Question about 1998 Oldsmobile Aurora

2 Answers

The blower works but there's no A/C

I had the compressor replaced by the dealer about three or four years ago...A/C worked fine until about a week ago, it just stopped working it will blow air, just not COLD air! What could've stopped it?

Posted by on

  • Israel Adame
    Israel Adame May 11, 2010

    Could be that the vehicle is low in freon. Have you had it checked?

×

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 290 Answers

Freon level may also be low. Once the level is low, a low pressure switch will open the circuit to prevent the compressor from running and burning up.

Posted on Jun 17, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Oldsmobile Master
  • 358 Answers

You need to have it checked for leak first of all.witch is the problem most of the time. if there are no leaks then you need to start checking for eletrical issues with the a/c system.

Posted on Jun 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

We have a propane tank outside to supply our range stove in the house for some reason the gas is not reaching the stove anymore , can it be the cold weather?


I would suspect the regulator might have iced and maybe if you poured hot water over it it would pass on thru system but be prepared to buy a new one if it doesn't .

Jan 13, 2015 | Cars & Trucks

1 Answer

2003 Toyota Corolla AC Blower/Fan will not turn on, I replaced the Blower/Fan a few weeks ago,


A/c compressor works fine and the blower motor works and shutdown right? it is the problem with the blower resistor or with blower motor relay. try to direct the resistor irrespective of the speed. hope the problem may be solved.

Jun 05, 2014 | 2003 Toyota Corolla

1 Answer

My 1995 gmc 1500 ext cab siarra 's ac stopped cooling, i put at least 2 1/5 cans in it about three weeks ago, it was running fine until a day ago, please tell me what is wrong, is it compreesor re


You have a leak,to see if you do,get a spray bottle,put soap water in it and spray all a.c.lines and see if it bubbles up any where.Look for usual stains at connections.

May 25, 2013 | 1995 GMC Sierra C1500

1 Answer

On my 1994 S-10 Blazer, the AC/Heater stopped blowing on high speed about 2 years ago. By switching the speed control quickly back and forth, sometimes High would work. But not anymore. I had the A/C...


Sometimes the electrical connecter burns on the back side of your switch. You can get just the switch and replace it and repair the connecter when possible.

Aug 12, 2010 | Chevrolet S 10 Cars & Trucks

1 Answer

1999 mercury cougar. 3 of my 4 blower settings for a/c stopped working 6 weeks ago and today the 4th went out. i had the blower test and is fine. I replaced the blower resistor and blower switch and still...


Make sure you contact a Mercury Dealer or Ford Dealer and run your vehicle ID number to see if it has a recall on the blower switch. I worked for Ford for years and I think I remember that vehicle having a blower switch and or relay recall. Some of these recalls did not expire and if that is the case it would not cost you anything to have this done. Good luck, hope this helped

Feb 06, 2010 | 1999 Mercury Cougar

2 Answers

AC blower won't come on


The problem is most likely the AC compressor clutch connector. It is a one pin connector. Located under the hood, near the clutch of the AC compressor. Clean this connector, make sure there is a good connection. I had the same problem and had to fix it myself. Works fine ever since.

Aug 11, 2009 | 2004 Kia Sorento

1 Answer

Fuel system


it may work again but that is only temporary it sounds like the fuel filter is clogging up

Feb 23, 2009 | 2000 Chevrolet Blazer

1 Answer

Piece of **** Jeep


Brakes are products that wear with time. Not avoidable.
Window motors or any other electrical item could stop working from the first day of replacement.
I don't remember any thermostat code working at the dealer.
I have been a Jeep person for 20 years. I love them.

Oct 23, 2008 | 2004 Jeep Grand Cherokee

1 Answer

93 Nissan sentra air conditioning


Sounds like your ballast resistor is out for the blower motor. You said that you only had 1 speed or off when you turned the fan on. The fan's speeds are made possible by a separate resistor installed on the heater box. The dash switch itself will only work at one speed when the resistor isn't functioning; and eventually the switch will burn out too. The resistor is much easier to change out than the blower motor was, and cheaper too. You can find it on the heater core/blower box by the passenger side footwell You can order the resistor for around $25.00 from a Nissan dealer, the switch itself costs about the same, verses around $90 for the blower motor.. It took me all of 20 minutes to change them out in my Nissan. I really hope you kept your receipt for the new blower motor, because it was probably fine. I'm not sure what you mean about the automated seat belt fuse. I know there is a sensor in each seat that causes the seatbelt indicator light to flash until you plug the belt in. There are 2 wiring harnesses, one for the seat that can tell when weight is on the seat, the other one shuts off the dash indicator when you plug the belt clasp in. Good luck...

Jun 11, 2008 | 1993 Nissan Sentra 4 Door

Not finding what you are looking for?
1998 Oldsmobile Aurora Logo

Related Topics:

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...