

http://vatspasslockpasskeysecurityhelp.yolasite.com/

Apr 10, 2012 | GMC Jimmy Cars & Trucks

1 Answer

I have a 1991 Honda accord ex..it has been sitting for years now it wont start where should I start I was told that the gas turns to funk after sitting for a long time.


if it is posible for you to drain the the old gasoline out and refill the tank with fresh gasoline that would be great, but if you only have a1/4 tank and draining the tank is not posible fill your tank up with supreme gas not regular the better grade gas with the high octane will dilute the old gas and help burn off the gas when the car starts.if you have more then 1/2 a tank try to pump out the gas with a driil pump, you can buy these a your local hardware store insert hose in filler neck of the tank.you should also remove the spark plugs and with and oil can add 8 good pumps of the can of motor oil in the cylinders do not replace plugs **** with a freshly charged battery turn the engine over few time in 2 or 3 second intervals this will kleen any rust that would have built up on the cylinder walls and also lube up the cylinder wall so that at start up the cylinder wont be dry ,add a few more sqirts of oil between turnovers.Replace spark plug if old ones look bad put spark plug in and start her up its going to smoke a bit at firts **** it will stop after the oil that was put in the cylinders burns off,let the engine idle for 10-15 minutes before putting any strain on motor give it a chance to clean out cylinders burn a few tanks of gas and change gas filter it should be fine.

Apr 04, 2011 | 1991 Honda Accord

2 Answers

Heard a grinding noise from back end, brakes were super hot. when got it home to look at it after removing lug nuts can't get back wheels off. Tried banging rim with a 2lb sled to free up any rust/funk...


soak in oil for a couple of days then place a wooden block against wheel rim and hit with 7kg lump hammer ,but you must soak it first around the back of the hub and then it will move ,and engine oil with some diesel in it not that silly spray stuff

Oct 22, 2010 | 1995 Subaru Legacy

2 Answers

The small storage compartment in the back of my 2007 2-door jeep wrangler Rubicon is wet, soaked with water. Where is it coming from?


If your Jeep has a soft top -

I have a 2007 Unlimited and has the same problem. My Jeep is a soft top and the water came from the rain and a poor seal of the back window. Part of the problem came from the displacement of the plastic "c" shaped "rear window bar holder" that clips on to the rear on either side of rear window. Ocasionally the clip pops out of place and breaks the seal between the rubber on the window and the rear sides of the Jeep.

Jun 10, 2010 | 2007 Jeep Wrangler Unlimited Rubicon 2...

1 Answer

Four wheel drive doesnt engage


Sounds like you have a bad switch.

Apr 21, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

2001 mazda 626 rpm going up to 4 before going into 2nd gear


the transmission and filter need to be changed quickly, the oil is most likely burnt and/or the filter is covered with funk, once those are swapped then your ride should cruise just fine.

Aug 03, 2009 | 2001 Mazda 626

1 Answer

300zx erratic idle 1993 n/a


Your Idle Air Control Valve is at fault. These never set a code when they fail and they always fail.

Check this item out on eBay.

http://cgi.ebay.com/ebaymotors/nissan-300zx-OEM-idle-air-control-valve-IACV_W0QQcmdZViewItemQQ_trksidZp3286Q2em20Q2el1116QQhashZitem5189d6b9f7QQitemZ350204901879QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories

They aren't usually this expensive so search the net and you should find a much better deal.

You shouldn't need to worry about the gasket when replacing this. They usually don't tear and stick to the manifold. If it does tear though you should replace it

Aug 27, 2008 | 1993 Nissan 300ZX

Not finding what you are looking for?
1994 Jeep Cherokee Country Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...