Question about 1995 Honda Passport
Everything is taken apart and i still can't get it off
You have to remove the lower ball joint connector slide the axle out from the rotor side and drop the axle then you must use a heavy pry bar and pry the axle out away from the motor, there is a snap ring that can get damaged that will keep it from coming out without a lot of force once you get past the snap ring it will come out easy. Be sure to hols the axle up with a block or something so that the weight of the axle is not just dangling on the ground the straighter the axle is the less force is needed to get it out. Pry between the engine and the round part of the shaft next two it. If you can't get it out of the wheel side you have to use a hammer to tap it to get it out of the hub bearing and disconnect the tie rod end to get it to be removed. Still have problems then post a responce to this post.
Posted on Jun 17, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Jun 20, 2013 | 1998 Mercury Mountaineer
Jun 10, 2010 | 1987 Pontiac Fiero
Feb 22, 2010 | 1992 GMC Jimmy
Sep 28, 2009 | 1997 Isuzu Rodeo
Sep 27, 2009 | 1998 Isuzu Trooper
Sep 27, 2009 | 2005 Honda Pilot
Apr 04, 2009 | 1996 Buick Century
119 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: